EDU Science 035RF 27MHz Radio Transmitter User Manual

EDU Science Co., Ltd. 27MHz Radio Transmitter Users Manual

Users Manual

1367810U.S. AND INTERNATIONAL PATENTS PENDINGContains NiMH battery,battery must be recycled or disposed of properly.Battery Care - For maximum performance, always allow your battery of the Vectron Ultralite to drain before recharging.- Never charge a second time without discharging first. This will affect or damage the battery. - Do not dispose of the battery in your regular household waste.- Contact your local waste management officials for information on environmentally sound disposal of rechargeable batteries.- If a battery leak develops, avoid contact with leaking fluid. Place the damaged battery in a plastic bag for proper disposal.- If fluid comes in to contact with skin or eyes, wash with cool water for at least 15 mins.Battery Disposal- Your Vectron Ultralite is only to be charged under adult supervision.- Never expose the Vectron Ultralite battery pack to direct sun, hot areas, or fire as it may explode.- The Ultralite charger and battery may become warm during charging. - The Ultralite charging cord must be disconnected from the Vectron Ultralite when it is fully charged.- Never leave your Vectron Ultralite connected to the AC adaptor overnight.- Never overcharge the Vectron Ultralite as it can damage the rechargeable battery.Battery Safety52I) Thrust Transmitter2) Insert 1 9V (6LR61) Alkaline battery.TriggerAntennaPower On Indicator1) Open or close the cover with a Philips screwdriver.CLOSE OPEN4ContentsAuto-stop Safety PropellerAC Adaptor Thrust Transmitter Launch PlatformRechargeable BatteryInfrared ReceiverRed LEDGreen LEDPower Switch (ON / OFF)Ring Charging SocketII) Flight Preparation1) Place your Vectron Ultralite on to the launch platform.WARNING: Never recharge your Vectron Ultralite a second time without having flown first. Continuous recharging without discharging first, will damage the Ultralite battery. CAUTION: Always recharge your Vectron Ultralite with suppliedAC Adaptor! Operate with third-party AC Adaptor may cause damage to this product.2) NOTE: After the red and green LED blink alternately, the red LED will start to flash slowly. At this time your Vectron Ultralite is ready for take off.III) Flying, Hovering and Landing Your Vectron Ultralite1) 2) Switch on your Vectron Ultralite.IMPORTANT: Ensure your Vectron Ultralite is fully charged for first time use and that you have a least 10 ft. (3 m) of clear area. Learning More About Your Vectron Ultralite Vectron Ultralite   Flying Range (max.) 12 meters Technical Specifications 1 x 9V (6LR61) Alkaline BatteryUltralite Controller  Battery Power Consumption 0.3 W (Peak)10 and UP Recommended AgeWorking Voltage (DC) 7~9 VWorking Voltage 5 VWorking Current 1.5 W (Peak)3) Extend the antenna of the thrust transmitter.4) Press the trigger slowly to allow your Vectron Ultralite to take off.TIPS: - For your first flight, ensure there are no strong air currents from fans, air conditioners or open windows.- Adjust the trigger to find the correct position so your Vectron Ultralite will hover preventing it from flying too high or too low. It will take some practice to get the hang of it. - Always point the thrust transmitter towards your Vectron Ultralite to ensure a steady controllable flight.- Do not try to land your Vectron Ultralite on to the launch platform. Try to land on any open floor area.- Your Vectron Ultralite can also take off from any smooth flat surface. Do not try to take off from deep pile carpet or soft furniture. This may jam the propeller before take off.5) Adjust and hold the trigger to allow your Vectron Ultralite to hover.6) Release the trigger to allow your Vectron Ultralite to descend or land.coverThe next generation of flying toys has arrived. The World's Smallest Wireless Flying Saucer!Excitement in the air!ONOFFNOTES: - The red and green LED will blink alternately. It will take approximately 10 minutes to charge your Vectron Ultralite completely; at this point the green LED will flash continuously. - When your Vectron Ultralite is new or has not been flown for a long time it will take several charge/discharge cycles for the battery to reach its full flight time.Rechargeable Battery Type 6 V 100mA Ni-MH Ultralite Charging DevicesI) AC Adaptor Output DC 13V 5.4W AC Adaptor Input 120V AC 60Hz 10WCharge Duration 10 minutes (max.)- V detect plus master timeout Charge MethodRYour Vectron Ultralitedoes not respond to thethrust transmitter.The thrust transmitter battery is low. The red LED does not flash after depressing the trigger.Replace the 9V (6LR61) Alkaline battery with new one.The thrust transmitter battery is inserted improperly.Check and reinsert the battery with the proper polarity as per the markings in the holder.Your Vectron Ultralite is out of range. Move closer to your Vectron Ultralite.NOTE: The transparent labels underneath the ring are for protection against the propeller. A damaged ring can be repaired with transparenttape. Some glues may damage the polyfoam ring.You are outdoors or flying in a largeroom with high ceiling.Fly indoors with the appropriate ceilingheight.9TroubleshootingYour AC Adaptor is the wrong type or damaged preventing it from charging your Vectron Ultralite.Contact your support team at service@bhsciencetech.com stating the voltage and plug type required. Do not return your Vectron Ultralite to the retail store.The propeller auto-stop feature is activated. This feature is activated when the propeller is obstructed by body parts or objects. If your Vectron Ultralite crashes on to the floor, this may trigger the auto-stop feature as well. The red and green LED will blink alternately. Reset your Vectron Ultralite by switching it off and turning it back on again to resume flight.Problem Possible Cause Solution Your Ultralite battery is not charged. Charge your battery fully before flying.The battery power is low. Recharge the battery fully.Your Vectron Ultralite is not placed properly onto the launch platform.Place your Vectron Ultralite properly sitting in the middle of the launch platform.Your Vectron Ultralite is out of range. The green LED does not come on which means there is no signal transmission.Move closer to your Vectron Ultralite.The trigger is not depressed far enough on the thrust transmitter.Depress the trigger at least half way.The room may have drafts from windows, fans, air conditioner and ventilation systems.Minimize the drafts before take off.Operator error. Wait for the red LED to flash before trying to take off.Your Vectron Ultralite does not take off.No power to the propeller.Slide the power switch to the ON position.Power switch is not turned on.Ensure your Vectron Ultralite is switched OFF, then connect the charging cord to your Vectron Ultralite.IMPORTANT:a) Ensure the AC Adaptor voltage and plug is suitable for your area.b) Connect the AC Adaptor to the wall outlet. With your Vectron Ultralite on the launch platform, unplug the charging cord.FCC ID: Q6N035RF This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.AntennaWARNING!- CAUTION: Electrically operated product. Not recommended for children under 10 years of age. As with all electric products, precautions should be observed during handling and use to prevent electric shock. - Keep face, eyes, fingers, hair, body parts etc. away from the propeller and other moving parts.- Always fly the Vectron Ultralite with 10 feet (3 meters) of open space.- Fly your Vectron Ultralite indoors only. - Do not expose your Vectron Ultralite to rain or moisture.- Do not fly in a crowded environment.- Do not fly in a dusty area.- Do not fly in complete darkness.- Ensure people know that you are flying the Vectron Ultralite.- Use only your Ultralite controller included in this package.- Always turn your Vectron Ultralite "OFF" when not in use.General- Your Vectron Ultralite must not be used if there is any damage to the AC adaptor, charging cord, charging socket, rechargeable battery, propeller, ring or other parts of the Vectron Ultralite.- Do not attempt to lift objects with your Vectron Ultralite.- Infrared frequencies (TV remote control, infrared RC car, etc.) may interfere with proper infrared signal.- Flying under direct sunlight or bright lights may interfere with the infrared signal.- Vectron Ultralite is a high tech precision instrument and is vulnerable to misuse Protecting all components is an essential part of flight maintenance. - This toy is not intended for children under 3 years old.- The instruction manual contains important information and must be kept.- This toy only operates with supplied AC adaptor.- The use of the AC adaptor should be supervised by an adult and examined regularly.- This toy must not be used if there is any damage to the power cord, plug and other parts of the transformer.- The AC adaptor must be disconnected before cleaning.AC Adaptor Important InformationBattery Removal- Remove the 3 screws on the top of the Vectron Ultralite with a Philips screwdriver, disassemble the unit and remove the rechargeable battery.Your Vectron Ultralite is wireless with infrared control. The patented aero gyro technology keeps the saucer straight and level. You control the altitude with your thrust transmitter. Just charge the battery and it is ready to fly, hover and dive!INSTRUCTION MANUAL(1)CLOSE OPEN(2) (3) (4)PLEASE DO NOT RETURN THIS PRODUCT TO A RETAIL STORE. FOR QUESTIONS OR PROBLEMS WITH THIS PRODUCT, PLEASE CALL OUR CUSTOMER SERVICE AT 1-800-637-3455 OR EMAIL: service@bhsciencetech.comP38 - EL035RF - 81001000Battery Safety Guidelines- To prevent battery leakage: Be sure to insert batteries correctly.- Batteries should be replaced by adult.- Never dispose of batteries in fire as this may cause them to explode.- Do not mix old and new batteries (replace all batteries at the same time).- Do not mix Alkaline, standard (Carbon-Zinc) or rechargeable (Nickel-Cadmium) batteries (or equivalent). Only batteries of the same or equivalent type as recommended are to be used.- Non-rechargeable batteries are not to be recharged.- Always remove exhausted or dead batteries from product. Remove batteries from product which is not going to be used for a long time. Otherwise the batteries may leak and cause damage.- The supply terminals are not to be short-circuited.- Make sure battery compartment is secure.- Do not immerse battery operated toys. Wipe clean only.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV NTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER AUTHORITY TO OPERATE THE EQUIPMENT.

Navigation menu