EZ Automation EAS CAP/EAS Encoder-Decoder User Manual

EZ Automation CAP/EAS Encoder-Decoder EZ EAS Manual

a href="https://usermanual.wiki/EZ-Automation" itemprop="url"> EZ Automation >

Draft Copy of User Manual

FCC Part 15 Notice: Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. Special Instructions: Shielded interconnect cables and a shielded AC power cable must be employed with this equipment to ensure compliance with the pertinent RF emission limits governing this device. Changes or modifications not expressly approved by the system’s manufacturer could void the user’s authority to operate the equipment. Assembled From Tested Components by: EZ Automation 3302 N. Van Dyke Rd. Imlay City, MI 48444 (810) 895-2040 www.voicetracking.com Product Name EZ Automation Product Model EAS
EZ Automation EAS/CAP Encoder Decoder www.voicetracking.com (810) 895-2040 © 2005-2012 GETTING STARTED PROGRAMMING: OVERVIEW: This section will take you step by step through the programming setup process to get your EAS system programmed and running. This initial setup should be performed by or at least with the assistance of your Engineering department. It is important that the initial programming is done properly. PART 1: SYSTEM SETUP. STEP 1: GETTING TO THE STATION SETUP SCREEN. The first step is configuring the EAS unit. To enter the setup, go to the menu bar click on Config, then on Station Setup. This will take you to the station setup screen. .
Download:
Mirror Download [FCC.gov]
Document ID1811579
Application IDcL2F85s2jMpiQLs2ljlNOA==
Document DescriptionDraft Copy of User Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize65.86kB (823270 bits)
Date Submitted2012-10-10 00:00:00
Date Available2013-07-09 00:00:00
Creation Date2012-10-10 10:59:29
Producing SoftwareGPL Ghostscript 8.15
Document Lastmod2012-10-10 10:59:29
Document TitleMicrosoft Word - EZ EAS Manual.doc
Document CreatorPScript5.dll Version 5.2
Document Author: Administrator
FCC ID Filing: OTQEAS

Navigation menu