Eastern Times Technology 8103-K010 Wireless Keyboard User Manual Manual

Eastern Times Technology Co., Ltd. Wireless Keyboard Manual

Manual

ET-8103 Wireless keyboard user manualProduct featuresAdopt 2.4 G wireless solutionsMeet the appearance of the principle of human body engineering design ideaChocolate key cap design, flexible operation, easy clean.High quality injection silica gel, feel comfortableProduct installation1. Take out the Wireless keyboard and receiver from the box2. Put the Nano receiver into the USB port3. Put 2PCS AAA alkaline battery inside the keyboard according in the correct polarity4. LED blink a few seconds, now you can use the productProduct function1. The battery is low voltage remind functionThe battery is low voltage remind function as the keyboard use time lengthen, battery voltage will slowlylower, below the set remind voltage, in the process of use, LED light flashing red instructions appeared toremind you to replace new batteries.2.CAPS LOCK、NUM LOCK instruction functionThis product increases the CAPS LOCK and NUM LOCK instruction function, users to identify caseand the digital working condition. When LED light after the use of the keyboard, LED will be put out. Theuse of the keyboard again when press any key LED to light.ReconnectThe wireless set respectively transmit and receive a group of built-in identification number, easy to useof products when using one-on-one. High temperature, high magnetic field, vibration, etc may make thisgroup of code disappear, they need to connect only can be used, the method is as follows：1. Pulling out and then to plug in the receiver;2. Hold the "ESC" and "K" keys on the keyboard for a few seconds, and then to loosen, the low voltageLED shining to code namely after success. You also can use wireless keyboard.Note1、Use only AAA alkaline battery, a long time not to use products please take out the battery, in order toavoid corrosion parts。2、This product use 2.4 GHZ radio waves to transmit data, the sight range of 10 meters, if have largerobstacles, environmental interference, use distance will be reduced.WarningWithout the approval of the authorities responsible for any change or correction of clear users shall havethe right to prohibit the equipment.
RemarkThis equipment by test found that comply with digital equipment level restriction of B, accord with FCCarticle 15 regulations. This limit the requirements in the shelter place provides the reasonableanti-interference protection. This equipment use they emit radio waves, if not in accordance withinstructions installation, may arise for wireless communication harmful interference. However, noguarantee interference will not occur in a particular device. If the equipment on the radio or TV receivingindeed cause influence, and may, through the turn this equipment and then open to adjust. Suggest usersthrough the following method to remove interference or more of one of:*Mobile receiving antenna；* Increasing the distance of the equipment and the receiver;*Will this device to connect with the receiver to different electricity on the road;*Consulting the dealer or looking for experienced radio/TV tech help.FCC StatementChanges or modifications not expressly approved by the party responsible for compliance could void theuser's authority to operate the equipment.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant toPart 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates uses and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, may cause harmful interference toradio communications. However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio or television reception, which can bedetermined by turning the equipment off and on, the user is encouraged to try to correct the interference byone or more of the following measures:-- Reorient or relocate the receiving antenna.-- Increase the separation between the equipment and receiver.-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.-- Consult the dealer or an experienced radio/TV technician for helpThis device complies with part 15 of the FCC rules. Operation is subject to the following two conditions(1)this device may not cause harmful interference, and (2) this device must accept any interferencereceived, including interference that may cause undesired operation

Navigation menu