Eastern Times Technology 8103-K010 Wireless Keyboard User Manual Manual
Eastern Times Technology Co., Ltd. Wireless Keyboard Manual
Manual
ET-8103 Wireless keyboard user manual
Product features
Adopt 2.4 G wireless solutions
Meet the appearance of the principle of human body engineering design idea
Chocolate key cap design, flexible operation, easy clean.
High quality injection silica gel, feel comfortable
Product installation
1. Take out the Wireless keyboard and receiver from the box
2. Put the Nano receiver into the USB port
3. Put 2PCS AAA alkaline battery inside the keyboard according in the correct polarity
4. LED blink a few seconds, now you can use the product
Product function
1. The battery is low voltage remind function
The battery is low voltage remind function as the keyboard use time lengthen, battery voltage will slowly
lower, below the set remind voltage, in the process of use, LED light flashing red instructions appeared to
remind you to replace new batteries.
2.CAPS LOCK、NUM LOCK instruction function
This product increases the CAPS LOCK and NUM LOCK instruction function, users to identify case
and the digital working condition. When LED light after the use of the keyboard, LED will be put out. The
use of the keyboard again when press any key LED to light.
Reconnect
The wireless set respectively transmit and receive a group of built-in identification number, easy to use
of products when using one-on-one. High temperature, high magnetic field, vibration, etc may make this
group of code disappear, they need to connect only can be used, the method is as follows：
1. Pulling out and then to plug in the receiver;
2. Hold the "ESC" and "K" keys on the keyboard for a few seconds, and then to loosen, the low voltage
LED shining to code namely after success. You also can use wireless keyboard.
Note
1、Use only AAA alkaline battery, a long time not to use products please take out the battery, in order to
avoid corrosion parts。
2、This product use 2.4 GHZ radio waves to transmit data, the sight range of 10 meters, if have larger
obstacles, environmental interference, use distance will be reduced.
Warning
Without the approval of the authorities responsible for any change or correction of clear users shall have
the right to prohibit the equipment.
Remark
This equipment by test found that comply with digital equipment level restriction of B, accord with FCC
article 15 regulations. This limit the requirements in the shelter place provides the reasonable
anti-interference protection. This equipment use they emit radio waves, if not in accordance with
instructions installation, may arise for wireless communication harmful interference. However, no
guarantee interference will not occur in a particular device. If the equipment on the radio or TV receiving
indeed cause influence, and may, through the turn this equipment and then open to adjust. Suggest users
through the following method to remove interference or more of one of:
*Mobile receiving antenna；
* Increasing the distance of the equipment and the receiver;
*Will this device to connect with the receiver to different electricity on the road;
*Consulting the dealer or looking for experienced radio/TV tech help.
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions
(1)this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation