Electronic Solutions ABMHZ01 Zwave Based Motor Controller User Manual ABMHZsetup 1 indd

Electronic Solutions, Inc. Zwave Based Motor Controller ABMHZsetup 1 indd

User Manual

Compatible with other Z-wave™ enabled devices.• Mechanical motor limits must be set before performing the sequences below.• If the Motor LED is red, the unit has not been calibrated and will not respond correctly.• Verify OPEN button opens shade and CLOSE botton closes shade. If directions are • swapped, see “Toggle Direction” below. Calibration ProcedureSimultaneously press and hold both 1. OPEN and CLOSE for at least 10 seconds until Motor LED turns solid green.Release both OPEN and CLOSE.2. Within 10 seconds press and release 3. CLOSE to start the calibration sequence. (Press and release OPEN instead to “Toggle Direction” and start the calibration sequence.)The calibration sequence will run the motor from one limit to the other and end with the shade closed, motor off, and Motor LED off.Unit is ready for use.• Optional Z-Wave Include/ExcludeFor “Include”, place the primary controller into the INCLUDE mode and do a quick press of the LEARN button (Z-Wave LED will fl ash green). For “Exclusion”, place the primary controller into the EXCLUDE mode and do a quick press of the LEARN button (Z-Wave LED will fl ash green).Electronic Solutions, Inc.1355 Horizon AvenueLafayette, CO 80026VOX +1 303.469.9322FAX +1 303.469.5129Ratings230VAC Unit: 230VAC 5A 1/2HP115VAC Unit: 115VAC 8A 1/3HPMechanicalL: 5.25” W: 3.14” H: 2.0”L: 133.4mm W:79.8mm H: 50.8mmABMHZ v1+1— Quick SetupVersion 1 11 June 2007www.elec-solutions.comElectronicSolutions, Inc.© 2007, Electronic Solutions, Inc.
FEDERAL COMMUNICATIONS COMMISSION STATEMENTThis device complies with part 15 of the FCC rules. Operation of this device is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference, including interference that may cause undesired operation.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pur-suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio com-munications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the follow-ing measures:Reorient or relocate the receiving antenna or device.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.• WARNING!Changes or modifi cations not expressly approved by Electronic Solutions, Inc. could void the user’s authority to operate the equipment.

Navigation menu