Enterasys Networks Matrix 7H4385 49 Users Manual DFE Platinum Series Hardware Installation Guide

2015-02-04

• DFE-Platinum Series Hardware Installation Guide
• Notice
  • Regulatory Compliance Information
  • Enterasys Networks, Inc. Firmware License Agreement
• Contents
  • Figures
  • Tables
• About This Guide
  • Who Should Use This Guide
  • How to Use This Guide
  • Related Documents
  • Conventions Used in This Guide
  • Getting Help
• Introduction
  • Overview of DFE-Platinum Series Module Capabilities
  • DFE-Platinum 7H4385-49 PoE Module
  • Connectivity
  • Management
    • Switch Configuration Using WebView
    • Switch Configuration Using CLI Commands
  • Standards Compatibility
  • Secure Networks Policy Support
  • LANVIEW Diagnostic LEDs
• Network Requirements
  • Link Aggregation
  • Module Placement in a Matrix E7 Chassis
  • FTM Bridge Function and Optional Interface Module
  • 10BASE-T Network
  • 100BASE-TX Network
• Installation
  • Installation Site Requirement
  • Unpacking the DFE Module
  • Installing Optional Network Expansion Module (NEM)
  • Backplane Connections and Installation Rules
    • FTM1 and FTM2 Connectivity
    • Module Placement and Installation Rules
  • Preparing to Install into a Matrix E7, N1, N3, N5, or N7 Chassis
    • Installing the 7H4385-49 into a Matrix E7 or Matrix N7 Chassis
    • Installing the 7H4385-49 into Matrix N1, N3, or N5 Chassis
  • Connecting 48 Vdc Power for PoE Operation
  • Connecting to the Network
    • Connecting UTP Cables to 7H4385-49
  • Connecting to COM Port for Local Management
    • What Is Needed
    • Connecting to an IBM PC or Compatible Device
    • Connecting to a VT Series Terminal
    • Connecting to a Modem
    • Adapter Wiring and Signal Assignments
  • Completing the Installation
    • Completing the Installation of a New System
    • Completing the Installation of a DFE Module in an Existing System
• Troubleshooting
  • Using LANVIEW
    • About the Management (MGMT) LED
    • Viewing the Receive and Transmit Activity
    • Viewing the PoE Port Status
  • Troubleshooting Checklist
  • Overview of DFE Module Shutdown Procedure
    • Recommended Shutdown Procedure Using OFFLINE/RESET Switch
    • Last Resort Shutdown Procedure Using OFFLINE/RESET Switch
• Specifications
  • DFE Module Specifications
  • COM Port Pinout Assignments
  • Regulatory Compliance
• Mode Switch Settings and Option Installations
  • Required Tools
  • Setting the Mode Switches
  • Memory Locations and Replacement Procedures
  • Gaining Access to Memory Modules
    • Removing the Safety Cover
    • DRAM SIMM Replacement Procedure
    • DIMM Replacement Procedure
    • Installing the Network Expansion Module (NEM)
    • Reinstalling the Safety Cover
• About PoE (Power over Ethernet)
  • Overview
    • Proprietary PD Detection
    • Power Interface
    • Matrix N5 Backplane 48 Vdc Interface
    • Front Panel 48 Vdc Interface
    • PoE Port Status LEDs
• Index
  • Numerics
  • C
  • D
  • E
  • F
  • G
  • I
  • L
  • M
  • N
  • O
  • P
  • R
  • S
  • T
  • U
  • V
  • W