Epson Labelworks Iron On Kit Users Guide User's
Epson-Epson-Labelworks-Iron-On-Kit-Owner-S-Manual epson-epson-labelworks-iron-on-kit-owner-s-manual
2015-03-28
: Epson Epson-Labelworks-Iron-On-Kit-Users-Guide-665749 epson-labelworks-iron-on-kit-users-guide-665749 epson pdf
Open the PDF directly: View PDF
Page Count: 40
- Contents
- Welcome
- Getting Started
- Inserting batteries
- Using the optional AC adapter
- Inserting a tape cartridge
- 1. Remove any slack from the ink ribbon.
- 2. Remove the rear cover.
- 3. Insert the tape cartridge and press it down firmly until it snaps into place.
- 4. If there is excess tape, feed the end of the tape through the tape guide slot.
- 5. Replace the cover and snap it into place.
- 6. Press to turn on the printer.
- 7. Press + .
- 8. Press the Cut button to cut the tape.
- 1. Remove any slack from the ink ribbon.
- Removing a tape cartridge
- Changing the language
- Creating labels
- Saving labels
- Printing labels
- 1. Press to print the current label. The length of the label and the number of copies shows on the display while the label prints.
- Printing multiple copies
- 1. Press . You see 2-9 on the display.
- 2. Press the one of the number keys to enter the number of copies (2-9).
- 3. Press . The length of the label and the number of copies shows on the display while the labels print.
- 4. When printing stops, press the Cut button to cut the tape. A cut mark is printed between each copy, as shown:
- 5. Using scissors, cut along the marks to separate each label.
- 1. Press . You see 2-9 on the display.
- Customizing your labels
- Adjusting the Display
- Applying Iron-On labels
- Attaching your labels
- 1. Set your iron to 284-320 ˚F (140-160 ˚C), without steam.
- 2. Make sure the area where you want to attach the label doesn’t have any wrinkles.
- 3. Place the label in the desired location with the printed side up.
- 4. Gently press the iron down on one end of the label to temporarily attach it in place.
- 5. Press the iron firmly down on the entire label, holding the iron still for about 10 to 15 seconds. To make sure the label adheres securely, repeat this step 3 or 4 times.
- 1. Set your iron to 284-320 ˚F (140-160 ˚C), without steam.
- Label usage tips
- Attaching your labels
- Cleaning the Printer
- Solving Problems
- Error messages
- Problems and solutions
- The product does not function normally
- Power is on but no images appear on the display
- The display turns off
- Nothing prints
- Characters do not print properly
- Printing stops in the middle of text
- Saved labels are gone
- Labels curl after ironing
- Labels fall off after a few washings
- Epson Technical Support
- Specifications
- Notices