Ericsson LG PCI1020 802.11n Wireless PCI Adapter User Manual

Ericsson-LG Co., Ltd. 802.11n Wireless PCI Adapter

User Manual

LG-Ericsson
PCI-1020
WIRELESS 802.11N PCI ADAPTER
QUICK
INSTALLATION
GUIDE
3
PACKAGE CONTENTS
INSTALLATION CD
INCLUDES SETUP WIZARD & TECHNICAL MANUALS
LG-ERICSSON PCI-1020 WIRELESS 802.11N PCI ADAPTER
LOW PROFILE BRACKET
If any of these items are missing from your packaging, please contact your reseller.
QUICK INSTALLATION
1. Remove the side panel from your PC
2. Insert the LG-Ericsson PCI-1020 Adapter into one of the
PCI slots.
3. Re-attach the side panel once the drives have been
installed.
4. The CD contains all the instructions required to set up the LG-Ericsson
PCI-1020.
5. Insert the CD ROM into your computer's drive. The setup wizard should start
automatically.
6. Click the gray Start button on the welcome screen to begin the Setup Wizard.
Follow the instructions on the screen.
Antenna Specifications:
The LG-Ericsson PCI-1020 Wireless PCI Adapter can be used with the standard 2dBi
antenna that is included in the original product package or Laird Technologies TRA24003
3dBi antenna with N-type connector. When used with the Laird Technologies TRA24003
3dBi antenna, use a minimum 20-feet long LMR-240 RF cable.
TROUBLESHOOTING
SETUP AND CONFIGURATION PROBLEMS
This section provides solutions to common issues that may occur during the installation and
operation of the Wireless PCI-1020 Adapter. If you are unable to find an answer here, check
the LG-Ericsson USA website at http://www.lgericssonus.com
1. THE WIRELESS PCI-1020 DOES NOT WORK PROPERLY?
• Reinsert the wireless PCI-1020 into your PC’s PCI slot.
• Right-click on My Computer and select Properties. Select the Device Manager
and click on Network Adapter. You will find the LG-Ericsson PCI-1020 if it is
installed successfully. If you see the yellow exclamation mark, the resources are
conflicting. You will see the status of the PCI Adapter. If there is a yellow
question mark, please check the following:
• Make sure that your PC has a free IRQ (Interrupt Request, a hardware interrupt
on a PC)
• Make sure that you have inserted the right adapter and installed the proper
driver.
• If the Wireless PCI-1020 adapter does not function after attempting the above
steps, remove the adapter and do the following:
• Uninstall the driver software from your PC.
• Restart your PC and repeat the hardware and software installation as specified in
the User Guide.
2. I CANNOT COMMUNICATE WITH THE OTHER COMPUTERS
LINKED VIA ETHERNET IN THE INFRASTRUCTURE CONFIGURATION?
• Make sure that the PC and the wireless router/access point to which the adapter
is associated is powered on.
• Make sure the LG-Ericsson PCI-1020 adapter is configured on the same channel
and with the same security options as with the other computers in the
infrastructure configuration.
Canadian Compliance Statement
This device complies with RSS 210 of Industry Canada. This Class B device
meets all the requirements of the Canadian interference-causing equipment
regulations.
Cet appareil numérique de la Classe B respecte toutes les exigences du
Règlement sur le matériel brouilleur du Canada.
This device complies with Industry Canada license exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Cet appareil est conforme aux normes CNR exemptes de licence d’Industrie
Canada. Le fonctionnement est soumis aux deux conditions suivantes : (1) cet
appareil ne doit pas provoquer d’interférences et (2) cet appareil doit accepter
toute interférence, y compris celles susceptibles de provoquer un fonctionnement
non souhaité de l’appareil.
Under Industry Canada regulations, this radio transmitter may only operate using
a 2dBi dipole antenna approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is
not more than that necessary for successful communication.
This radio transmitter (PCI-1020) has been approved by Industry Canada to
operate with the antenna types listed below with the maximum permissible gain
and required antenna impedance for each antenna type indicated. Antenna types
not included in this list, having a gain greater than the maximum gain indicated
for that type, are strictly prohibited for use with this device:
- External dipole antenna with maximum gain 2dBi and impedance
50ohm
- External dipole antenna with maximum gain 3dBi and impedance
50ohm
Radiation Exposure Statement:
This equipment complies with CANADA radiation exposure limits set forth for an
uncontrolled environment. Thisequipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
WARRANTY INFORMATION AND TECHNICAL SUPPORT
The following warranty only applies in the USA
To register LG-Ericsson products and to review a detailed warranty statement,
please refer to the LG-Ericsson US website at:
http://www.lgericssonus.com
For technical support assistance, call 1(877)828-2673
Copyright
Information furnished by LG-Ericsson USA, Inc. (LG-Ericsson USA) is
believed to be accurate and reliable. However, no responsibility is assumed
by LG-Ericsson USA for its use, nor for any infringements of patents or other
rights of third parties, which may result from its use. No license is granted by
implication or otherwise under any patent or patent rights of LG-Ericsson USA.
LG-Ericsson USA reserves the right to change specifications at any time
without notice.
© Copyright 2011. LG-Ericsson USA, Inc. All rights reserved. LG-Ericsson
USA, Inc. is a registered trademark. Other products and company names are
trademarks and registered trademarks of their respective holders.

Navigation menu