Estone Technology TP36Q10 IRV 10.1 Touch Screen Control Panel User Manual manual

Estone Technology Inc. IRV 10.1 Touch Screen Control Panel manual

Users Manual

1. SHOWS THE BATTERY / FRESH WATER / BLACK W   ATER 1 / BLACK WATER 2 / GREYWATER 1 / GREY WATER 2 / GALLEY TANK STATUS2. PANEL POWER (ON/OFF)3. ENTRY LIGHT (ON/OFF)4. PORCH LIGHTS (ON/OFF)5. ELECTRIC WATER HEATER (ON/OFF)6. ODS FLOOD (ON/OFF)7. LP GAS WATER HEATER (ON/OFF)8. WATER PUMP (ON/OFF)9. TANK HEATER (ON/OFF)10. STEP LIGHT (ON/OFF)11. AISLE LIGHT (ON/OFF)12. CONTROL SLIDE ROOM IN13. CONTROL SLIDE ROOM 2 IN14. CONTROL SLIDE ROOM 3 IN15. CONTROL AWNING RETRACT16. CONTROL AWNING 2 RETRACT17. CONTROL SLIDE ROOM OUT18. CONTROL SLIDE ROOM 2 OUT19. CONTROL SLIDE ROOM 3 OUT20. CONTROL AWNING EXTEND21. CONTROL AWNING EXTEND22. POWER ON/OFF23. CONNECT TO THE CONTROLLER - RELAY BOX24. MIN USBSLID EROOM 2 OU TSLID EROOM 3 OU TAWNIN GEXTE NDAWNIN G 2EXTE NDSLID EROOM 2 INSLID EROOM 3 INAWNIN GRETR AC TAWNIN G 2RETR AC TLP GASWATERHEATERWATER PUMP TANKHEATER  STEPLIGH T  AIS LELIGH TGalle ytankGreywater 2Greywater 1Blackwater 1Blackwater 2Freshwater 1Batte rySLID EROOM I NSLID EROOM O UTDSI FAULTENTRYLIGH TPORCHLIGH TS ELECTRIC WATER HEATERODSFLOO D12 3 4 5 67 8 9 10 1112 13 14 15 1617 18 19 20 2122MINI USBRJ45 2423USER  MANUAL Power On/OffPress and hold (PANEL POWER) button to power on. Press and hold (PANEL POWER) button to power off.Restart PANELPress and hold POWER button to restart panel system .Press the button  (3-11) breifly  to operate ON/OFF as below:3. ENTRY LIGHT (ON/OFF)4. PORCH LIGHTS (ON/OFF)5. ELECTRIC WATER HEATER (ON/OFF)6. ODS FLOOD (ON/OFF)7. LP GAS WATER HEATER (ON/OFF)8. WATER PUMP (ON/OFF)9. TANK HEATER (ON/OFF)10. STEP LIGHT (ON/OFF)11.  AISLE LIGHT (ON/OFF)Press and hold the button  (3-11) to control as below:12. CONTROL SLIDE ROOM IN13. CONTROL SLIDE ROOM 2 IN14. CONTROL SLIDE ROOM 3 IN15. CONTROL AWNING RETRACT16. CONTROL AWNING 2 RETRACT17. CONTROL SLIDE ROOM OUT18. CONTROL SLIDE ROOM 2 OUT19. CONTROL SLIDE ROOM 3 OUT20. CONTROL AWNING EXTEND21. CONTROL AWNING 2 EXTENDSymbol level shows the Battery / Fresh water / Black water 1 / Black water 2 / Grey water 1 / Grey water 2 / Gallery Tank status: GalleytankGreywater 2Greywater 1Blackwater 1Blackwater 2Freshwater 1BatteryWarning:   Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.Note: This equipment has been tested and found to comply with the limits for a class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Consult the dealer or an experienced radio/TV technician for help.Warning:The TP36Q10 has been tested for body-worn Specific Absorption Rate (SAR) compliance. The radio module has been evaluated and found to be compliant to the requirements as set forth in CFR 47 Sections, 2.1093, and 15.247 (b) (4) addressing RF Exposure from radio frequency devices. This model meets the applicable government requirements for exposure to radio frequency waves. The highest SAR level measured for this device was 0.946 W/kg.

Navigation menu