Etekcity SE9 Bluetooth Headset User Manual 15 SE9 UserMan
Etekcity Corporation Bluetooth Headset 15 SE9 UserMan
Etekcity >
15_SE9 UserMan.pdf
Instruction Manual
Model:SE9
FCC ID:2AB22SE9
Thank you for purchase this product, please read carefully before using.
Charging:
DC 5V 500mA for charging, Red indicator light on, charging start, Blue indicator light on,
charging finished.
ON/OFF:
Power on: Keep pressing the “ ” button for more than 3 seconds, blue light on and
“POWER ON” voice prompt.
Power off: Keep pressing the “ ” button for more than 3 seconds, red light on and
“POWER OFF” voice prompt.
Bluetooth Mode:
Pair: In the state of POWER OFF, keep pressing the “ ” button to the red and blue light
flashing alternately, Pairing mode start. Search for Bluetooth device until find out “E26”,
select it, then the indicator keeps flashing slowly, pair successfully.
(Noted: if the pass code is required, please enter “0000”)
If you want to disconnect the Bluetooth connection and back to code match state, please short
press the “ ” and “ ” keys at the same time when no music playing.
Noted: 1. When the Bluetooth connection disconnect accidentally, short press the “ ”
button, the Bluetooth will reconnect.
2. If you want to reset the connected Bluetooth devices list, please long press the
“ ” and “ ” keys at the same time.
Music Playing:
Short press “ ” button，Play/Pause;
Short press “ ” button, Volume decrease; long press “ ” button, Previous song;
Short press “ ” button, Volume increase; long press “ ” button, Next song.
Voice Dial:
When in paired status, long press “ ” or “ ” button, then say the name out you
want to call.
Noted: Please make sure voice dial function is supported on your smartphone.
Call Mode :
In Bluetooth connected status, double click the “ ” button to dial the last call again.
While calling incoming, short press the“ ”button to pick up the call; long press
the“ ”button to reject the call.
On talking status, short press the “ ” button to hang up; long press the “ ” or
“ ” keys at the same time to mute the microphone, and long press the “ ” or
“ ” keys at the same time again to resume talking; double click the “ ” button to
switch the telephone back and forth between the earphone and mobile phone.
Low Power Warning:
In working status, when the power is low, there will be a voice prompt “Battery low” and the
red indicator light will flash discontinuously
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
Thisdevicecomplieswithpart15oftheFCCrules.Operationissubjecttothefollowingtwo
conditions:
(1)thisdevicemaynotcauseharmfulinterference,and
(2)thisdevicemustacceptanyinterferencereceived,includinginterferencethatmaycause
undesiredoperation.
Changesormodificationstothisunitnotexpresslyapprovedbythepartyresponsiblefor
compliancecouldvoidtheuser'sauthoritytooperatetheequipment.