Ewig Macao Commercial Offshore 001H22M Wireless Remote Sensor User Manual 683F33
Ewig Industries Macao Commercial Offshore Limited Wireless Remote Sensor 683F33
User Manual
RF 433Mhz Wireless Remote Sensor 001H22 (HANG) (STAND) °C °F TX : +32°F to +122°F (0°C to +50°C) : -58°F to +158°F (-50°C to +70°C) : Maximum 30 meters, open area : AAA size x 2 pcs. (remote sensor) : 6 months : 433.92 MHz This device could be sensitive to electrostatic discharge, If electrostatic discharge or malfunctioning occurs, please reset this unit. RF REMOTE SENSOR Specification Recommended remote sensor operating range: Sensor with LCD display Detachable outdoor probe Transmission range Batteries Battery life Transmission frequency SLIDE “Modifications not authorized by the manufacturer may void users authority to operate this device” SLIDE A . LCD Displays temperature and humidity in toggle B. LED indicator Flashes when the remote unit transmits a reading C. °C/°F slide switch Selection Centigrade (°C) or Fahrenheit (°F) D. T X Press once to re-transmit manually. Press and hold to clear the TX ID and start re-registration E. Battery compartment Accommodates two AAA-size batteries F. Battery door G. Removable table stand with wall-mount hole To enable the remote unit on a flat surface and support it in wall-mounting. During the 3 minutes when the home receiver is seeking for sensor registration signal, remove the bracket stand, and battery cover. Insert 2 pieces of AAA batteries into the battery compartment according to polarity markings. The channel 1 icon and the temperature/humidity will appear on the LCD of the receiving unit. -If the registration is sucessful, a beep confirmation will be heard. If not, check the AAA batteries, repeat the registration procedure again, or hold the TX button for 2 seconds to send the registration signal. Then, close the battery door. -To register sensor 2 and sensor 3: Press and hold the “Channel” button for 2 seconds on the home receiver to select the channel. Insert batteries for sensor 2, the channel 2 icon and temperature will appear on the LCD of the receiving unit. Follow the same procedure to register sensor 3. Note: • The sensor will transmit the registration code automatically once the batteries are inserted. If the batteries have been already inserted into the battery compartment , hold the TX 2 seconds for registration. • If the “---” icon appears on the outdoor remote sensor, move the unit closer to the receiving unit. Repeat the registration procedure again. • The channels will be automatically assigned to the sensors respectively in sequence of registration. However, if all sensors are already registered, you can perform the registration again by selecting the desired channel and hold “Channel” for 2 seconds to enable the receiving unit to receive RF temperature signals. For wireless remote sensor with detachable probe only If measurement of water, soil, or other liquid is desired, open the cover of the plug hole at the side of the sensor and insert the probe plug. (optional) Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.1 Linearized : No Page Count : 1 Create Date : 1910:31:10 31:35:65 Producer : Acrobat Distiller 3.0 for Windows Title : 683F33 Subject : 683F33 Author : eunice Creator : Adobe PageMaker 6.5EXIF Metadata provided by EXIF.tools