FUJIFILM Business Innovation RFHIFX Limited Modular Transmitter User Manual Jigen IOT

Fuji Xerox Corporation Limited Limited Modular Transmitter Jigen IOT

Contents

Users manual

91.4 Installation Procedure11.4.3 Installing the EP CartridgeWhen installing the EP cartridge, take note of the following points:• Do not subject it to direct sunlight or strong light. • When installing the EP cartridge, select a location not subject to strong light and try to finish the installation within 5 minutes. • Do not touch the surface of the photosensitive drum. Do not stand or place the EP cartridge upside down. The drum might get damaged. • A drum shutter protects the photosensitive drum from light. Do not open the drum shutter. • Although the toner is not harmful to the body, wash it off immediately if your hands or clothes are stained with it. • It is recommended to use up the EP cartridge within 1 year after opening it. “5.2.2 Replacing the EP Cartridge” for details when replacing the EP cartridge.Open the top cover. Do not touch any parts inside the printer. Take the EP cartridge out of the box and shake it 7 to 8 times as shown in the diagram. Never throw an EP cartridge into an open flame. It can cause an explosion and you can get burnt.Jigen_IOT.book Page 9 Thursday, February 20, 2003 9:24 AM
1011.4 Installation ProcedurePlace the EP cartridge on a flat surface and pull the seal out horizontally. •When pulling out the seal, pull it out horizontally. The tape might break if it is pulled out diagonally. •After the seal has been pulled out, do not shake or bump the EP cartridge. Hold the EP cartridge by the grip and insert it into the slot inside the printer. •Do not touch any parts inside the printer. •Ensure that the EP cartridge is firmly set. Close the top cover securely. Jigen_IOT.book Page 10 Thursday, February 20, 2003 9:24 AM
1411.4 Installation Procedure1.4.4 Installing the Toner CartridgesFollow the procedure below to install the toner cartridges The toner is harmless but should still be washed off immediately ifit comes into contact with hands or clothing.Remove the top cover.Select the new toner cartridge whose colormatches the cartridge holder and remove itfrom its packaging.
1511.4 Installation ProcedureShake the toner cartridge 7 or 8 times asshown in the illustration to distribute thetoner evenly.Align the toner cartridge with the corre-sponding insertion point in the printer andinsert it as shown in the illustration.Grip the levers at each end of the toner car-tridge with your fingers, then push downfirmly to rotate the levers forward.
1611.4 Installation ProcedurePull the toner seal straight up to remove it.Pull the toner seal straight up.Pulling the toner seal diago-nally may tear the seal.Repeat steps - to install the remainingtoner cartridges.Replace the top cover.

Navigation menu