Fibar Group HC2 Home Center User Manual kartka pl

Fibar Group S.A. Home Center kartka pl

User Manual_20131223_v1 - HC-Manual-USA

To start using Fibaro System Home Center 2, please connect the device to power and LAN sockets, as shown below.1. Unscrew left side panel 3. Connect wires as shown on gure below2. Take side panel oHC2 back HC2 front WARNING! Do not turn Home Center 2on without RECOVERY pendrive.
POWER- click to turn HC2 ON- click (when HC2 ON) to reset the device- press and hold for approx 10 seconds to turn HC2 OFFLED Indicators Back panel buttonsPOWER - power ON LAN - HC2 connected to EthernetINTERNET - HC2 connected to InternetZ-WAVE - communication within Z-Wave networkLEARN MODE [blinking slowly] - new device beeing added to the Z-Wave networkLEARN MODE [blinking] - device beeing deleted from the Z-Wave networkLEARN MODE [blinking quickly] - device has been added/removed.RECOVERY - Recovery Mode active UPDATE - New software version available for downlowadSERVICE - Software update in progress.RECOVERY- to enter Recovery Mode disconnect the power supply. Press and hold Recovery button when reconnecting the power supply (release the button after entering Recovery Mode)*.- click once - entering Learn Mode (add new Z-Wave device),- click twice - entering Learn Mode (delete Z-Wave device),- press and hold to set static IP: 192.168.81.1** NOTE: after setting static IP Home Center 2 will loose the router connection.For more information go to www.baro.comStart HC2 with a POWER button and wait approx. 2 minutes for the device to start. Correct connection will be signalled by diodes 1, 2, 3 (see the glossary below).Connect power cable to the mains, and network cable to LAN socket in your router (Home Center 2 requires an outside router).5. Start Home Center 24. Connect HC2Start the HC2 Finder and click "Refresh". After the list of Home Center 2, available within your local network appears, choose the one you wish to connect and click "connect".After successful connection you will access HC2 control panel. Choose your language version, enter user name and password. Defaults are: admin / admin.Go to www.baro.com, nd Support section, download and install HC2 Finder desig-nated for your operating system.6. Login to Home Center 2POWER
FCC ID: 2AA9MHC2THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHOR-IZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2.This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reason-able protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help.

Navigation menu