Fisher And Paykel Nz Au Bi602Cte Users Manual 541768C_BIcombo_INST
BI602ED to the manual 802323d6-914d-1464-bd6e-219d578df4d9
2015-02-02
: Fisher-And-Paykel Fisher-And-Paykel-Nz-Au-Bi602Cte-Users-Manual-406213 fisher-and-paykel-nz-au-bi602cte-users-manual-406213 fisher-and-paykel pdf
Open the PDF directly: View PDF 
.
Page Count: 8
| Download | |
| Open PDF In Browser | View PDF |
Installation Instructions NZ, AU Installation Information BI452 series Built-In Compact Oven BI602 series Built-In Oven BI602CTE series Built-In Oven/Cooktop combination BI602ED series Built-In Double Oven BI602XC series Built-In Oven/ Microwave combination 541768C 10.2004 NZ Warnings and Safety information WARNING! Cut Hazard Take care - panel edges are sharp. Failure to use caution could result in minor injury or cuts. CAUTION! In order to avoid hazard these products must be installed according to these instructions. Please follow installation information carefully. If in doubt consult your local building authority by-laws. Failure to install the product correctly could invalidate any warranty or liability claims. The product is to be installed only by an authorised person. IMPORTANT! Please make this information available to the person responsible for installing the product as it could reduce your installation costs. The cavity must be a completely sealed box with no gaps. This will ensure the cooling air flows under the product and through the oven frame to give the correct venting and cooling for the oven and cabinet surround. Failure to seal cavity box may cause distortion of surrounding cabinetry. Read these instructions carefully before installing or using this product. 1 Before you start Ensure a suitable disconnection switch is incorporated in the permanent wiring, mounted and positioned to comply with the local wiring rules and regulations. A means of disconnection with at least a 3mm air gap contact separation in all poles must be incorporated into the fixed wiring in accordance with the wiring rules, unless the local wiring rules allow for the following variation. A means of disconnection from the supply having an air gap separation in all active (phase) conductors must be incorporated in to the fixed wiring. Ensure that the location of the oven connection socket is outside the installation space if the product is flush to the rear wall. Ensure the benchtop and the oven cavity are square and level. Ensure the electrician provides sufficient free length of mains cable to reach from the bottom rear of the cavity to at least 1.5 metres in front of the bottom edge of the opening. The cable may enter the cavity from the side, top or bottom, but top entry must be at the rear of the cavity. Use easy to clean finishes for the wall surfaces surrounding the oven and cooktop to aid in removal of any cooking fume staining resulting from the use of the oven and cooktop. Check the height from the floor suits the user. Ensure that drawers and doors will be clear of obstruction when fully opened. Installation Instructions Installation instructions 1 Check that the oven cavity is square and within the limits in the installation dimensions. Flush fitting installation options a 2 Remove the mains wiring access cover. 3 Connect the mains wiring and replace the 20 mm access cover. 4 Remove the oven door and accessories, lift and slide oven into place. When installing the oven it is essential to centre the product in the cavity giving a spacing of 2.5mm from the door edge to the joinery 5 Secure oven in cavity using the four ‘wood 2.5 mm b screws’ and washers supplied through the enamelled frame at either side of the oven as shown in the flush fitting installation options. 20 mm 6 Test then refit the door and accessories, check that the oven is firmly secured in the kitchen unit. 2.5 mm CUPBOARD FRONT c Installing a cooktop above an oven If installing a cooktop above the oven ensure adequate clearance is provided for the cooktop as per the Cooktop Manufacturers Instructions. 20 mm 2.5 mm DRAWER FRONT 2 Height recommendation guide Figures are based on an average height of 1650mm (5’5”) wearing shoes. The height of the product may vary according to the height of the most frequent user. 3 BI602 series Single Built-In Oven 595 mm 550 578 mm mm 915 mm 550 mm 932 mm mm 595 mm 595 BI602ED series Double Built-In Oven m 460 m door upper m 20 m mm m 3 1 5 m or 5 6 2 m 20 m m 460nm door lower do 585 mm 922 mm ove m 562 m m 0m 0 6 m 0m 60 Top View 570 mm MIN 570 mm MIN Top View 20 mm 20 mm 16-20 mm 16-20 mm 600 mm 600 mm 4 578 mm 595 mm BI602CTE series Built-In Oven/Cooktop Combination 595 mm 550 mm Benchtop Detail Benchtop 20 mm CookTop Cutout* Gap 15 mm MIN. OVEN m 20 m m m 562 m 460 moor 55 mm MIN. *see cooktop installation instructions p/n 599100 d oven Cooktop Installation 1 Remove the brackets from the cooktop. 2 Place the cooktop in the cutout and secure using the brackets previously removed. 3 Feed the cooktop wiring harness out through the oven cavity. 4 Remove the oven connector block cover on 585 mm the oven top wiring cover. 5 Connect the cooktop wiring harness lining the numbers/letters on the harness with the numbers/letters on the oven connector block. Leave plastic wiring card attached for future reference. m 0m 0 6 6 Clamp the wiring harness with the wiring clamp on the oven top wiring cover. 7 Replace the oven connector block cover. 8 Install the oven as described on page 2. 570 mm MIN Top View 20 mm 16-20 mm 600 mm 5 harness detail plastic wiring card oven connector block 5 4 P N E E N 3 2 1 5 4 P N E E N3 2 1 550 m m ave microw door 46 5 m m 433 mm 930 mm m 450 mm 595 m BI602XC series Built-In Oven/Microwave Combination 455 mm 30 mm 5 560 95 mm mm 932 mm BI452 series Compact Built-In Oven m 20 m m m 562 m 315 m r m 20 m m m 562 m 460 m r doo oven oven doo 440 mm 935 mm 595 mm 70 mm min. clearance m 0m 0 6 m 0m 0 6 570 mm MIN Top View 570 mm MIN Top View 20 mm 16-20 mm 20 mm 16-20 mm 600 mm 600 mm 6
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : Yes Page Count : 8 XMP Toolkit : XMP toolkit 2.9.1-13, framework 1.6 About : uuid:b4afd87c-3c22-11d9-babb-000a95b6ccda Producer : Acrobat Distiller 6.0.1 for Macintosh Modify Date : 2004:11:22 14:06:06+13:00 Creator Tool : Adobe InDesign CS (3.0.1) Create Date : 2004:11:22 14:06:06+13:00 Document ID : uuid:b4afc6ac-3c22-11d9-babb-000a95b6ccda Format : application/pdf Creator : Adrian Title : 541768C_BIcombo_INST.indd Author : AdrianEXIF Metadata provided by EXIF.tools