Fisher Price 1580T Baby Monitor User Manual 71580pr 0920qrk

Fisher-Price Inc. Baby Monitor 71580pr 0920qrk

manual

SOUNDS SO CLEARNURSERY MONITORProduct Number: 71580•Adult assembly is required to install the battery (if used).•For proper setup and use, please read these instructionsand keep for future reference.•Includes one AC adaptor to power receiver (plugs intostandard household outlets –120V AC). Receiver also runson battery power (9V alkaline battery – not included).•Includes one AC powered transmitter (plugs into standardhousehold outlets – 120V AC).PROBLEMS AND SOLUTIONSPROBLEMS SOLUTIONS1Transmitter power off. Power indicator not lit. 2You hear static or buzzing because transmitter channel switch is not onsame channel as receiver.3Transmitter power off. Power indicator not lit. Light switch that controlspower flow to wall outlet off.4Transmitter power off. Power indicator not lit. AC power cord plug-to-outlet not connected.5Transmitter power off. Power indicator not lit. Power is off because circuit breaker for baby’s room off.6You hear static or buzzing and all five bars lit on receiver.1Turn transmitter power on. Power indicator lights.2Make sure channel switches on both transmitter and receiver set to same channel.3Make sure light switch that controls power flow to wall outlet is on.4Check AC power cord plug-to-outlet connections.5Make sure house fuses and circuit breakers are on.6Check all five solutions above. Any one or more of these solutions should solve the problem.Helpful Hint: If, after checking all of these solutions, you believe that your transmitterAC power cord or receiver AC adaptor is damaged, please call Fisher-Price®at 1-800-432-KIDS.PROBLEMYou can hear conversations orsounds from other homes. There issignal interference due to other nursery monitors on same channel or cordless telephones.SOLUTIONChange channel switches on both trans-mitter and receiver to eliminate source of interference.Helpful Hints:- Do not use more than one transmitterand one receiver at same time in samehousehold.- Always remember that you are usingpublic airwaves when using your moni-tor. Conversations, even from roomsnear transmitter, may broadcast to othernursery monitors, radios, cordless tele-phones, or scanners outside your home.To protect privacy of your home, alwaysturn transmitter off when not in use.PROBLEM SOLUTIONCircuit Breaker312426BUZZZZBUZZZZZBUZZZZZ5STATICSTATICSTATIC2“Ma, ma, ma. Da, da, da…”“Did you readabout…”“Did you readabout…”“Wah, Wah,Wah…”“Wah, Wah,Wah…”“Wah, Wah,Wah…”1You hear static or buzzing because receiver is out of range of transmitter. Note: Range varies depending on surrounding conditions such as noise levels, physical obstructionsand signal interference.Move receiver closer to transmitter.Helpful Hint:- If you cannot hear your child and all five bars do not light, yourreceiver battery is weak. Replace receiver battery with a fresh,9V alkaline battery or use AC adaptor for power source.TM
IMPORTANT!• This product is not intended to be used as a medical monitorand its use should not replace adult supervision.• Test sound reception of receiver before first-time use and whenever you change location of transmitter.• To prevent entanglement:- Never place transmitter in a crib or playpen. Keep transmitterand receiver out of baby’s reach.- Never use extension cords with transmitter or AC adaptor.• Never use transmitter, receiver or AC adaptor near water(ie.: bathtub, sink, laundry tub or wet basement, etc.).• Always use transmitter, receiver and AC adaptor where there isadequate ventilation. To prevent overheating, keep transmitter,receiver and AC adaptor away from heat sources such as radiators, heat registers, direct sunlight, stoves, amplifiers, or other appliances which produce heat.CAUTIONThis product cannot replace responsible adult supervision.Place transmitter in room inwhich you intend to use it. Slidetransmitter power switch to turnpower on. Turn on a radio.Test transmitter transmission and receiver reception.Place receiver in room in which you intend to use it. Rotate on/off/volume dial to turn power on. Adjust receiver location.Hint: If you turn receiver power onbefore transmitter power, you willhear a static noise and all five bars in variable light display light.Simply turn volume down and turntransmitter power on.If you experience interference(buzzing or static, etc.) whileusing one channel setting,switch both units to other channel. Selecting a channel isusually a one time adjustment.9V (6LR61)SHOWN ACTUAL SIZE• Locate battery compartment door on back of receiver.• Loosen screw in battery compartment door.• Open battery compartment door and snap terminals of a fresh, 9V alkaline battery into receiver connectors.• Close battery compartment door. Tighten screw with Phillips screwdriver.Do not over-tighten.• Remove the battery during long periods of non-use. Always removean exhausted battery from the product. Battery leakage and corrosioncan damage the product. Dispose of the battery safely.• Never short circuit the battery terminals.• A non-rechargeable battery is not to be recharged.• Only a battery of the same or equivalent type as recommended inthe “Receiver Battery Installation” instructions is to be used.• If a removable rechargeable battery is used, it is only to be chargedunder adult supervision.• A rechargeable battery is to be removed from the product before it is charged.• If you use a battery charger, it should be examined regularly for damage to the cord, plug, enclosure and other parts. Do not use adamaged battery charger until it has been properly repaired. IMPORTANT! Test sound reception of this monitor before first time use and whenever you change location of transmitter (see this page).1Set transmitter channel switch to same channel as receiver.2Place transmitter in same room with child. Point microphone directly toward crib or play area. 3Plug AC power cord into wall outlet.4Slide transmitter on/off switch to turn power on. Power indicator lights.5Place receiver where you will see or hear it. 6Unwrap and fully extend AC adaptor cord for best reception. InsertAC adaptor jack into receiver socket and plug into wall outlet.Note: To use a 9V alkaline battery for power source, refer to“Receiver Battery Installation” instructions on this page.7Rotate receiver on/off/volume dial to turn power on. Power indicator lights. Rotate on/off/volume dial to adjust volume. Battery Compartment Door23“Peek-a-boo…”41Occasionally a consumer may experience a problem with one of ourproducts. If this should happen, please call us, toll-free, rather thanreturn this product to the store. Usually we can solve the problem onthe telephone or by sending you replacement parts. Please call Fisher-Price®Consumer Affairs, toll-free at 1-800-432-KIDS, 8 AM - 5 PMEST Monday through Friday. Hearing-impaired consumers using TTY/TDDequipment, please call 1-800-382-7470. Or, write to: Fisher-Price®Consumer Affairs, 636 Girard Avenue, East Aurora, New York 14052.Excess dirt in transmitter microphone will hamper transmission of sound. Clean outer surface of transmitter and receiver with a cloth lightly dampened with a mild cleaning solution.Never immerse transmitter, receiver or AC adaptor.Note: This equipment has been tested and found to comply withthe limits for a Class B digital device, pursuant to Part 15 of the FCCRules. These limits are designed to provide reasonable protectionagainst harmful interference in a residential installation. This equip-ment generates, uses and can radiate radio frequency energyand, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in aparticular installation. If this equipment does cause harmful interfer-ence to radio or television reception, which can be determined byturning the equipment off and on, the user is encouraged to try tocorrect the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Consult the dealer or an experienced radio/TV technician for help.Sounds So ClearTM Nursery MonitorModel Number: 71580This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may notcause harmful interference and (2) this device must accept anyinterference received, including interference that may cause undesired operation.Sounds So ClearTM Nursery MonitorConsumer Affairs Department636 Girard AvenueEast Aurora, New York 14052Any modification of the transmitter or receiver will violate FCCcompliance and can void the user’s authority to operate theequipment.Fisher-Price, Inc., 636 Girard Avenue, East Aurora, New York14052 warrants that the Sounds So ClearTM Nursery Monitoris freefrom all defects in material and workmanship when used undernormal conditions for a period of one (1) year from the date of purchase.Should the product fail to perform properly, we will repair orreplaceit at our option, free of charge. Purchaser is responsiblefor shipping the product to Consumer Affairs at the address indi-cated above and for all associated freight and insurance cost.Fisher-Price, Inc., will bear the cost of shipping the repaired orreplaced item to you. This warranty is void if the owner repairsor modifies the product. This warranty excludes any liabilityother than that expressly stated above including but not limitedto any incidental or consequential damages.SOME STATES DO ALLOW THE EXCLUSION OR LIMITATION OFINCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU.THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOUMAY ALSO HAVE OTHER RIGHTS WHICH MAY VARY FROM STATETO STATE.The electronic components in transmitter, receiver and AC adaptor are not designed for consumer repair. Evidence of any attempt of consumer repair will void this warranty.If you have any questions about this product:In Canada, call 1-800-567-7724, or write to: Mattel Canada Inc., 6155 Freemont Blvd.,Mississauga, Ontario L5R 3W2.In Great Britain, telephone 01628 500303.In Australia, Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond,Victoria 3121 Australia. Consumer Advisory Service 1-800-800-812 (valid only in Australia).Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14052, U.S.A.©1999 Mattel, Inc. All Rights Reserved.® and ™ designate U.S. trademarks of Mattel, Inc.Printed in Hong Kong 715780pr-09207156“Peek-a-boo…”RECEIVER BATTERYINSTALLATIONTESTING SOUNDRECEPTIONBATTERY TIPSFCC NOTE(UNITED STATES ONLY)ONE (1) YEARLIMITED WARRANTYSETUP AND USE CARECONSUMERINFORMATIONNotes: • Variable light display lights when sound is received by receiver.• If all five bars in variable light display light:- Receiver power is on and transmitter power is off.- Receiver is too far away from transmitter.- Receiver and transmitter are not on same channel.- Loud sounds are transmitting.

Navigation menu