Fisher Price B9636-03 Sound'n Lights Monitor User Manual 2 2003 25

Download:
Mirror Download [FCC.gov]
Document ID	353227
Application ID	7hKIjl6sa7p+YcUyzblgUg==
Document Description	User Manual Part 1
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	186.66kB (2333252 bits)
Date Submitted	2003-09-04 00:00:00
Date Available	2003-09-04 00:00:00
Creation Date	2003-09-03 08:38:47
Producing Software	pdfFactory v1.57 (Windows Me Chinese(Taiwan))
Document Lastmod	2003-09-04 14:45:58
Document Title	九月 2, 2003 (25)
Document Creator	pdfFactory http://www.pdffactory.com
Document Author:	cee3

FishepPrice'
Monitor
Model Number: B9636
For proper setup and use, please read these instructions.
Please keep this instruction sheet for future reference,
as it contains important information.
Includes two AC adaptors to power transmitter and receiver (plugs into
standard household outlets 7120V AC). Receiver also runs on battery
power (9V alkaline battery 7 not included).
Adult assembly is required to install the battery (if used).
Tool needed for battery installation:
Phillips screwdriver (not included).
IMPORTANT;
A CAUTION
This product cannot replace
responsible adult supervision.
- This product is not Intended to be used as a medical monitor
and its use should not replace adult supervision
- Test sound reception of receiver before first-time use and
whenever you change location of transmitter.
. To prevent entanglement:
, Never place transmitter in a crib or playpen. Keep transmitter
and receiver out of baby’s reach.
- Never use extension cords with the AC adaptors.
- Never use transmitter or receiver near water (ie; bathtub, sink,
laundry tub or wet basement, etc).
- Always use transmitter and receiver where there is adequate
ventilation.To prevent overheating, keep transmitter and receiver
away from heat sources such as radiators, heat registers, direct sun-
light, stoves, amplifiers, or other appliances which produce heat.
Consumer Information
Occasionally a consumer may experience a problem with one of our
products. if this should happen, please call us toll-free, rather than
return this product to the storeUsuaIIy, we can solve the problem
over the telephone or send you replacement parts.
Please call Fisher-Price® Consumer Relations, toll»free at
1-800-432-5437, between 8 AM » 6 PM EST, Monday through
Friday.
Hearing-impaired consumers using TTY/TDD equipment,
please call 1-800-382—7470.
Or write to:
Fisher-Price® Consumer Relations
636 Girard Avenue
East Aurora, New York 14052
C are
Excess dirt in transmitter microphone will hamper transmission of sound.
Clean outer surface oftransmitter and receiver with a cloth lightly damp-
ened with a mild cleaning solution.
Never immerse transmitter, receiver or AC adaptors.
Receiver Battery lnstalbtion (Optional)
9V(
I c°"‘""’“"‘e“' °°°’ SHOWN ACTUAL SIZE
~ Locate battery compartment door on bottom of receiver.
- Loosen screw on battery compartment door with a Phillips
screwdriver. Remove battery compartment door.
‘ Snap terminals ofa fresh, 9V alkaline battery into
receiver connectors,
- Replace battery compartment doorTighten screw with a
Phillips screwdriver.
Battery Safety Information
Batteries may leak fluids that can cause a chemical burn injury or
ruin your product.To avoid battery leakage
~ Insert battery as indicated inside the battery compartment.
~ Remove battey during long periods of non-use.Always remove an
exhausted battery from the product. Dispose of battery safely. Do
not dispose of battery in a fire.The battery may explode or leak.
- Never short—circuit the battery terminals.
- Use only a battery of the same or equivalent type, as recommended.
- Do not charge a non-rechargeable battery.
' Remove a rechargeable battery from the product before charging.
' lfa removable, rechargeable battery is used, it is only to be
Lliarged under adult supervisiuu.
‘Setupé’99Use ‘
[Setup 6? Use
IMPORTANT! Test sound reception of this monitor before first time
use and whenever you change location of transmitter (see page 4).
et transmitter channel switch to same channel as receiver.
2 Place transmitter in same room with child. Point microphone
directly toward crib or play area
Unwrap and fully extend AC adaptor cord for best transmission.
nsert AC adaptorjack into transmitter socket and plug into
; wall outlet.
4 Rotate transmitter power dial to turn power on. Power
f indicator lights.
5 Place receiver where you will see or hear it.
6 Unwrap and fully extend AC adaptor cord for best recep—
, tion. Insert AC adaptorjack into receiver socket and plug into
‘i wall outlet.
Note: To use a 9V alkaline battery for power source, refer to
”Receiver Battery Installation”instructions on page 3.
7 Rotate receiver power/volume dial to turn power on, Power
r indicator lights, Rotate power/volume dial to adjust volume.
Notes: AC adaptor is 120 VAC, 60Hz,4W input; 6 VDC iOOmA output;
center positive polarity; plug OD is 55 mm, plug D is 15 mm.
lfyou have any questions about this product:
In Canada, call 1-800567-7724, or write to. Mattel Canada lnc,oi 55 Freemont Blvd,
Mississauga, Ontario LSR 3W2.
In Great Bri in telephone 01628 500303.
ln Australia, Mattel Australia Pty Ltdnsss Church Street, Locked Bag $870,
Richmond, Victoria 3121 Australia. Consumer Advisory Service i—800—800—8i 2 (vai;d
only in Australia).
Testing Sound Reception
Test transmitter transmission and receiver reception
each time you change location of use.
Q Power
indicator
Place transmitter in room in which
you intend to use it‘ Rotate transmitter
power dial to turn power on. Power
indicator lightsrTurn on a radio.
iner
indicator
Pow rNqurne
Dial
Place receiver in room in which
you intend to use it Rotate
power/volume dial to turn power
on, Power indicator lights. Adjust
receiver location.
- Variable light display lights when
sound is received by receiver:
» One or two dots light for
shallow sounds.
- Three or more dots light for
louder sounds
- if you experience interference
(buzzing or static, etc) while using
one channel setting, switch both
units to other channel. Selecting
a channel is usually a one time
adjustment
Hint: All five dots in receiver variable light display ligh t:
- If you turn receiver power on before transmitter power. You will also hear static
nose. I urn volume down on receiver and turn transmitter power on
- If the receiver is too far away from the transmitter. Move the receiver closer to
the transmitter.
- If loud sounds are transmitting.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Create Date                     : 2003:09:03 08:38:47Z
Modify Date                     : 2003:09:04 14:45:58+02:00
Page Count                      : 6
Has XFA                         : No
Author                          : cee3
Producer                        : pdfFactory v1.57 (Windows Me Chinese(Taiwan))
Creation Date                   : 2003:09:03 08:38:47Z
Mod Date                        : 2003:09:04 14:45:58+02:00
Metadata Date                   : 2003:09:04 14:45:58+02:00
Title                           : 九月 2, 2003 (25)
Creator                         : cee3

EXIF Metadata provided by EXIF.tools