Fit2Go TPMS PC TPMS Pressure Checker User Manual Michelin TPMS Operations Manual 120mm X 170mm

Download:
Mirror Download [FCC.gov]
Document ID	3569824
Application ID	2ECq07N94Rn0dM4VCHejXg==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	Yes
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	59.87kB (748360 bits)
Date Submitted	2017-09-20 00:00:00
Date Available	2017-09-20 00:00:00
Creation Date	2017-05-25 16:14:28
Producing Software	Mac OS X 10.11.6 Quartz PDFContext
Document Lastmod	2017-09-20 12:00:49
Document Title	Michelin TPMS Operations Manual (120mm X 170mm)
Document Creator	PowerPoint

TPMS Pressure Checker
Model: PC-1
Operating Frequency: TX-125KHz; RX-433.92MHz
TPMS Sensor
Model: ELTS-1
Operating Frequency: TX-433.92MHz; RX-125KHz
Receiver Fitting Instructions
1. TURN ON RECEIVER
Using a pen simply press and hold down for 5
seconds the small button on the rear as
shown. When the Receiver Powers up the
Icons will flash and there will be a loud bleep.
The white Power Icon will flash ON every 3
seconds for half a minute before reverting to
normal working mode.
2. RECEIVER POSITION, REMOVAL OF
ADHESIVE BACKING
Find the ideal position for the receiver along the
top of the windscreen ensuring that it is outside
the wiper sweep. Ensure the solar panel is not
blocked by the black border which exists on many
windscreens. Clean the windscreen area selected.
Remove the backing from both adhesive pads.
Take care not to touch the adhesive surface.
3. FITTING RECEIVER
Place the receiver in the correct position
and push firmly against the windscreen,
holding and pushing for up to 10 seconds.
TPMS Sensors Fitting Instructions
1. TYRE PRESSURE
IMPORTANT : ALL TYRE PRESSURES
MUST BE INFLATED TO THE CORRECT
PRESSURE BEFORE FITTING THE TPMS
SENSORS
The target pressure is the normal cold operating
pressure that you require for each tyre. The
vehicle manufacturer provides this information
and it is usually printed in the vehicle manual
and on a label in the driver’s door frame.
2. ATTACH TPMS SENSOR
a) Remove the dust cap.
b) Twist on a anti-theft lock nut (clockwise).
c) Twist on the Fit2Go TPMS Sensor until
FINGER TIGHT.
d) Check for the Red LED flashing on while
the clever TPMS sensor self-calibrates to
the current tyre pressure.
3. TIGHTEN THE ANTI-THEFT LOCK NUT
Using the special lock nut tool supplied in
your kit, tighten the anti-theft lock nut anticlockwise, until it locks tightly against the
TPMS Sensor. Take care to ensure that the
TPMS Sensor does not loosen during this
operation.
NOTE : The TPMS Sensor will auto-pair to
your receiver and auto-calibrate to the tyre
pressure.
Pressure Checker Operation Instructions
1. TURN ON
(the pressure checker require 2 X AAA
batteries).
To turn on simply Press down the Power
button for five seconds and the Pressure
Checker will Power up and you will hear a
bleep sound. There will be a battery indication
in the bottom right of the screen and this is
representative of the battery level of the 2 X
AAA batteries in the Pressure Checker.
2. CHANGE UNITS
Factory setting is in psi. To change to bar,
press the Power button five times quickly. The
screen indication will now show bar.
3. TYRE PRESSURE MEASUREMENT
Place the MICHELIN head logo of the
pressure checker over the MICHELIN head
logo on the TPMS sensor (you will feel a
magnetic pull). Witihn 5 seconds TPMS
TURN OFF / AUTO-TURN OFF
sensor will detect the presence of the
To turn off the Pressure Checker simply hold
pressure checker and transmit the actual
down the Power Button for 3 seconds and with a pressure of the tyre. The TPMS sensors will
bleep the Pressure Checker will be turned OFF. flash RED once and the tyre pressure and
Alternatively the Pressure Checker has an auto sensor battery level will be displayed on the
switch off function if not used for one minute.
pressure checker.
MICHELIN Tyre Pressure Management System
Warnings, Alarms & Specifications
POWER ICON
The POWER Icon will flash white every 60 seconds when the receiver battery power is OK. This Icon will flash
RED when the battery power is low. If there is no power the Icon will not flash and the receiver needs solar
power.
TEMPERATURE ICON
The Temperature Icon will flash ORANGE if the tyre temperature is too high. STOP the vehicle and check the
TPMS Sensors for RED flashing LEDs.
LOW SENSOR BATTERY ICON
The Sensor Low Battery Icon will flash ORANGE to warn of a low battery in one or more sensors.
PRESSURE ICON
A. EARLY LOW PRESSURE (-15%)
The Pressure Icon will flash ORANGE every 20 seconds. Please drive carefully as this is the onset of handling
problems. Inflate tyres to the correct pressure at your earliest convenience.
B. HIGH PRESSURE (+35%) / LOW PRESSURE (-25%) / MINIMUM PRESSURE (22psi/1.5bar)
The Pressure Icon will flash ORANGE every 5 seconds and there will be a bleep sound. After 30 seconds this
warning will continue as Pressure Icon flashing ORANGE every 20 seconds. STOP the vehicle at nearest
convenience and check the TPMS Sensors for RED flashing LEDs.
C. MEDIUM / FAST LEAKAGE (1.5 psi / 3 psi per minute leakage)
The Pressure Icon will flash ORANGE every 5 seconds and there will be a bleep sound. After 60 seconds this
warning will continue as Pressure Icon flashing ORANGE every 5 seconds. STOP the vehicle at nearest
convenience and check the TPMS Sensors for RED flashing LEDs.
SERVICE AND WARRANTY
Please register your guarantee by completing your details on our web site. The system is warranted to be free from manufacturing
defects and is guaranteed for a period of twelve months from date of purchase. There are no user- serviceable parts inside and if
internal parts have been tampered with, the warranty may be void. The warranty does not affect your statutory rights.
PRODUCT DISCLAIMER
The Michelin Tyre Pressure Management System is designed as a driver assistance device, and should not be used as a substitute for regular
manual tyre safety checks.
Neither the seller nor the manufacturer will be liable for any loss damage or injury directly or indirectly arising from the use or inability to
determine the use of this product. Before using, the user shall determine the suitability of the product for its intended use, and the user shall
assume all responsibility and risk in connection herewith.
The driver is always responsible for the condition of tyres on their vehicle and regular visual checks are essential to stay tyre safe. All Tyre
pressures should be checked at the very least once a month or before any long journey, when the tyres are in their cold state, using an supplied
Michelin Pressure Checker. Whilst checking pressures it is also recommended to give the tyres a thorough inspection for any tyre damage, tread
depth or uneven wear.
Information has been carefully checked and is believed to be accurate; however, no responsibility is assumed for inaccuracies. Fit2Go TPMS Ltd
reserves the right to make changes without further notice to any products to improve reliability, function, or design. Fit2Go TPMS Ltd does not
assume any liability arising out of the application or use of any product.
TPMS SENSOR SPECIFICATION
Working temperature: -20℃ to 80℃
Storage temperature: -40℃ to 85℃
Pressure range: 0-92 psi / 0-6.3 bar
(not suitable for trucks)
Pressure Accuracy: ± 0.5 psi
Temperature Accuracy: ±3℃
Size: 19.8mm×14.4mm
Weight: 8g
RECEIVER SPECIFICATION
Working temperature: -20℃to 80℃
Storage temperature: -40℃ to 85℃
Standby current: ≦30uA
Working current: ≦1mA
Size: 102mm × 42mm x 16.5mm
Weight: 69g
Consumer enquiries:
Tel. 01543 415823
emaill: michelin@fit2gotpms.co.uk
© 2017 Michelin. www.michelin-lifestyle.com
MICHELIN and/or the Michelin Man Device and/or
BIBENDUM are trademark(s) owend by, and used wit h
the permission of, the Michelin Group.
Distributed under licence by
Fit2Go TPMS Ltd. Unit 52, Brit annia Way, Brit annia
Enterprise Park, Lichfield, Staffordshire, WS14 9UY, UK
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer
could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The device can be used
in portable exposure condition without restriction.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Create Date                     : 2017:05:25 16:14:28Z
Creator                         : PowerPoint
Modify Date                     : 2017:09:20 12:00:49+08:00
Has XFA                         : No
XMP Toolkit                     : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00
Creator Tool                    : PowerPoint
Metadata Date                   : 2017:09:20 12:00:49+08:00
Keywords                        : 
Producer                        : Mac OS X 10.11.6 Quartz PDFContext
Format                          : application/pdf
Title                           : Michelin TPMS Operations Manual (120mm X 170mm)
Document ID                     : uuid:2667af82-0183-4e60-90ad-aaf7bfaf87d9
Instance ID                     : uuid:92490ca3-d978-4709-9acc-dc06a331da13
Page Count                      : 3

EXIF Metadata provided by EXIF.tools