Fleetwood Group V240S Low Power RF and IR Module User Manual CERTIFICATE OF COMPLIANCE
Fleetwood Group Inc Low Power RF and IR Module CERTIFICATE OF COMPLIANCE
User Manual
Rhein Tech Laboratories, Inc.
Client:
Fleetwood Group, Inc.
360 Herndon Parkway
Model:
V240S
Suite 1400
Standards:
FCC 15.249/IC RSS-210
Herndon, VA 20170
http://www.rheintech.com
FCC/IC ID:
FBRV240S/1859A-V240S
Report #: 2010235
Page 28 of 38
Appendix L: Manual
Please refer to the following pages.
USER MANUAL
V240S Module
ii
Copyright 2007 Fleetwood Group, Inc., Electronics Division. All rights reserved. Licensed software products are
owned by Fleetwood Group, Inc. or its suppliers and are protected by United States copyright laws and international
treaty provisions.
Fleetwood Group, Inc. products are covered by U.S. and foreign patents, issued and pending. Information in this
publication supersedes that in all previously published material. Specifications and pricing are subject to change
without notice.
Printed in the U.S.A.
Fleetwood Group, Inc.
Electronics Division
11832 James St.
Holland, Michigan 49424
www.fleetwoodgroup.com
Sales: 1-800-257-6390
Technical Service: 1-888-GO-REPLY (467-3759)
Reply® is a registered trademark of Fleetwood Group, Inc.
Other trademarks contained herein are the property of their respective holders.
Revision History:
Rev
Date
Description
A
2/3/2011
Original
iii
Table of Contents
1.0 V240S MODULE .................................................................................................................................................. 4
1.1 DESCRIPTION ....................................................................................................................................................... 4
1.2 BATTERY REPLACEMENT ..................................................................................................................................... 4
1.3 FCC AND IC ......................................................................................................................................................... 4
1.4 STANDARDS AND GUIDELINES ............................................................................................................................. 4
1.5 FCC/IC COMPLIANCE .......................................................................................................................................... 5
4
1.0 V240S Module
1.1 Description
The V240S is a low power real time locating system sensor. The V240S module is used to identify the location of
an individual or asset location. It communicates at 2.4GHz, to a badge module or a link module, and uses an IR
receiver that receives data from a badge to determine its location.
The overall operation of the V240S module is controlled by a microcontroller. This microcontroller is powered
from an internally regulated supply, and uses a 16 MHz reference. The V240S module can be powered from
batteries, approximately 4.5V, or low voltage DC. The microcontroller handles control of the RF and IR
communications, indicator LEDs, external I/O, and external serial communications.
RF communications use a 2.4 GHz transceiver. The transceiver chip uses a 16 MHz reference oscillator that is
shared with the microcontroller for TX/RX, and is also powered by an internally regulated supply. The transceiver
uses an integral antenna on the PCB.
1.2 Battery Replacement
The V240S can be powered from 3, D Cell batteries. The batteries are replaceable. To replace the batteries, open
the case, remove the old batteries, and replace with new batteries noting their polarity.
1.3 FCC and IC
V240S Module
Responsible Party Pertaining to the Declaration of Conformity
Fleetwood Group, Inc.
11832 James Street
Holland, MI 49424
Attn: Product Service Coordinator
Phone: 888-467-3759
1.4 Standards and Guidelines
This device complies with the following USA/Canada Regulations:
The USA Federal Communications Commission (FCC) Rules and Regulations
Industry Canada Rules and Regulations
This device complies with the following national and international standards:
FCC Part 15B, 15.249 (10-01-09)
IC RSS-210 Issue 8
5
1.5 FCC/IC Compliance
This device complies with Part 15 of the FCC Rules and RSS-210 of the Industry Canada Rules. Operation is subject to
the following two conditions: (1) this device may not cause interference and (2) this device must accept any interference,
including interference that may cause undesired operation of the device. The user is cautioned that changes or
modifications to the device that are not approved by the manufacturer could void the user’s authority to operate the device.