Fleetwood Group VL4B Low Power RF and IR Module User Manual CERTIFICATE OF COMPLIANCE

Fleetwood Group Inc Low Power RF and IR Module CERTIFICATE OF COMPLIANCE

User Manual

Download: Fleetwood Group VL4B Low Power RF and IR Module User Manual CERTIFICATE OF COMPLIANCE
Mirror Download [FCC.gov]Fleetwood Group VL4B Low Power RF and IR Module User Manual CERTIFICATE OF COMPLIANCE
Document ID1330247
Application IDTJpnbjO7M0CknEkBlPyL0g==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize4.9kB (61242 bits)
Date Submitted2010-08-20 00:00:00
Date Available2010-08-20 00:00:00
Creation Date2010-08-18 15:23:26
Producing SoftwareAdobe PDF Library 9.0
Document Lastmod2010-08-18 15:23:56
Document TitleCERTIFICATE OF COMPLIANCE
Document CreatorAcrobat PDFMaker 9.1 for Word
Document Author: Systems Administrator

Rhein Tech Laboratories, Inc.
360 Herndon Parkway
Suite 1400
Herndon, VA 20170
http://www.rheintech.com
Appendix K :
Client:
Model:
Standards:
FCC/IC ID:
Report #:
Fleetwood Group, Inc.
VL4B
FCC 15.231/IC RSS-210
FBRVL4B/1859A-VL4B
2010155
Manual
Please refer to the following pages.
Page 27 of 38
USER MANUAL
VL4B Module
Copyright 2007 Fleetwood Group, Inc., Electronics Division. All rights reserved. Licensed software products are
owned by Fleetwood Group, Inc. or its suppliers and are protected by United States copyright laws and international
treaty provisions.
Fleetwood Group, Inc. products are covered by U.S. and foreign patents, issued and pending. Information in this
publication supersedes that in all previously published material. Specifications and pricing are subject to change
without notice.
Printed in the U.S.A.
Fleetwood Group, Inc.
Electronics Division
11832 James St.
Holland, Michigan 49424
www.fleetwoodgroup.com
Sales: 1-800-257-6390
Technical Service: 1-888-GO-REPLY (467-3759)
Reply® is a registered trademark of Fleetwood Group, Inc.
Other trademarks contained herein are the property of their respective holders.
Revision History:
ii
Rev
Date
Description
8/11/2010
Original
Table of Contents
1.0 VL4B MODULE ................................................................................................................................................... 4
1.1 DESCRIPTION ....................................................................................................................................................... 4
1.2 BATTERY REPLACEMENT ..................................................................................................................................... 4
1.3 FCC AND IC......................................................................................................................................................... 4
1.4 STANDARDS AND GUIDELINES ............................................................................................................................. 4
1.5 FCC/IC COMPLIANCE .......................................................................................................................................... 5
iii
1.0 VL4B Module
1.1 Description
The VL4B Module is an infrared transmitting badge with a RF supervisory signal. The VL4B Module contains a
low power RF transmitter chip which is controlled by a micro processor. The frequency synthesizer for generation
of the RF output carrier is received from a low frequency external crystal. A crystal resonator chip runs the micro
processor device. When an RF transmission needs to be generated the data from the microprocessor is sent to the RF
chip. The modulation used by the radio frequency chip is on/off key at 433.92MHz. The RF antenna is a PCB
etched loop. The VL4B is powered by a three-volt battery.
Both infrared and RF signals are independent of each other. Both infrared and RF signals contain recognition code
to identify the badge, along with motion status, battery status, and switch information.
There are two ways that theVL4B Module can send RF transmission packets. The first is an automatic transmission
per FCC regulations section 15.231 part (a) paragraph three, which states that the periodic rate of transmission does
not exceed one transmission of not more than one second duration per hour of each transmitter. The second type of
RF transmission occurs when a button is pressed on the badge. The RF transmission packets cease operation when
the button is released.
1.2 Battery Replacement
The VL4B is powered from a 3V battery. The battery is replaceable. To replace battery, open the case, remove the
old battery, and replace with a new battery noting its polarity. The negative side of the battery should be facing the
PCB.
1.3 FCC and IC
VL4B Module
Responsible Party Pertaining to the Declaration of Conformity
Fleetwood Group, Inc.
11832 James Street
Holland, MI 49424
Attn: Product Service Coordinator
Phone: 888-467-3759
1.4 Standards and Guidelines
This device complies with the following USA/Canada Regulations:
 The USA Federal Communications Commission (FCC) Rules and Regulations
 Industry Canada Rules and Regulations
This device complies with the following national and international standards:
 FCC Part 15B, 15.231e (10-01-09)
 IC RSS-210 Issue 7
1.5 FCC/IC Compliance
This device complies with Part 15 of the FCC Rules and RSS-210 of the Industry Canada Rules. Operation is subject to
the following two conditions: (1) this device may not cause interference and (2) this device must accept any interference,
including interference that may cause undesired operation of the device. The user is cautioned that changes or
modifications to the device that are not approved by the manufacturer could void the user’s authority to operate the device.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Author                          : Systems Administrator
Create Date                     : 2010:08:18 15:23:26-07:00
Modify Date                     : 2010:08:18 15:23:56-07:00
XMP Toolkit                     : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04
Metadata Date                   : 2010:08:18 15:23:56-07:00
Creator Tool                    : Acrobat PDFMaker 9.1 for Word
Format                          : application/pdf
Title                           : CERTIFICATE OF COMPLIANCE
Creator                         : Systems Administrator
Document ID                     : uuid:9c266bfe-1009-45c0-b6c2-658ca48d454f
Instance ID                     : uuid:0681d93f-47a7-4977-bb46-7bab2503b482
Producer                        : Adobe PDF Library 9.0
Page Count                      : 6
EXIF Metadata provided by EXIF.tools
FCC ID Filing: FBRVL4B

Navigation menu