Freescale Semiconductor MC33493MOD315E RF MODULE 315MHz DEVELOPER KIT User Manual USERS MANUAL

Freescale Semiconductor, Inc. RF MODULE 315MHz DEVELOPER KIT USERS MANUAL

USERS MANUAL

MC33493MODxxx Quick Start Guide Laurent GAUTHIER-TSPG-MCD-ARC  Page 1  Last update: February 5, 2007   MC33493MODxxx KIT Quick Start User Guide  This document provides first information to use MC33696 tools.  Last update: V1.1: Note for FCC  Important: This device complies with Part 15 of the FCC Rules.  Operation is subject to the following two conditions:  (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.  Note: the manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.  1 OVERVIEW  MC33493MODxxx operation requires:   An MC33493MODxxx RF Module with attached Printed antenna   A DEMO9S08RG60 MCU board  An RS232 cable   A PC with RS232 port, CD player and Hyper Terminal.   A 9V Battery    The operation of MC33493 is done by sending with Hyper Terminal a script to the MCU board that will configure MC33493 in a defined configuration.
MC33493MODxxx Quick Start Guide Laurent GAUTHIER-TSPG-MCD-ARC  Page 2    Available script files:  standby configuration   continuous CW transmission   continuous 4.8kHz OOK transmission   continuous 4.8kHz FSK transmission   2  LAUNCHING THE KIT   Plug the RF Module on the MCU board   Connect the MCU board to the PC using the RS232 cable   Launch HyperTerminal using the proper xxx.ht file according to available COM port   Connect the 9V battery   Screen on HyperTerminal receives status of MC33493 Registers and Pin levels      3  SENDING A SCRIPT FILE 3.1 Configuration in Receive mode   With the mouse, click on “Transfer/Send text file”   Select the xxx.txt Script file corresponding to the wanted configuration   For exemple :“TX OOK 433.92MHz Square 4800bps.txt” will configure the kit in Teceive mode at 433.92MHz to send a modulated signal at 4800bps.   At the end: “Sending square wave” indicates that the kit is sending a continuous modulation

Navigation menu