Futaba FHSS3-24G Radio Control User Manual user manual

Futaba Corporation Radio Control user manual

User manual

  FHSS3-24G 2.4GHz Module User Manual. Futaba  corporation 1080 Yabutsuka Chosei-son Chosei-gun   Chiba 299-4395    JAPAN 1. Features  2.4GHz Frequency Hopping Spread Spectrum (FHSS) radio transceiver module.  Operates in the unlicensed worldwide ISM band (2.4 GHz to 2.483.5GHz) band  Fully integrated power regulation with a wide input unregulated operating range 4.0 to 7.2V.  Equipped Fully integrated local oscillator and 26MHz 20ppm reference crystal  100mA operating current  Transmit power    60mW EIRP  Receive sensitivity up to -98dBm  FHSS data rates up to 500kbps  1/2 mile operating range  2. Pin assign Pin Number Name  Description J110 1 Vcc  Module power input      2 GND  Module Ground 3 DATA  Input/output 1 4 CS  Input/output 2  3. Specifications Parameter Value Units Storage temperature -20 ~ +80  Degrees Celsius Operating temperature -10 ~ +45  Degrees Celsius Transmit power (conducted) 16 max  dBm Receive Sensitivity -98 dBm Input voltage  4.0 ~ 7.2  Volt Regurated voltage  3.3  Volt Transmit current 100 max mA
4. Module User Requirements  4.1 This module must be integrated into a device where the user cannot access the antenna connector and should not be able to remove or install the module.  4.2 Under a 2.14dBi antenna can be used with this module. The antenna must not exceed the gain and pattern of the standard dipole antenna.  4.3 The device must contain the following permanent labeling on the exterior of the device as follows:  Contains FCC ID: AZPFHSS3-24G  4.4 The user manual of the device must contain the following paragraph:  This device complies with part 15 of the FCC rules. Operation is subject    to the following two conditions: (1) This device may not cause harmful    interference, and (2) this device must accept any interference received,    including interference that may cause undesired operation.  Caution: Changes or modifications not expressly approved by the party    responsible for compliance could void the user’s authority to operate the equipment.  This product contains a radio transmitter with wireless technology which has been tested and found to be compliant with the applicable regulations governing a radio transmitter in the 2.400 GHz to 2.4835 GHz frequency range.  4.5 This module meets the requirements for a mobile device that may be used at separation distances of more than 20cm from the human body. To meet the RF exposure requirements of the FCC this device shall not be co-located with another transmitting device.

Navigation menu