G4S Monitoring Technologies SOL915 OM247 SOLO2 User Manual User Guide Safety

G4S Monitoring Technologies Limited OM247 SOLO2 User Guide Safety

User Guide (Safety)

Document Classication: PublicOM247-SOLO Safety GuideUser Safety and Regulations
Page 2Document Classication: PublicThis guide contains basic regulatory and safety information.Document Number: 94-0159-01Revision: 1.0Issue Date: 22/05/2014About This Guide
Page 3Document Classication: PublicOperational WarningsImportant information on safe and efcient operation. Read this information before using the device. For safe and efcient use of the device, observe the guidelines outlined below.International Protection RatingThe device carries an IP rating of IP68 and as such can be immersed in water up to a depth of 5 metres.Environmental Specication10% to 90% humidity(Battery Charger tted) 0°C to +45°C(No Battery Charger tted) -20°C to +60°CInstallationThe equipment must be installed by a SERVICE PERSON.Unit RecordThe model number, regulatory number and serial number are located on a nameplate on the rear of the device.Battery ChargingWhen not in use, disconnect the battery charger from both the device and the mains electricity supply. To halt charging, remove the charging clip from the device.User Safety
Page 4Document Classication: Public Do not disassemble, open, crush, deform or puncture the product. Do not modify, remanufacture, attempt to insert foreign objects, expose to re, explosion or other hazards. Only use the product with an approved charger. Use of an unqualied charger may present a risk of re, explosion, leakage or other hazard. Use only approved power accessories such as AC-power adaptors.AC Power AdaptorSource: G4SMTLModel: SMCPart Number: 35-0092-3Input Rating: 100-240V VAC, 50-60Hz, 350mAOutput Rating: 5VDC, 3000mAProduct Handling
Page 5Document Classication: PublicThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Statements
Page 6Document Classication: PublicFCC Statements (continued)Modications not expressly approved by the manufacturer could void the user’s authority to operate the equipment under FCC rules.This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation. This product meets the FCC Radiofrequency Emission Guidelines and is certied with the FCC as:FCC ID: OY3SOLO433FCC ID: 2ACGBSOL915The FCC ID is located on a label on the rear face of the product.
Page 7Document Classication: PublicWe hereby declare that this device is in conformance to all essential requirements of the R&TTE Directive 1999/5/EC.This equipment is marked with the ‘CE’ symbol and can be used throughout the European Community.This indicates compliance with the R&TTE Directive 1999/5/EC and meets the relevant parts of the following technical specications: ETSI EN 300 220-1 V2.3.1 ETSI EN 300 220-2 V2.3.1 ETSI EN 301 489-1 V1.8.1 ETSI EN 301 489-3 V1.4.1 EN 60950-1:2006EU Regulatory ConformanceThis symbol indicates that this product should be recycled and not be disposed of in unsorted municipal waste. This product should be returned to the supplier for correct disposal.
Page 8Document Classication: PublicThis unit has been tested for RF exposure compliance at a qualied test laboratory. It was found to comply with the regulations regarding exposure to RF Energy under the recommendations of the International Commission on Non-Ionizing Radiation Protection (ICNIRP).SAR (Specic Absorption Rate) is measured using the device’s highest transmitting power. Because the device automatically lowers its power output to the minimum required to connect with the network, the actual SAR while it is operating is typically lower than the quoted gure.The SAR limit for mobile devices set by FCC/IC is 4.0 W/kg, averaged over 10 grams of tissue for the extremities — hands, wrists, ankles, and feet.The highest reported SAR value of the OM247-SOLO tag is 3.571 W/kg, averaged over 10g.The maximum 10g volume averaged SAR level measured for all the tests performed did not exceed the 2.0 W/kg level dened for limiting the exposure of the general population to time-varying electric and magnetic elds by ICNIRP (1998), which is the relevant standard for testing according to the CENELEC EN 62209-1: 2006 test method.RF Safety Exposure (SAR)

Navigation menu