G4S Technology S820 Proximity card reader User Manual Manual

G4S Technology Limited Proximity card reader Manual

Manual

Installation and User Instructions for S820 ReadersThe S820-HICLR is a 125kHz proximity card readerthat is capable of reading HID formatted cards, aswell as other standard and custom formats.The S820-HICLR uses 20mA current loopcommunications.®1Mount the BackplateTo mount the backplate:1) Detach the main body of the reader from the backplate by releasing the two securingscrews along the bottom edge of the reader.2) Mount the backplate adjacent to the opening edge of the door and at a convenientheight. Feed the cable to the reader through the backplate.You should find that the backplate has suitable holes forconnection to most standard electrical backboxes.2
9600-0303. Installation and User Instructions for S820Readers, Issue 1.0x1 22nd May 2003. AMAGTechnology, 2003.FCC Notice: This device complies with Part 15 of the FCCRules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) this device must accept any interference received,including interference that may cause undesired operation.Any unauthorised modification to this device may void theauthority of the user to operate it.All trademarks acknowledged.HID is a registered trademark of HID Corporation.©3Using the Reader2Reader Connections20mA Current Loop Reader ConnectionsTwisted pairs (useBelden 9503 cable)0VConnect screen atcontroller end only(attach to case)Tx-Tx+Rx-Rx+ Tx+Tx-Rx+Rx-12V 12V0VController connections(20mA reader port)RedBlackWhiteBlueGreenOrangeReaderPresent the proximity card face-on to the reader until you hear a "bleep". The maximum read rangeis typically 4" ( 10cm). If the green indicator is lit, the card has been accepted and the door isunlocked. If the red indicator is lit, either the card has not been accepted, or you do not haveaccess through the door.cards can be presented in rapid succession - there is no need to wait for the green or redLED to extinguish before presenting another card.Note:SpecificationsInput voltage: 9-14V.Input current: 100mA.Operating temperature: -4 to 150 F (-20 to 70 C)without heater.Operating humidity: 15 to 90%, non-condensing.Maximum read range: 4" (10cm).Approvals: EN50133, R&TTE, IP656.°°

Navigation menu