GE MDS DS-MESH2400 WiYZ Mesh Radio User Manual MESH2400 Prelim

GE MDS LLC WiYZ Mesh Radio MESH2400 Prelim

Contents

Installation Guide

MESH2400 MDS MESH2400 Radio Installation Guidelines 1 of 1
MESH2400
Radio Installation Guidelines
To comply with regulatory requirements products containing the GE MDS module shall:
1. In addition to any labeling requirements for the host system (such as those
required by FCC Part 15 and ICES-003 for a digital device) the host device shall
clearly display the FCC ID and Industry Canada number for the module on the
outside of the device. Wording should be of the format:
Contains FCC ID: E5MDS-MESH2400
Contains 101D-MESH2400
2. The module can only be used with the antennas associated with the device
approvals. At this time those antennas are:
Yagi: 97-4278A01
Omni: 97-4278A48
Panel: 97-4278A16
The system can only be operated with the antennas with which it was approved.
Where the device has been subject to professional installation requirements the
antenna may not be changed except by the professional installer.
3.
The module can only be installed in host systems manufactured by GE MDS. The
installation does not currently allow for collocating the device with other
transmitters.
4. In addition to the relevant
manual statements required by FCC Part 15 / ICES 003
for digital devices the host system manual must contain the following statement:
Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation
of the device.
5. The manual for the host system must also clearly explain the antenna installation
requirements. The antenna installation requirements shall include the following
statements:
To comply with rf exposure requirements the antenna shall be installed
to ensure a minimum separation distance of 20cm from persons. The
antenna may not be collocated or operated in conjunction with other
transmitting devices.
To reduce potential radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that permitted for successful
communication.
Where the host system uses standard rf connectors then professional
installation for that system must be ensured in accordance with the
policies already in place for similar part 15 systems.
6. The modular approval only covers the host system’s compliance with
the technical requirements for the intentional radiator. Complete system
verification against the digital device requirements of FCC Part 15, ICES
003 or other pertinent rules is required.

Navigation menu