GE MDS TRANSNET900 MDS TransNet 900 User Manual

GE MDS LLC MDS TransNet 900 2708A TransNET Body

a href="https://usermanual.wiki/GE-MDS" itemprop="url"> GE MDS >

users manual

MDS 05-2708A01 Rev. ASeptember 2001 TransNET 900“Spread Spectrum Data Transceiver MDS TransNET 900“
QUICK START GUIDE Below are the basic steps for installing the transceiver. Detailed instructions are given in INSTALLA-TION on page 24 of this guide. 1. Install and connect the antenna system to the radio ¥ Use good quality, low-loss coaxial cable. Keep the feedline as short as possible.¥ Preset directional antennas in the direction of desired transmission. 2. Connect the data equipment to the radio s INTERFACE connector ¥ Connection to the radio must be made with a DB-9 Male connector. Connections for typical systems are shown below. ¥ Connect only the required pins. Do not use a straight-through RS-232 cable with all pins wired.¥ Verify the data equipment is configured as DTE. (By default, the radio is configured as DCE.) 3. Apply DC power to the radio ¥ Observe proper polarity. The red wire is the positive lead; the black is negative. 4. Verify proper operation by observing the LED display ¥ Refer to Table 4 on page 32 for a description of the status LEDs.¥ Refine directional antenna headings for maximum receive signal strength using the RSSI command.
Download:
Mirror Download [FCC.gov]
Document ID224698
Application IDmcglbfLzBLtYGI1rB9KdLw==
Document Descriptionusers manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize127.37kB (1592120 bits)
Date Submitted2002-02-05 00:00:00
Date Available2002-02-04 00:00:00
Creation Date2002-01-16 17:00:19
Producing SoftwareAcrobat Distiller 4.0 for Macintosh
Document Lastmod2002-01-16 17:01:04
Document Title2708A-TransNET Body.book
Document CreatorFrameMaker 5.5
Document Author: MDS Employee
FCC ID Filing: E5M-TRANSNET900

Navigation menu