GE Power Electronics BLST-SP792 Electric Discharge Lamp Control Equipment User Manual User s Manual rev2

GE Power Electronics (Shanghai) Co., Ltd. Electric Discharge Lamp Control Equipment User s Manual rev2

User's Manual_rev2

Electronic Ballast For Electrodeless Fluorescent Lamp 1．Product code. 300W SP792-Y01A or SP792-Z01A 2．Outside characteristic. The outside picture of Electronic Ballast For Electrodeless Fluorescent Lamp as below, there are three wires at input port, L line is blue，N line is gray, GND line is yellow and green. There are two white wires at output port. The input wires connect to the power grid, and the output wires connect to the Electrodeless Fluorescent Lamp. Outside picture Inside picture Size：
Size picture 3．Electrical characteristic. 1) Rated Input Voltage: 120~277Vac 2）Input Rating Current 2.83A/1.48A/1.26A @120Vac/230Vac/277Vac --electrodeless lamp 300W 3）Output Rating Current 1.25A (load, electrodeless lamp 300W) 4）Output Rating Voltage 240V (load, electrodeless lamp 300W) 5）Start Trigger Voltage 2350±100Vop (load,electrodeless lamp 300W) 6）Output Frequency 230K±30kHz(load,electrodeless lamp 300W) 7）Open circuit and short circuit protection 4．Ambient temperature. Generally the ballast is set up in the lamps and lanterns to use, the ambient temperature of ballast is -40--55℃ in lamps and lanterns. 5. Warning: This product may cause interference to radio equipment and should not be installed near maritime safety communications equipment, ships at sea or other critical navigation or communication equipment operating between 0.45–30MHz.

Navigation menu