GIGA BYTE TECHNOLOGY GN-WIKG Wireless mini-PCI Module User Manual GN WIKG EN

Download:
Mirror Download [FCC.gov]
Document ID	441009
Application ID	+bI6wjtBQHLtMIeyd/VXzA==
Document Description	user manual part 1
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	138.94kB (1736707 bits)
Date Submitted	2004-06-16 00:00:00
Date Available	2004-06-16 00:00:00
Creation Date	2004-06-14 17:15:11
Producing Software	Acrobat Distiller 6.0 (Windows)
Document Lastmod	2004-06-14 17:17:41
Document Title	Microsoft Word - GN-WIKG_EN.doc
Document Creator	PScript5.dll Version 5.2
Document Author:	lynn.yeh

GN-WIKG
IEEE 802.11b/g Wireless LAN Mini-PCI Card
User’s Manual
http://www.gigabyte.com.tw
Rev. 1.0 First Edition
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
"GIGABYTE declare that GN-WIKG (Wireless mini-PCI Module) is limited in CH1~CH11 by specified
firmware controlled in USA."
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and
users, and
2) The transmitter module may not be co-located with any other transmitter or antenna.
As long as 2 conditions above are met, further transmitter test will not be required. However,
the OEM integrator is still responsible for testing their end-product for any additional
compliance requirements required with this module installed (for example, digital device
emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain
laptop configurations or co-location with another transmitter), then the FCC authorization is
no longer considered valid and the FCC ID can not be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be
installed such that 20 cm may be maintained between the antenna and users (for
example :AP/Router/Motherboard). The final end product must be labeled in a visible area
with the following: JCK-GN-WIKG
Manual Information That Must be Included
The OEM integrator has to be aware not to provide information to the end user
regarding how to install or remove this RF module in the users manual of the end
product which integrate this module.
The users manual for OEM integrators must include the following information in a prominent location
“ IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this
transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be
co-located or operating in conjunction with any other antenna or transmitter.
Contents
CHAPTER 1. PRODUCT OVERVIEW
1-1.
1-2.
1-3.
1-4.
INTRODUCTION ...........................................................................................................1
FEATURES .................................................................................................................1
PHYSICAL DIMENSIONS/PACKAGING .............................................................................1
SYSTEM REQUIREMENTS ............................................................................................2
CHAPTER 2. INSTALLING THE WLAN CARD
2-1.
2-2.
2-3.
2-4.
2-5.
INSTALLING THE WIRELESS MINI-PCI ADAPTER ............................................................3
DRIVER & UTILITY INSTALLATION - WINDOWS® 98SE ....................................................4
DRIVER & UTILITY INSTALLATION - WINDOWS® ME .......................................................8
DRIVER & UTILITY INSTALLATION - WINDOWS® 2000...................................................12
DRIVER & UTILITY INSTALLATION - WINDOWS® XP ......................................................17
CHAPTER 3 USING THE GIGABYTE WLAN
CONFIGURATION UTILITY
3-1.
3-2.
3-3.
3-4.
3-5.
3-6.
21
THE PROFILE TAB ....................................................................................................21
THE LINK STATUS TAB ..............................................................................................28
THE SITE SURVEY TAB .............................................................................................29
“STATISTICS” SETTING ..............................................................................................30
THE ADVANCED TAB .................................................................................................31
THE ABOUT TAB .......................................................................................................32
CHAPTER 4 TROUBLESHOOTING
33
CANNOT ENABLE 802.1X, WPA OR WPA-PSK..........................................................33
CANNOT ESTABLISH CONNECTION TO A WIRELESS NETWORK ......................................33
CAN CONNECT TO AN ACCESS POINT, BUT CANNOT ACCESS THE INTERNET .................33
POOR LINK QUALITY AND WEAK SIGNAL STRENGTH ....................................................33
CHAPTER 5 HARDWARE SPECIFICATIONS
34
Chapter 1. Product Overview
1-1. Introduction
This 802.11b/g Wireless Local Area Network (WLAN) card is composed of the MAC,
Baseband, and radio components, Mini-PCI interface, and two built-in antennas. It
operates in 2.4GHz frequency bands, providing fast (up to 54Mbps) and secure (support
AES, 802.1x & WEP and WAP) connections to 802.11b and 802.11g networks from a
single card.
1-2. Features
Conforms to 802.11b/802.11g specification.
Transmits data rate up to the maximum speed of 54Mbps.
Dynamically scales the data rate.
Automatic power management to reduce battery consumption.
Built-in diversity antenna.
Seamless roaming between 802.11b and 802.11g networks.
Supports AES (Advance Encryption System), enterprise-class 802.1x security and
multiple levels of WEP encryption (64-bit /128-bit), and WPA (Wi-Fi Protected
Access)..
Driver supports Windows 98SE/Me/2000/XP.
1-3. Physical Dimensions/Packaging
Dimensions: 59mm* 44mm* 4mm
Please check that the package contents include:
•
•
GN-WIKG Wireless Mini-PCI Adapter
GN-WIKG Installation CD with Windows Drivers
In case of damaged or missing package contents, please contact your local distributor or
authorized reseller immediately. Should you require returning the product, please include
all original packing materials or the warranty will be voided.
1-4. System Requirements
•
IBM PC/AT compatible computer
•
Windows® 98SE/Me/2000/XP
Chapter 2. Installing the WLAN Card
This chapter will assist you in completing the hardware and software installation of the
GN-WIKG Wireless Mini-PCI Adapter successfully. Please refer to the driver & utility
installation section that matches your operating system.
2-1. Installing the Wireless Mini-PCI Adapter
Step 1: Turn off your PC and disconnect the power cord.
Step 2: Remove the PC cover.
Step 3: Locate an available Mini-PCI slot and remove its back plate from the PC chassis.
Step 4: Insert the GN-WIKG Mini-PCI Adapter into the slot and fasten it to the chassis
using the screws in step 3.
Step 5: Power on your desktop PC.
2-2. Driver & Utility Installation - Windows® 98SE
Step 1: When the Add New Hardware Wizard screen appears, click Cancel to exit.
Step 2: Insert the GN-WIKG Installation CD into the CD-ROM drive. The GIGABTYE
GN-WIKG Wireless Mini-PCI Adapter setup screen appears.
Step 3: Drag your mouse over Install Wireless LAN Utility and click on it to start the
utility installation program.
Step 4: When the Welcome screen appears, click Next.
Step 5: The Check Setup Information screen displays the Operating System of your
computer. If it is correct, click Next to continue.
Step 6: An information box screen appears. Click OK to go to the next screen.
Step 7: After the software utility installation is complete, click Finish. You are now
ready to install 802.1x authentication software.
Step 8: Drag your mouse over Browse the CD and click on it.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Encryption                      : Standard V1.2 (40-bit)
User Access                     : Print, Copy, Fill forms, Extract, Assemble, Print high-res
Modify Date                     : 2004:06:14 17:17:41+08:00
Create Date                     : 2004:06:14 17:15:11+08:00
Title                           : Microsoft Word - GN-WIKG_EN.doc
Author                          : lynn.yeh
Creator                         : PScript5.dll Version 5.2
Producer                        : Acrobat Distiller 6.0 (Windows)
Page Count                      : 10
Mod Date                        : 2004:06:14 17:17:41+08:00
Creation Date                   : 2004:06:14 17:15:11+08:00
Metadata Date                   : 2004:06:14 17:17:41+08:00
Has XFA                         : No

EXIF Metadata provided by EXIF.tools