User Manual
User Guide_Hardware Component GVCI component User Guide_Hardware GVCIUnlock Unlock Button External Port Bluetooth Button Unlocks GVCI from OBD-II II connector Communication port for Tablet PC (Optional) Enables Bluetooth mode ◈GVCISpecification Specification Item Specifications Micro Controller ARM 32-bit Cortex™-M4 / 180MHz 0MHz System Memory Flash Memory 2Mbyte / SRAM 256 256KByte Operating Voltage 7~30VDC User Guide_Hardware Operating Temperature Storage -10℃ ~ 50℃ (14℉ ~ 122℉)) : Wireless LAN Mode -10℃ ~ 55℃ (14℉ ~ 131℉)) : USB Mode -20℃ ~ 80℃ (-4℉ ~ 176℉ ℉) Noncondensing @ 0℃ ~ 10℃ (32℉ ℉ ~ 50℉) Operating Relative Humidity 95%RH @ 10℃ ~ 30℃ (50℉ ~ 86 86℉) 70%RH @ 30℃ ~ 55℃ (86℉ ~ 131 131℉) Storage Noncondensing @ -20℃ ~ 80℃ (-4℉ ℉ ~ 176℉) Operating Mode Diagnosis Function / Flight Record Function Current Consumption Typical 100mA @12V Housing ABS Dimension 58 X 74 X 36 mm Weight 90g Interface Item Specifications Wire Protocol USB 2.0 Full Speed via 30-pin pin Connection Wireless Protocol Bluetooth 2.1 (2.4GHz ) Indication Lamps 1 LEDs(Front) Input Devices Input key GVCI (G-scan tab Vehicle Communication Interface) Item Specifications CAN CAN (High Speed, Low Speed, Single Speed Speed) K-Line/L-Line ISO-9141, ISO-9141-CARB, KWP-2000 2000 Commercial Vehicle SAE-J1708/J1587,J1850(VPWM,PWM) /J1587,J1850(VPWM,PWM) Data/Control Line Melco Pull-Down ◈GVCI LED Color Description [Blue on]: Connection in Ready status –GVCI GVCI Is not connected with G-scan Tab [Blue flashing]: ]: GVCI is connected with G-scan Tab User Guide_Hardware [Green flashing]: Vehicle communication in process ◈How How to connect with vehicle Connect GVCI connector with OBD-II OBD port of vehicle. User Guide_Hardware Appendix Changes or modifications not expressly approved by the party responsible for complianceCould void the user’s user s authority to operate the equipment. This device complies with part 15 of the FCC Rules.Operation is su subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may causeundesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable User Guide_Hardware protection against harmful interference in a residential installation. This This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following ollowing measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced perienced radio/TV technician for help. Indication of any restrictions of use This equipment was restricted to indoor use. Indication of the countries where the equipment is intended to bo used This equipment may be operated in AT, BE, CY, CZ, DK, EE, FI, FR, DE, GR, HU, IE, IT, LV, LT, LU, MT, NL, PL, PT, SK, SI, ES, SE, GB, IS, LI, NO, CH, BG, RO, TR This product is CE marked according to the provision of the RED( 2014/53/EU). Here by G.I.T co., Ltd.. declares that this product in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU WEEE (Waste Electrical and Electronic Equipment) symbol shown in [Figure 1] is indicated on the back of the VCI main module, VMI main module, and Trigger module. Please follow the regulation guide for disposal of Waste Electrical and Electronic Equipment. Use caution disposing of the Trigger module; it contains a lithium battery. Users must follow the regulations when replacing or discarding this battery. User Guide_Hardware Fig. 1. WEEE Symbol Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, oduct, please contact your local city office, your household waste disposal service or the shop where you purchased the product.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No Page Count : 7 Page Mode : UseNone Creator : Microsoft Word - ◆G-scan Tab_ Hardware_20160922_[[영문]] Producer : NesPDF Create Date : 2016:10:18 17:18:43+09:00 Modify Date : 2016:10:18 17:18:43+09:00 Author : hws Title : Microsoft Word - ◆G-scan Tab_ Hardware_20160922_[[영문]]EXIF Metadata provided by EXIF.tools