GUARDIAN PTX01-CC Remote for Garage Door Opener User Manual P3B pub
GUARDIAN SHANGHAI CORP. Remote for Garage Door Opener P3B pub
GUARDIAN >
Users Manual
Guardian Shanghai Corp. 368,MInShen Rd, Song Jiang, Shanghai, China,201612
To Program Remote Control(s):
1. See Fig.2 to add a Remote Control. Press the “LEARN”
button on the rear control panel of the Opener. The
courtesy light will illuminate with an audible click*. The
unit is now ready to learn a Remote Control.
2. Within 30 seconds, press the button on the Remote
Control.
3. The courtesy light will flash twice indicating Remote
Control has been stored successfully**.
Up to 20 Remote Controls (including wireless keypad codes)
can be added to the unit by repeating the above procedures.
If more than 20 Remote Controls are stored, the first stored
Remote Control will be replaced. (i.e. the 21st Remote Con-
trol replaces the 1st stored Remote Control.)
* If the courtesy light is already on, it will flash once and stay
illuminated for 30 seconds.
** If a Remote Control is not accepted, the courtesy light will
stay on for 30 seconds, flash 4 times and then stay on for 4-
1/2
minutes. Retry programming the Remote Control by repeat-
ing the steps above.
Removing ALL Remote Controls:
To remove ALL Remote Controls from memory, press and
hold the “LEARN” button for 5 seconds. The courtesy light
will flash 7 times indicating ALL Remote Controls have been
removed from memory.
Replacing Remote Control Battery:
When the battery of the hand held Remote Control is low,
the indicator light will become dim and/or the range of the
Remote Control will diminish. To replace the battery, remove
the battery cover from the Remote Control as shown in Fig 3.
Replace with two CR2016 6 volt alkaline batteries with po-
larity
Fig.1
This device complies FCC Rules for HOME OR OFFICE USE. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any Changes or
modification not expressly approved by the party responsible for compliance
could void the user’s authority to operate equipment.
x2
Fig.2
LEARN
30
Visor Clip
User Manual