GUARDIAN WKTX01-CC Wireless Keypad CC User Manual wkcc 17 6 13 pub
GUARDIAN SHANGHAI CORP. Wireless Keypad CC wkcc 17 6 13 pub
GUARDIAN >
Users Manual
Guardian Shanghai Corp. 368,MInShen Rd, Song Jiang, Shanghai, China,201612
To Add Personal Codes:
1. Press/Release the “LEARN” button on the rear control
panel, courtesy light will glow# or “OK” LED will glow and
beep*. The unit is now ready to accept a transmitter in
the next 30 seconds as shown in Fig.1.
2. Enter 2 - 6 digit(s) personal code on the Keyless Entry
within 30 seconds and press/release button.
3. Courtesy light will flash twice# or “OK” LED will flash and
beep twice* indicating personal code is stored in
memory.
Up to 20 personal codes (including 1-button transmitters) can
be added to the unit by repeating the above procedures.
If more than 20 personal codes are stored, the previously
stored one from the very beginning will be replaced, i.e. the
21st transmitter replaces the 1st stored one.
Operation:
To access the door, enter a pre-stored personal code and press
to transmit code, and within 20s, the button can
be used to stop or reverse the door.
If the code is entered incorrectly, correction can be made by
pressing to reset and re-enter code.
When dark, may be pressed in advance to turn on back
light.
Removing ALL Personal Code(s):
To remove ALL personal code(s) and/or transmitters from
memory, press and hold the “LEARN” button for 5 seconds.
Courtesy light will flash or “OK” LED will flash and beep,
indicating ALL codes/transmitters have been removed from
memory.
# For units with AC motor
*For units with DC motor
Fig.2
Fig.1
User Manual
Mounting the Keyless Entry:
Keyless Entry may be secured on door jamb face outside your
garage. Refer to Fig.2, locate the Keyless Entry within sight of
door at minimum height of 5 feet (1.5m), ensure it is away from
reach of children and moving parts of door and hardware. Test
the reception of the Keyless Entry before mounting. Change
location for better reception if necessary.
Use the mounting holes on the Keyless Entry as template to mark
position on the mounting surface. On wooden use the screws
provided. In case of drywall surface, drill holes and use drywall
anchors provided.
Replacing Keyless Entry Batteries:
When the battery of Keyless Entry is low, dimmed illumination is
observed. To replace batteries, remove the battery cover, replace
the batteries with (2) 1.5V AAA alkaline batteries.
1
2
3
(2)
Model : WKCC
This device complies FCC Rules for HOME OR OFFICE USE. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modification not expressly approved by the party responsible
for compliance could void the user’s authority to operate equipment.