Garmin Canada HRM1 Telemetry Device User Manual INSTRUCTION SHEET manual HRM1 2

Manual

Wearing the HRM1 Heart Rate Monitor

Wear the HRM1Heart Rate Monitor directly on your skin, slightly below your breastbone. Wetting both sensors on the

back of the Heart Rate Monitor will result in optimum capture of heart rate pulses (wet with water or biogel). The strap

should fit snugly enough to remain in place during your exercise session. Proper placement of the Heart Rate Monitor is

also important for optimum capture of heart rate pulses.

Pairing the HRM1 Heart Rate Monitor with a Sports Monitoring Watch

The HRM1Heart Rate Monitor must “pair” with an ANT-enabled Sports Monitoring Watch in order to display Heart Rate

data to the user. To do this:

• Bring the HRM1Heart Rate Monitor within 10-30 inches (25-75cm) of the Sports Monitoring Watch

• Be sure to stand at least 72 inches (183cm) away from any other ANT-enabled Heart Rate Monitor

• You can be in proximity to other ANT-enabled devices

• After the HRM1Heart Rate Monitor pairs with the Sports Monitoring Watch, the heart rate icon should appear on

the watch and you may also be in proximity to other ANT-enabled devices

Specifications:

Size (max dimensions): 347 x 42 x 22mm (W x H x D)

Weight: 29g

Strap: Detachable adjustable elastic strap, 425-641mm (L)

Power: Single user-replaceable CR-2032 battery

Battery life: 3 years assuming use of 1 hr/day at 20°C

Storage temp: -20°C to +70°C

Operating temp: -10°C to +50°C

User-interface: Auto on/off

RF frequency/protocol: 2.4 GHz / Dynastream ANT transmit protocol

Communication range: > 3 m (receiver dependent)

Regulatory compliance: FCC, IC, and CE ready

FCC Compliance

Part 15 of FCC Interference Limits for Class B Digital Devices

The HRM1 complies with Part 15 of FCC Interference Limits for Class B Digital Devices. Documents are on file with the

FCC.

Section 21 - Emission of Radio Frequency Energy

The HRM1 complies with FCC Section 21 - Emission of Radio Frequency Energy. Documents are on file with the FCC.

Operational Conditions

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device

may not cause harmful interference, and (2) this device must accept any interference received, including interference that

may cause undesired operation. Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.