Garmin 01633 LOW POWER COMMUNICATIONS TRANSMITTER User Manual
Garmin International Inc LOW POWER COMMUNICATIONS TRANSMITTER Users Manual
Garmin >
Users Manual
ecoRoute ESP Instructions................................................................... 2 ecoRoute ESP Instructions in French.................................................. 4 190-01132-91_0A.indd 1 9/14/2009 12:18:24 PM ecoRoute ESP Instructions RESET key The ecoRoute™ ESP device connects to your vehicle’s OBD II (On-Board Diagnostics) connector. The ecoRoute ESP device sends data wirelessly to a compatible Garmin GPS device. LED OBD II Connector Location Cable ties The location of the OBD II connector varies for each vehicle. For the best view of the connector, open the driver door and kneel. The following are common locations in which to look for the OBD II connector: ecoRoute ESP device Customizing the Cable Angle If the vehicle requires the cable to be at an angle from the connector, you can use the cable ties to customize the cable for the installation. 1. Bend the cable around the connector to suit the installation. 2. Use a cable tie to secure the cable to the connector to fit a Cable Secured variety of installation situations. to the Connector OBD II Connector • The OBD II connector is often below the steering column, between the center console and the driver’s door. • The OBD II connector might be under a labeled cover. Remove or open the cover to access the connector. • The OBD II connector might be under or behind the ash tray or near the power outlet in the center console. Wirelessly Connecting with a Garmin GPS Device Before wirelessly connecting to a GPS device, you must install the ecoRoute ESP device. Installing the ecoRoute ESP Device 1. Start the vehicle. The LED turns green when the ecoRoute ESP device is communicating with your vehicle. 2. Turn on the GPS device. 3. Bring the GPS device within 10 meters (33 feet) of the ecoRoute ESP device. 4. From the Tools menu, touch ecoRoute > ESP Connection. The LED turns blue when the ecoRoute ESP device is connected to your GPS device. Warning When installing the device in a vehicle, install the device securely so it does not interfere with the vehicle operating controls, such as the foot pedals. Interfering with the vehicle operating controls can result in an accident, which could result in injury or death. Before installing the ecoRoute ESP device, you must find the OBD II connector in your vehicle. 1. Connect the ecoRoute ESP connector to the OBD II connector in the vehicle. About the Wireless Connection to the GPS Device The ecoRoute ESP device and the GPS device automatically connect when they are turned on and are within 10 meters (33 feet) of each other. ecoRoute ESP connector Vehicle OBD II connector 2. Use the cable ties to secure the ecoRoute ESP device and cable to the vehicle. When it is not connected to a GPS device, the ecoRoute ESP device records the vehicle information and sends the data to the GPS device the next time they connect. 190-01132-91_0A.indd 2 9/14/2009 12:18:26 PM Viewing ecoRoute ESP Data different circuit from the GPS unit. • Consult the dealer or an experienced radio/TV technician for help. This product does not contain any user-serviceable parts. Repairs should only be made by an authorized Garmin service center. Unauthorized repairs or modifications could result in permanent damage to the equipment, and void your warranty and your authority to operate this device under Part 15 regulations. On your GPS device, touch Tools > ecoRoute. About the LEDs The LED on the top of the ecoRoute ESP device indicates the connection status: LED Green flashing Green solid Blue solid Meaning Connecting to the vehicle. Communicating with the vehicle. Communicating with the vehicle and a GPS device. Industry Canada Compliance Category I radiocommunication devices comply with Industry Canada Standard RSS-210. Category II radiocommunication devices comply with Industry Canada Standard RSS-310. Resetting the ecoRoute Device Reset the ecoRoute device if it stops functioning. • Press and release the Reset key to rest the device. • Press and hold the Reset key for 3 seconds to restore the factory settings. Note: When restoring the factory settings, the wireless connection information and recorded vehicle information will be deleted. Declaration of Conformity FCC Compliance California Notices Hereby, Garmin, declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. To view the full Declaration of Conformity, go to www.garmin.com /declaration-of-conformity. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The California Electronic Waste Recycling Act of 2003 requires the recycling of certain electronics. For more information on the applicability to this product, see www.erecycle.org. Warning This product, its packaging, and its components contain chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. This notice is provided in accordance with California’s Proposition 65. See www.garmin.com/prop65 for more information. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and may cause harmful interference to radio communications if not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: Limited Warranty Garmin’s standard limited warranty applies to this accessory. For more information, see the Important Safety and Product Information in the Garmin GPS device box. • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Connect the equipment into an outlet that is on a 190-01132-91_0A.indd 3 9/14/2009 12:18:26 PM ecoRoute ESP Instructions in French 190-01132-91_0A.indd 4 9/14/2009 12:18:26 PM 190-01132-91_0A.indd 5 9/14/2009 12:18:26 PM Garmin® and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. ecoRoute™ is a trademark of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express permission of Garmin. For the latest free software updates (excluding map data) throughout the life of your Garmin products, visit the Garmin Web site at www.garmin.com. © 2009 Garmin Ltd. or its subsidiaries Garmin International, Inc. 1200 East 151st Street, Olathe, Kansas 66062, USA Garmin (Europe) Ltd. Liberty House, Hounsdown Business Park, Southampton, Hampshire, SO40 9LR UK Garmin Corporation No. 68, Jangshu 2nd Road, Shijr, Taipei County, Taiwan www.garmin.com October 2009 190-01132-91_0A.indd 6 Part Number 190-01132-91 Rev. A Printed in Taiwan 9/14/2009 12:18:26 PM
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes Tagged PDF : Yes XMP Toolkit : 3.1.1-111 About : 80fb6756-a57d-11da-84bf-c376cc85d35c Create Date : 2009:09:14 12:18:24-05:00 Metadata Date : 2009:09:14 12:18:26-05:00 Modify Date : 2009:09:14 12:18:26-05:00 Creator Tool : Adobe InDesign CS2 (4.0.5) Thumbnail Format : JPEG Thumbnail Width : 256 Thumbnail Height : 256 Thumbnail Image : (Binary data 3226 bytes, use -b option to extract) Instance ID : uuid:266b5a1f-f1fe-4375-83a1-b48a24c78608 Document ID : adobe:docid:indd:54088c37-a151-11de-8abb-f821ee815779 Rendition Class : proof:pdf Derived From Instance ID : afe1af45-a14f-11de-8032-df8fcd1c6926 Derived From Document ID : adobe:docid:indd:afe1af43-a14f-11de-8032-df8fcd1c6926 Manifest Link Form : ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream Manifest Placed X Resolution : 72.00, 246.19, 268.25, 247.33, 247.33, 267.75, 267.75, 72.00, 72.00 Manifest Placed Y Resolution : 72.00, 246.19, 268.25, 247.33, 247.33, 267.75, 267.75, 72.00, 72.00 Manifest Placed Resolution Unit : Inches, Inches, Inches, Inches, Inches, Inches, Inches, Inches, Inches Manifest Reference Instance ID : uuid:E2D274F06C55DD11B659DC6B3AA69CE3, uuid:7476D3724FA1DE11959CCCFD0F8296A8, uuid:7D28029B4F92DE11B8CDB87A17ED4D1D, uuid:7C41255D4FA1DE11B4BAF086ECD54EEB, uuid:7C41255D4FA1DE11B4BAF086ECD54EEB, uuid:E6264A1CA08DDE11B7EAFDBE5EDE014A, uuid:E6264A1CA08DDE11B7EAFDBE5EDE014A, uuid:7CC6B2727055DD11B22F90F22C99F3D5, uuid:de048344-7799-46d2-a182-113d0e6870f0 Manifest Reference Document ID : uuid:E1D274F06C55DD11B659DC6B3AA69CE3, uuid:5FDC00634FA1DE11959CCCFD0F8296A8, uuid:7C28029B4F92DE11B8CDB87A17ED4D1D, uuid:95FC1D404FA1DE11B4BAF086ECD54EEB, uuid:95FC1D404FA1DE11B4BAF086ECD54EEB, uuid:E5264A1CA08DDE11B7EAFDBE5EDE014A, uuid:E5264A1CA08DDE11B7EAFDBE5EDE014A, uuid:7BC6B2727055DD11B22F90F22C99F3D5, uuid:A7D6D30B435CDE11B0FBA87E98C8B9AF Format : application/pdf Producer : Adobe PDF Library 7.0 Trapped : False Page Count : 6 Creator : Adobe InDesign CS2 (4.0.5)EXIF Metadata provided by EXIF.tools