Garmin 02564 Low Power Transmitter 2402-2480 MHz User Manual

Garmin International Inc Low Power Transmitter 2402-2480 MHz

UserManual.wiki >

02564 User Manual >

Contents

1. User Manual
2. User Manual 1

User Manual

Quick Start ManualApril 2015 Printed in Taiwan 190-01844-91_0ADRAFT

Introduction WARNINGSee the Important Safety and ProductInformation guide in the product box forproduct warnings and other importantinformation.Always consult your physician before youbegin or modify any exercise program.Charging the DeviceNOTICETo prevent corrosion, thoroughly dry theUSB port, the weather cap, and thesurrounding area before charging orconnecting to a computer.The device is powered by a built-in lithium-ion battery that you can charge using astandard wall outlet or a USB port on yourcomputer.NOTE: The device will not charge whenoutside the approved temperature range(page 9).1Pull up the weather cap À from theUSB port Á.2Plug the small end of the USB cableinto the USB port on the device.3Plug the large end of the USB cableinto an AC adapter or a computer USBport.4Plug the AC adapter into a standardwall outlet.When you connect the device to apower source, the device turns on.5Charge the device completely.Installing the Standard MountFor the best GPS reception, position themount so the front of the device isoriented toward the sky. 1Select a secure location to mount thedevice where it does not interfere withsafe operation.2 IntroductionDRAFT

2Place the rubber disk À on the back ofthe mount.The rubber tabs align with the back ofthe mount so it stays in place.3Place the mount on the product.4Attach the mount securely usingthe two bands Á.5Align the tabs on the back of thedevice with the mount notches Â.6Press down slightlyuntil it locks into place..Installing the Other Mount1Select a secure location to mount theother device where it does notinterfere with the safe operation.2Use the hex key to remove the screwÀ from the connector Á.3If necessary, remove the two screwson the back side of the mount Â,rotate the connector Ã, and replacethe screws to change the orientation ofthe mount.Introduction 3DRAFT

4Place the rubber pad around theproduct:• If the diameter is25.4 mm, use the thicker pad.• If the diameter is31.8 mm, use the thinner pad.5Place the connector aroundthe rubber pad.6Replace and tighten the screw.NOTE: Garmin® recommends a torquespecification of 7 lbf-in. (0.8 N-m). Youshould check the tightness of thescrew periodically.7Align the tabs on the back of the otherdevice with the mount notches Ä.8Press down slightly until it locks into place..KeysÀ Select to adjust the backlightbrightness.Hold to turn the device on andoff.ÁSelect to scroll through the datascreens, options, and settings.From the home screen, select toview the connections page.ÂSelect to scroll through the datascreens, options, and settings.From the home screen, select toview the device menu.ÃSelect to mark a new lap.4 IntroductionDRAFT

1Pull up the weather cap À from theUSB port Á.2Plug the small end of the USB cableinto the USB port on the device.3Plug the large end of the USB cableinto a computer USB port.4Go to www.garminconnect.com/start.5Follow the on-screen instructions..6 IntroductionDRAFT

Notifications: Displays notifications and messages on yourdevice.SensorsYour device can be used with wirelesssensors. For more informationabout compatibility and purchasingoptional sensors, go to http://buy.garmin.com.Putting On the Heart Rate MonitorNOTE: If you do not have a heart ratemonitor, you can skip this task.You should wear the heart rate monitordirectly on your skin, just below yoursternum. It should be snug enough to stayin place during your activity.1Snap the heart rate monitor module Àonto the strap.The Garmin logos on the module andthe strap should be right-side up.2Wet the electrodes Á and the contactpatches Â on the back of the strap tocreate a strong connection betweenyour chest and the transmitter.3Wrap the strap around your chest, andconnect the strap hook Ã to the loopÄ.NOTE: The care tag should not foldover.The Garmin logos should be right-sideup.4Bring the device within 3 m (10 ft.) ofthe heart rate monitor.After you put on the heart rate monitor, it isactive and sending data.ANT+ Sensors 7DRAFT

.Device InformationTemperature SpecificationsOperating temperature range:From -20º to 60ºC (from -4º to 140ºF)Charging temperature range: From0º to 45ºC (from 32º to 113ºF)Getting More Information• Go to www.garmin.com/intosports.• Go to www.garmin.com/learningcenter.• Go to http://buy.garmin.com, or contactyour Garmin dealer for informationabout optional accessories andreplacement parts.Getting the Owner's ManualYou can get the most recent owner'smanual from the web.1Go to www.garmin.com/manuals/.2View or download the full owner'smanual in your preferred format.Device Information 9DRAFT

DRAFT

DRAFT

Navigation menu