Ge Appliances Pedestrian Signals Installation Guide LED Transportation Traffic Signal Lighting Modules GT1 16x18inch Incandescent Install |

Ge-Pedestrian-Signals-Installation-Guide-649811 ge-pedestrian-signals-installation-guide-649811

: Ge-Appliances Ge-Pedestrian-Signals-Installation-Guide-649811 ge-pedestrian-signals-installation-guide-649811 ge-appliances pdf

Open the PDF directly: View PDF .
Page Count: 2

Installation Instructions

GT1TM LED Pedestrian 16x18’’ Incandescent Look

Signal Modules / PS7-CFF1-46A-J & PS7-CFF1-26A-J

Full Hand/Person Overlay/Countdown

Installation Steps:

1. Verify input voltage is within specified range on the back of the LED signal module before

installation. Failure to do so will cause lamp to fail.

2. Open front cover of (customer supplied) traffic signal housing.

3. Connect the wires to the appropriate terminal block within customer supplied signal housing.

(Orange wire (+ for Hand), Blue Wire (+ for Person) and White wire (for the neutral).

4. Close front cover of (customer supplied) traffic signal housing ensuring that the module gasket is

tight within the housing.

…Page 2

Back of 16 x 18 inch Pedestrian Module

Risk of Electric Shock

Install unit in enclosure tested to

be suitable for wet locations only.

Voltage Rating

Blue Wire White Wire Orange Wire

Countdown Option

Jumpers

(See next page)

16 x 18 inch Overlay / Countdown

Prepare Electrical Wiring

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Electrical Requirements

 Do not use in wet locations

 Follow all National Electric Codes

(NEC) and local codes.

Installation Instructions (cont’d)

GT1TM LED Pedestrian 16x18’’ Incandescent Look

Signal Modules / PS7-CFF1-46A-J & PS7-CFF1-26A-J

STEP A

To Test Countdown

Note: Module does not need to be disconnected from terminal block.

1. Remove Cap from "CONNECT TO TEST"

2. Connect jumper wire using appropriate screws.

3. Re-install Cap over jumper location

To Stop Testing Countdown

1. Remove Cap from "CONNECT TO TEST"

2. Disconnect jumper wire and store it for future use (as shown on Figure A).

3. Re-install Cap over jumper wire

STEP B

To Disable Countdown

Note: Module does not need to be disconnected from terminal block.

1. Remove Cap from "DISCONNECT TO DISABLE"

2. Remove jumper wire and replace screws for future use.

3. Re-install Cap over jumper location

To Re-Enable Countdown

1. Remove Cap from "DISCONNECT TO DISABLE"

2. Re-install jumper wire using appropriate screws (as shown on Figure B).

3. Re-install cap over jumper wire.

Risk of Electric Shock

Install unit in enclosure tested

to be suitable for wet locations

only.

Step B:

Disconnect Jumper

wire to Disable

Countdown

Step A:

Connect Jumper

wire to Test

Countdown

Fig. A

Fig. B

GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com

1 - 8 8 8 - 6 9 - 4 3 - 5 3 3

GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. GT1 is a trademark of GE Lighting Solutions, LLC. The GE brand and logo are trademarks of the

General Electric Company. © 2010 GE Lighting Solutions, LLC. Information provided is subject to change without notice. All values are design or typical values when

measured under laboratory conditions.

TRAF059-R120110