Gemalto 300GEL Card Reader User Manual manual MES300GEL

Manual extract

FCC ID: MES300GEL

1 USER MANUAL

This is a copy of the 2nd page where the FCC statement is included :

Regulatory Information

Notice for the USA: FCC Statement

Federal Communications Commission (FCC) Radio Frequency Interference Statement (USA Only)

This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part

15 of FCC Rules. These limits are designed to provide reasonable protections against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try one of more of the following measures:

à Relocate the radio or television antenna.

à Plug the equipment away from the radio or television.

à Plug the equipment into a different electrical outlet, so that the equipment and the radio or television are on

separate electrical circuits.

à Make sure that all your peripheral devices ar also FCC Class B certified.

à Make sure you use only shielded cables to connect peripheral devices to your equipment.

à Consult your equipment dealer, or an experienced radio / television technician for help.

WARNING: The system verification tests were conducted with GEMPLUS supported peripheral devices and

GEMPLUS shielded cables, such as those you received with your system. Cables used with this equipment must

be properly shielded to comply with the requirements of the FCC.

Changes or modifications not expressly approved by GEMPLUS could void the user's authority to operate the

equipment.

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions :

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.