Genbyte Technology GBBLE01-NRF52 BLE Module User Manual

Download:
Mirror Download [FCC.gov]
Document ID	3868210
Application ID	ZbdXcfJd0Z9xH4SHMRnMpQ==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	39.09kB (488564 bits)
Date Submitted	2018-05-30 00:00:00
Date Available	2018-05-30 00:00:00
Creation Date	2018-05-16 11:15:58
Producing Software	doPDF Ver 7.1 Build 351 (Windows 7 Ultimate Edition (SP 1) - Version: 6.1.7601 (x64))
Document Lastmod	2018-05-29 21:02:35
Document Title	User Manual
Document Creator	(Jisupdf Editor)

GBBLE01-NRF5201 BLE Module
Genbyte Technology Inc.
GBBLE01-NRF5201 BLE Module Instructions
Version：V1.0
Date：Mar, 2018
Genbyte
Technology
Inc. Confidential
Page 1 of 7
GBBLE01-NRF5201 BLE Module
Genbyte Technology Inc.
GBBLE01-NRF5201 BLE Module
General Description
GBBLE01-NRF5201 is a powerful, multiprotocol,
ultra low power Bluetooth Low Energy (BLE)
module using Nordic nRF52832 SoC. With an ARM
Cortex TM M4F MCU, 512KB flash, 64KB RAM,
embedded 2.4GHz multi-protocol transceiver, and
an integrated chip antenna. It provide a comple
solution with no extral RF design, allows faster
time to market with reduced development cost.
Overview and Features

























Based on Nordic Semiconductor’s nRF52832 BLE SoC;
Complete RF solution with integrated antenna;
Multi-Protocol 2.4GHz Radio;
32-bit ARM Cortex M4F processor;
Serial Wire Debug (SWD);
Over-the-Air (OTA) firmware update;
Flash/RAM: 512KB/64KB:
11 General purpose I/O pins:
12 bit/200KSPS ADC;
SPI Master/Slave (8Mbps);
Low power comparator;
Two 2-wire Master/Slave (I 2 C compatible);
I2S audio interface;
UART (with CTS/RTS and DMA);
20 channel CPU independent Programmable Peripheral Interconnect (PPI);
Quadrature Demodulator (QDEC);
128-bit AES HW encryption;
5 x 32 bits, 3 x 24 bits Real Time Counters (RTC);
Internal RC Oscillator 32.768kHz;
Receiver Sensitivity: -96 dBm;
TX power: +/- 0dBm; programmable +4dBm to -20dBm in 4 dB steps;
Sizes: 16.5*15.3*2.7mm;
Integrated chip antenna;
Operation voltage: 1.7V to 3.6V;
Operation temperature: -40°C to +85°C;
Application:


IoT Connected Devices, Appliances;
Bluetooth Low Energy Sensors;
Genbyte
Technology
Inc. Confidential
Page 2 of 7
GBBLE01-NRF5201 BLE Module
Genbyte Technology Inc.





Wearable;
Beacons/Proximity;
Lighting products;
Home Automation and Control;
Toys and Gaming;
Mechanical Specification:
Genbyte
Technology
Inc. Confidential
Page 3 of 7
GBBLE01-NRF5201 BLE Module
Genbyte Technology Inc.
PIN Description:
Number
10
11
12
13
14
15
Signal Name
P0.11
P0.12
P0.13
SWDIO
SWDCLK
P0.17
P0.18
P0.21
GND
VDD
P0.26
P0.27
P0.28
P0.29
P0.30
Signal Description
Note
I/O
I/O
I/O
Debug and flash programming I/O
Debug and flash programming I/O
I/O
I/O
Reset/IO
Configurable as reset
Power Ground
Power Supply
I/O
I/O
ADC IN
ADC IN
ADC IN
GPIO Electrical Specification:
The module has up to 32 GPIOs available. All GPIOs can be mapped to a module,
facilitating design and enabling changes after the hardware has been configured. Each
GPIO is configurable with the following features:
 Input/output direction
 Output drive strength
 Internal pull-up and pull-down resistors
 Wake-up from high or low level triggers on all pins
 Trigger interrupt on all pins
 All pins can be used by the PPI task/event system; the maximum number of
pins that can be interfaced through the PPI at the same time is limited by the
number of GPIOTE channels
 All pins can be individually configured to carry serial interface or quadrature
demodulator signals
HW debug and flash programming of Module :
The module support the two pin Serial Wire Debug (SWD) interface and offers
flexible and powerful mechanism for non-intrusive debugging of program code.
Breakpoints, single stepping, and instruction trace capture of code execution flow are
part of this support.
Pin
SWDIO
SWCLK
Genbyte
Flash Program interface
Debug and flash programming I/O
Debug and flash programming I/O
Technology
Inc. Confidential
Page 4 of 7
GBBLE01-NRF5201 BLE Module
Genbyte Technology Inc.
Recommended Operating Conditions:
Parameter
Operating Supply Voltage
Operating Temperature Range
Symbol
VCC
Top
Min
1.7
-40
Typical
3.0
25
Max
3.6
85
Unit
℃
Radio Specifications:
Parameter
MIN
2402
-20
MAX
2480
+1.50
-96
250kbps, 1Mbps, 2Mbps
Frequency Range
Channel Spacing
Output Power
Receiver Sensitivity - BLE
Data Rate
TYP
UNITS
MHz
MHz
dBm
dBm
Absolute Maximum Ratings:
Parameter
Supply Voltage
Storage Temperature Range
RF Signal Input Level
VI/O, VDD ≤ 3.6 V
VI/O, VDD > 3.6 V
Min
-0.3
-40
-0.3
-0.3
Max
3.9
125
10
VDD + 0.3V
3.9
Unit
℃
dBm
Recommended PCB Land Pattern:
Genbyte
Technology
Inc. Confidential
Page 5 of 7
GBBLE01-NRF5201 BLE Module
Genbyte Technology Inc.
For more information:
Manufacturer: Genbyte Technology Inc.
ADD: NO.4 Building, Huahong Xintong Industrial Park, Guangming New-district,
Shenzhen, China
FCC Caution:
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment .This equipment should be installed and operated with
minimum distance 20cm between the radiator& your body.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.aanantenna or transmitter. tenna or transmitter.
This module is intended for OEM integrator. The OEM integrator is still responsible for
the FCC compliance requirement of the end product, which integrates this module.
The final end product must be labeled in a visible area with the following “Contains
FCC ID: 2AMRBGBBLE01-NRF52” and the frequency can’t be changed by end users.
Genbyte
Technology
Inc. Confidential
Page 6 of 7
GBBLE01-NRF5201 BLE Module
Genbyte Technology Inc.
Important notice :
●Genbyte
Technology Inc. reserve the right to make corrections, enhancements,
improvements and other changes to its products.
●Buyer acknowledges and agrees that it is solely responsible for compliance with all
legal, regulatory and safety-related requirements concerning its products.
●Reserves the right to correct, modify, and/or improve products and/or specifications
without notice.
ATTENTION !
Electrostatic Sensitive Device
Observe Precaution for handing.
Rev
V1.0
Reversion History
Issued by
Checked by
Li Zhang
Leon
Genbyte
Technology
Inc. Confidential
Approved by
Jiaxiang Zeng
Page 7 of 7

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Create Date                     : 2018:05:16 11:15:58+08:00
Creator                         : (Jisupdf Editor)
ICN App Name                    : Jisupdf Editor
ICN App Platform                : Windows
ICN App Version                 : 2.00
Modify Date                     : 2018:05:29 21:02:35-07:00
XMP Toolkit                     : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26
Creator Tool                    : (Jisupdf Editor)
Metadata Date                   : 2018:05:29 21:02:35-07:00
Producer                        : doPDF Ver 7.1 Build 351 (Windows 7 Ultimate Edition (SP 1) - Version: 6.1.7601 (x64))
Format                          : application/pdf
Document ID                     : uuid:5944ec4a-44a1-41c4-be16-3296b585f7c6
Instance ID                     : uuid:b6678b94-3cb3-46a4-941b-f2762f3332d8
Page Layout                     : OneColumn
Page Mode                       : UseNone
Page Count                      : 7

EXIF Metadata provided by EXIF.tools