Grand Wing Servo Tech GWT-6A-72 Radio-Control Transmitter User Manual B1BDB4792D3139

Grand Wing Servo-Tech Co., Ltd. Radio-Control Transmitter B1BDB4792D3139

Users Manual

Download: Grand Wing Servo Tech GWT-6A-72 Radio-Control Transmitter User Manual  B1BDB4792D3139
Mirror Download [FCC.gov]Grand Wing Servo Tech GWT-6A-72 Radio-Control Transmitter User Manual  B1BDB4792D3139
Document ID549875
Application IDlXuW+U9WYR3IQPIuOZ36OQ==
Document DescriptionUsers Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize52.76kB (659511 bits)
Date Submitted2005-06-09 00:00:00
Date Available2005-06-09 00:00:00
Creation Date2005-05-25 11:19:09
Producing SoftwareAcrobat Distiller 6.0 (Windows)
Document Lastmod2005-06-02 17:58:22
Document Title
Document CreatorPScript5.dll Version 5.2
Document Author: Cathy

INTRODUCTION '
PVINS-t 096 -----
GWT-6A MANUA]
Thank you tor purchasing the GWS 6-Channel radio system. this unit have been designed and developed
using the latest manulacturing technologies and Incorporated with the tinest modern precision electronic
components,
GWS system are compatible with alt current FM-PPM radto control system.
Please read these instructions careluliy In order to obtarn sate operation and maximum pertormance tram
your GWS system,
TRANSMITTER SPECIFIC/171
Model Number : GWI-oA
Encoder : o-Cnannel
Frequency : 72MHZ
Modulation : FM-PPM
RF Output Power : Approximately 250mw
Current Drain : iOOmA
Power Source : 9.6V[t .2VthSSDmAh(AAA)
Ni-Mti Battery pack
Low Battery Indicator : Below eaquD turn to Red) Control Range : t.5mst0t5ms
TRANSMITTER LAYOUA
Elevator trim lever
(Mode l)
Throttle trim lever
(Mode 2)
Cite:Ftaa. Three porltlon
(witch (Mode l)
CH5:Landing gear switch
(Mode 2)
ElevaronMoae I]
throttle (Mode 2)
/ Rudder itlck
Power switch
In the upper position.
the power is turned on,
Displays the transmitter battery voltage.
rhrome tllllt IGVOl [Mode l]
Elevator trlm IeverlModo 2)
CH5:lanaing gear switch
(Mode l)
CH6:FIap, three position swltc
(Mode 2)
throtlte (Mode it?)
Elevatormoda 2)
lAlteron stick
Aileron trim lever
trainer Cord Jack
Servo Reversing Switches t
Switches lhat reverse the direction at operation at the serves.‘
the lower position rs normal ride and upper oolillon Is the
reverse side
Channel display Operating direction display
1. CH] 3. Ctis REV) : Reverse side
GWT-6A MANUAL
TRANSMITTE? T-éA (REAR PANEL)
Battery Cover
Use when repluclng the baflevy.
Sllde the cover downward wh||e
pressing the pan marked ”PUSH".
9.6V/550mAh(AAA]
Ni-MH cherv pack
l. Aileron 2. Elevator
©\ {Vlewed from me rear] \ Down
Down
— © @ Le" w” w @ ~ @ $7
A ,
r %%i e e ,
Left Right\
i .
‘ f' ‘ H
1 , e . Up
‘ © © M ® @
GED ”P L
\ (Mode 1] (Mode 2}
3. Throttle 4. Rudder
\ _\\ , _ ngh
i \ fl Cf HE“, Englne mrome lever @ © — Left
i " © ~ © © @ moves to he nwgh speed 6 ‘
f _ ~ ‘ side. "l ‘ ,
1 ( mm mm: J |Left RI h'
\ 4 / W Low 4R' _'
© ’ @ Ev: \, @ Engine ihvoflle lever © © '9h 1
0 7h | d \
Low L Low figs-es 0 9 Wm” GE ‘ ,
[Mode 1) [Mode 2] e ,
GWT-6A MANUAL
TRAINER FUNCTION
The trainer function is a very effective way for training students. To use it, the special trainer cord
[sold separately] is necessary
T. Match the servo reversing and trims of both radios.
2. Turn on the power switch of instructor transmitter and extend the antenna to its full length.
The student transmitter must be left off, then plug the trainer cord into both transmitters, the student
transmitter power indicator will automatically turn on.
3. When the trainer switch is not pressed, the Instructor has control, when the trainer switch is pressed,
control is transferred to the student.
AWarning : Never turn on the student transmitter power switch, it will cause interference
and a crash.
OUTPUT:
TX 9.6V DC / 60mA
RX 4.8V DC / 60mA
(1)
LVour GWT—éA radio system is shipped from the factory with
both the transmitter Ni-MH battery pack and wall charger. ‘7 Chargev
When charging the battery, place the switch in the OFF g _
'tion “7 TX: Transmitter
pOSI ' charging display
The LED on the battery charger should always be on during
the charging operating. Under normal conditions. It will
require approximately 15 hours to attain peak charge capacity.
Rx: Receiver charging
display
2.Charger for the power battery
Full charged time : TX9.6V TO~15 hours
Power battery 8.4V or 9.6V(750mAh) l.5~2 hours
-—— To transmitter
charging jack
AWarning : Do not use the charger for equipment
other than GWS.
Receiver battery packs
4.8V [Ni-Cd/Ni-MH]
OUTPUT:
TX 9.6‘! DC / 60mA
RX 10V DC / SOOmA
(2!
Charger
SERVO INSTAL
RX: Power battery
charging display
Servo Arm Retalnlng Screw
Wood screw H? $Sewo Arm / Horn
TX: Transmitter
charging display
Rubber ’
Grommet .- \'
Servo Eyelet 4-8 --- To transmltter
Servo Mount —\ k— Servo Case charging 100k
E Power battery packs
Servo Lead w/
7.2V~9. V N'-Cd '»
Connector 6 ( I /N|MH)
GWT-6A MANUAL
19 , r.’ . ,
SAME/B
ONIOFF Connect to Charger
C ONNE C , Swltctliamess for Charging
FOR ENGINE POWER fl
#_
—
Receiver
Antenna
FOR ELECTRIC POWER
Electronic Speed Controller
|C550 or 100
Receiver
GWR-bNII
PRECA UT
- Do not fly simultaneously on the same frequency.
- Extend the antenna to Its tull length, Always carry out a
range check prior to fight.
- Always turn the transmitter on first, then the receiver. When
you turn the system ott. always turn the receiver ott tirst
then transmitter. ’
This step is very important always follow this procedure.
If this procedure is not followed, Injury to yourself and
others as well as loss of control could occur.
Ni-Cd battery pack
4.8V~6V
Landing gear Channe assignment:
Brand
Charm; JR/SANWA FUTABA/Hi-tec
Rudder
CH] Throttle Aileron
CH2 Alleron Elevator
CH3 Elevator Throttle
CH4 Rudder Rudde
CH5 Landing gear Landing gear
CHé Flap Flap
NI-Cd battery pack
7.2V~9.6V
Alleron
Elevator
http:llwww‘gws.com.tw
153. Sec. 2, Datung Rd.. Shijr city Taipei 221, Taiwan, R,0.c.
TEL‘GBG 2-5692-6255 FAx:sss-z-ssez-sau~3
E-mar . a pe|@qws.cum.tw
International Trade Inqulry:export@gws.cum.tw
6 Grand Wing Servo-Tech Co., Ltd.
Grand Wing System U.S.A. Inc.
GWS USA, LLC.
138 5. Brent Circle. city or Industry. CA 91789-3050
TEL:909-594»Gwsg(4979) FAx:909-594-8051
USA lnquiry:usa@gws.com.lw
Worldwtdo Alter Servlce:BurvicthWmcome
D I] -13-JPG
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed an:
used in accordance with the instructions, may cause harmful interference to radio
communications. However , there is no guarantee that interference will not occur in a
particular installation. Ifthis equipment does cause harmful interference to radio ortelevisi
reception, which can be determined by turning the equipment off and on. the user is
encouraged to try to correct the interference by one of the following measures:
0 Reorieni or relocate the receiving antenna.
0 Increase the separation between the equipment and receiver.
0 Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
0 Consult the dealer or an experienced radio/TV technician for help.
WARNING
To assure continued compliance, (example -use only shielded interface cables when
connecting to computer or peripheral devices) any changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority to operate
this equipment.
This device complies with Part 15 ofthe FCC rules. Operation is subject to the following twc
conditions: (1) This device may not cause harmful interference. and (2) this device must _
acceptany interference received. including interference that may cause undesired
operation.
J J
GRAND WING SERVO-TECH CO., LTD.
153,SEC.!.DATUNG RD.,SHIJRCITY.
TAIPEI 221. TAlWAN, R.0.C.
TEENS-2415015155
FAX:B!G-2-8892-8342
http:l/www.qws.com.tw httD:IIwww.oranrlwmn mm in: n.m=|l'nvnnrtf/'v\nure Mm m.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Encryption                      : Standard V1.2 (40-bit)
User Access                     : Print, Copy, Fill forms, Extract, Assemble, Print high-res
Modify Date                     : 2005:06:02 17:58:22+08:00
Create Date                     : 2005:05:25 11:19:09+08:00
Page Count                      : 5
Has XFA                         : No
About                           : uuid:5cd6b4d1-b0e3-4631-9e96-6e425e28075f
Producer                        : Acrobat Distiller 6.0 (Windows)
Mod Date                        : 2005:06:02 17:58:22+08:00
Creation Date                   : 2005:05:25 11:19:09+08:00
Author                          : Cathy
Creator Tool                    : PScript5.dll Version 5.2
Metadata Date                   : 2005:06:02 17:58:22+08:00
Document ID                     : uuid:db483ebf-eae8-41be-bc09-49e6f11f7930
Format                          : application/pdf
Title                           : 
Creator                         : Cathy
EXIF Metadata provided by EXIF.tools
FCC ID Filing: P8OGWT-6A-72

Navigation menu