Grandex BR500-01 The MeatProbe Bridge User Manual
Grandex International Corporation The MeatProbe Bridge
Grandex >
User manual
Any Questions or Problems?
Visit us at http://grandex.com.tw/support
The MeatProbe Ultimate BBQ Set
Quick Start Guide
Step 1 | Download
Download The MeatProbe app on iOS
or Android to your mobile device.
Visit theMeatProbe.com/app
Step 2 | Power
Use the included Micro USB cables to
power on the Bridge and Charger with a
USB charger or a USB battery pack for
portability. Place a MeatProbe into the
Charger to begin charging.
Step 3 | Setup
Open the app and follow the instructions
to setup an account and the MeatProbe
Bridge. Attach the included antenna to the
threaded antenna post on the Bridge.
Step 4 | WiFi
When prompted, enter your WiFi
credentials. The WiFi icon will appear
on the Bridge’s LCD screen when the
connection is successful. When turned
on, the Bridge will always connect to
the last connected WiFi.
Step 5 | The MeatProbe
It is recommended to charge each
MeatProbe for at least an hour before the
first use. If the Charger’s LED is flashing
orange, the MeatProbe has enough power
for most cooking situations.
Step 6 | Let’s cook!
With everything setup and ready to go,
add a recipe in the app and get cooking.
Enjoy your perfectly cooked meat!
Any Questions or Problems?
Visit us at http://grandex.com.tw/support
FAQ
What are the meanings of the audible/visual alerts?
Long beep – Cook is added/edited.
Three beeps repeated and internal temperature icon flashes – Early
warning temperature has been reached.
Constant beeps – Target temperature has been reached.
Two beeps repeated and ambient temperature icon flashes – Ambient
temperature is too low or too high.
Two short beeps repeated every five seconds and Bluetooth icon
flashes or is gone – Bridge has lost connection with the MeatProbe.
One short beep repeated every ten seconds and name of cook flashes
– The MeatProbe has low batteries.
How do I stop the audible alarm?
Clinking the next button will stop the alarm.
How do I turn off the LCD backlight?
Long press and release the button. This will toggle between an always
on backlight and a temporary 30 second backlight. Clicking the next
button will then turn on the backlight.
Can I toggle between ºF and ºC?
You can change to your preferred temperature scale in the app
settings and recreate the cook.
Do I need to setup the WiFi each time I use the Bridge?
The Bridge remembers the last connected WiFi. If it is unable to
connect on boot, it will rebroadcast its WiFi signal so that it can be
connected to another WiFi.
Any Questions or Problems?
Visit us at http://grandex.com.tw/support
FCC Statement
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
The distance between user and products should be no less than 20cm