Green Packet Berhad IF250-GP LiTE Band 7 Indoor CPE User Manual IF 250 131128

Green Packet Berhad, Taiwan LiTE Band 7 Indoor CPE IF 250 131128

Users Manual

www.greenpacket.com TAIWANDATASHEETIF-250VISIONINTOUCHTAIWANTAIWANINTELLIGENCEPORTABLEPORTABLECONNECTIONCONNECTIONCONNECTIONINFINITTECHNOLOGYINFINITINTERACTVISIONVISIONBESTSUCCESSFULWI-FIALWAYS BEST CONNECTEDGLOBALGLOBALCOLLECTIONINTERACTCOLLECTIONINTOUCHVISIONDEVICESvisionDEVICESInnovating To Improve LivesALWAYS BEST CONNECTEDINTELLIGENCEMANAGEMENTMANAGEMENTSHANGHAISINGAPORESAN FRANCISCOSAN FRANCISCOSHANGHAISINGAPORESINGAPOREKUALA LUMPURKUALA LUMPURINTOUCHBESTBANGKOKBANGKOKTAIWANSAN FRANCISCOKUALA LUMPURPORTABLEGLOBALLTE LiTE Indoor ModemIF-250, equipped with high-gain built-in omni-antenna, serves as an affordable residential wireless broadband solution for 4G carriers operating on FDD-LTE Band 7.Simply connect IF-250 to PC with the factory-shipped USB cable, and then you are ready to go! FDD-LTE Indoor Modem IF-250
Following Green Packet's wireless broadband solution design legacy, IF-250 is equipped with built-in omni- antennas with peak gain up to 8dBi, delivering more EIRP than other indoor units of the same category. IF-250WN-200FDD-LTEWi-Fi SMART PHONENBUSB Cable802.11n 1x1up to 150 Mbps5V DC Power5dBi dipole antennaLAN Port x 1enetsDATASHEETAuto Firmware Upgrade MechanismIn addition to TR-069, a common device management practice, IF-250 allows operators to complete firmware upgrade via HTTP or FTP file server. Once connected to the Internet, the mechanism inside CPE will automatically check with operators' remote file server and identify whether an upgradeis available. With proper setting enabled, this makes eNodeB off-balance possible, avoiding overwhelming upgrade request or traffic directed to one single eNodeB at the same time. www.greenpacket.comIn conform with 3GPP Rel. 9 and being FDD-LTE Cat-4 configurable, IF-250 is competent to communicate with any Cat-4 eNodeB. This helps to make the most of eNodeB resources and increase communication efficiency. As part of LTE LiTE portfolio, IF-250 features to provide FDD-LTE connectivity and deliver stable throughput in streamlined and affordable hardware design.Category-4 Proven ThroughputHigher antenna efficiency suggests more percentage of transmitter power can be radiated out by antenans.IF-250 has the antenna efficiency over 70%, assuring to make the best of its built-in high-performance antenna. High Performance Built-in Antenna On any CDC or RNDIS platform, IF-250 will get started to set up 4G connectivity and provide the Internet access once it is connected to the USB port. This takes no learning curve for subscribers getting familiar with how to use IF-250! Cat-4Category 4 configurable, which facilitates the service and communications between CAT-4 eNodeB and IF-250. High performance antenna, which helps to complement indoor service coverage.Powered on by USB. True plug and play, without driver installation. CAT-4DL UL DL ULCAT-3CPE configured as Cat.4 deviceCPE configured as Cat.3 device147Mbps 50Mbps 120Mbps 40Mbps100Mbps 50Mbps 90Mbps 40Mbps *Subject to optmized MCS config. and UL window size.Hosted (w/t WCM) Hostless (w/o WCM)IF-250 is designed to power on via USB and does not require driver installation on subscribers' side. Plug-and-PlayParticularly concocted for remote technical assistance, all the WAN, or FDD-LTE, packets may be redirected to LAN and saved to the local machine as log files for further interpretation. This does not involve techncial staff attending the filed and, thus, facilitates operators' troubleshooting process. Log Analysis via WAN Traffic MirroringUSBDesktopLaptopIF-250LaptopWorking with Green Packet WN-200* to enable broadband sharing is an economic approach to making the best of FDD-LTE connectivity. 4G Broadband Share via Wi-Fi Router*Not included in IF-250 package.302023002325 2350 2375 2400 2570 2595 2620 2690 (MHz)908070605040Antenna 1Antenna 2Antenna Gain Efficiency (%)7.2723002325 2350 2375 2400 2570 2595 2620 2690 (MHz)8.48.287.87.67.4Antenna 1Antenna 2Antenna Peak (dBm)*Subject to the OS version that supports RNDIS or CDC.
DATASHEETLTE• USB 2.0 x 1• Power & Data x 1 (Blue)• LTE signal x 3 (Green)• Local FW update via Web GUI• OTA via HTTP / FTP update• TR-069*USBLED IndicationDevice ManagementSIM Card• Windows OS / MAC OS / Ubuntu 13.04 / Fedora 19 / Chromebook / OTG-enabled Android Plug-and-play ; no driver installation requiredSupported OS• 3GPP Rel. 9StandardUser Interface• SIM Slot x 1 Support 1.8V / 3.3V USIM* Requires extra IOT effortPDN • Support Multiple PDNMax. RF Transmit Power • 23 dBm, 3GPP-compliantFrequency Range • FDD-LTE Band 7 Uplink : 2500 MHz ~ 2570 MHz Downlink : 2620 MHz ~ 2690 MHz• Comply with 3GPP TS 36.101» 5MHz: QPSK 1/3 = -100 QPSK 1/2 = -97 QPSK 3/4 = -94 16QAM 1/2 = -91 16QAM 3/4 = -86 64QAM 2/3 = -83 64QAM 3/4 = -80 64QAM 4/5 = -79» 10MHz: QPSK 1/3 = -97 QPSK 1/2 = -94 QPSK 3/4 = -91 16QAM 1/2 = -88 16QAM 3/4 = -83 64QAM 2/3 = -80 64QAM 3/4 = -77 64QAM 4/5 = -76» 15MHz: QPSK 1/3 = -95.2 QPSK 1/2 = -92.2 QPSK 3/4 = -89.2 16QAM 1/2 = -86.2 16QAM 3/4 = -81.2 64QAM 2/3 = -78.2 64QAM 3/4 = -75.2 64QAM 4/5 = -74.2» 20MHz: QPSK 1/3 = -94 16QPSK 1/2 = -91 QPSK 3/4 = -88 16QAM 1/2 = -85 16QAM 3/4 = -80 64QAM 2/3 = -77 64QAM 3/4 = -74 64QAM 4/5 = -73 Rx Sensitivity (dBm)• IPv4• IPv4-IPv6 dual stack• IPv6• NAT/NAPT• VPN Pass-throughInternet ProtocolNATDHCP • DHCP Client• DHCP Server• FTP ALG• H.232 ALG• PPTP ALG• SIP ALGNAT ALGOperation Mode• DHCP• Static• MTUIP Configuration MethodAntenna• Built-in FirewallFirewallPort Forwarding • Support• NAT Mode (Up to 5 devices)• Bridge Mode via IP Pass-throughNetworking• 165 x 166 x 43 (mm)Dimensions (H x W x D)• 250g (Device only)Weight• < 3.3 W (23dBm+)• < 5 mW (LTE idle mode)Power Consumption• 0C ~ 40C (Operating)• -20C ~ 70C (Storage)TemperatureElectrical & Mechanical• 10%~85% non-condensing (Operating)• 5%~95% non-condensing (Storage)Humidity• RoHS compliantMaterial• 400,000 hoursMTBF• IF-250 FDD-LTE indoor USB modem x 1• Box dimension: 184 x 182 x 60 (mm)• USB 2.0 cable (2m) x 1• Package weight: 300g • 1Tx / 2Rx Built-in Omni-antenna up to 8dBi at peak gain• RF EN301908-1 EN301908-13• Safety EN60950-1• EMC EN301489-1, -24 EN300386• SAR EN62311CE• FCC Part 27M• FCC Part 15B• FCC 2.1091 (RF Exposure)FCCRegulation Compliance* Note: While in operating, the SIM slot cover shall be firmly closed.IF series doesn't support SIM card hot swapping.23 +/- 1 dBm, 3GPP compliantFDD-LTE Indoor Modem IF-250
Copyright © 2001-2011 Green Packet Berhad. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language, in any form by any means, without the written permission of Green Packet Berhad. Green Packet Berhad reserves the right to modify or discontinue any product or piece of literature at anytime without prior notice.DATASHEETThis device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment. This equipment complies with radio frequency (RF) exposure limits adopted by the Federal Communica-tions Commission for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body. FCC RF Exposure ComplianceThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guaran-tee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. ****************************************************************************************************************************************************************************************************************************************************************************marketing.gp@greenpacket.com

Navigation menu