Guangzhou Chiyuan Electronic X-6H 6CH Radio Control User Manual X6H FHSS 2 4G Airfield

Guangzhou Chiyuan Electronic Co.,Ltd 6CH Radio Control X6H FHSS 2 4G Airfield

User Manual

Download: Guangzhou Chiyuan Electronic X-6H 6CH Radio Control User Manual X6H FHSS  2 4G                   Airfield
Mirror Download [FCC.gov]Guangzhou Chiyuan Electronic X-6H 6CH Radio Control User Manual X6H FHSS  2 4G                   Airfield
Document ID1655390
Application ID6eQQKG6nGVC5PIbFecSODQ==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize57.91kB (723870 bits)
Date Submitted2012-03-14 00:00:00
Date Available2012-03-14 00:00:00
Creation Date2012-01-10 16:02:21
Producing SoftwareAcrobat Distiller 7.0.5 (Windows)
Document Lastmod2012-01-10 16:02:21
Document TitleX6H(FHSS) 2.4G说明书(Airfield).cdr
Document CreatorPScript5.dll Version 5.2
Document Author: Administrator

2.4G FHSS Technology
6-Channel 2.4G Digital Proportional Radio System
INSTRUCTION MANUAL
Thank you for purchasing our R/C system.
Before using, read this manual carefully.
2.4G Binding
1. The Binding processing
Turn on the transmitter, then connect the power of receiver keeping the
receiver "BIND" button till the light turn on GREEN which means the
binding is successful. After that, it's unnecessary to bind again.
Caution: make sure the RX and TX is within one meter, and around 10
meters no similar device.
If the light flashing, showing the binding failure, please do again as
above indication.
THRO
Transmitter
(Mode 2)
RUDD
LEFT STICK
ELEV
AILE
Receiver channel distribution:
Ch1: Aileron
Ch2: Elevator
Ch3: Throttle
Ch4: Rudder
Ch5: Flap
Ch6: AUX
RIGHT STICK
Technology Data
Antenna
Handle
CH5
Connection Diagram
CH6
LED
Switch
Switch1
Aileron
Reverse Reverse
Left Stick
Switch2
Switch3 Switch4
Switch5
Switch6 MODE1
Pitch
Elevator Throttle R u d d e r Gyro
Reverse Reverse Reverse Reverse Reverse
MODE2
MODE1 Right hand
MODE2 Left hand
Right Stick
Power Switch
Transmitter
Channels : 6
Resolution : 4096
Frequency : 2.4GHz ISM Frequency range
Modulation : GFSK
Spread Spectrum Mode:FHSS
Number of frequency channels : 20
Hopping rate : 240 Jump / S
Output Power : < = 20dBm
Working current : < = 150mA
Working voltage: 1 . 2 V 4 N i C a d / N i M H
Dimensions: 200 m m X185 m m X105 m m
Net Weight: 507g
HV.PT
The Hovering Pitch function is to shift the center point of
curve either upward or downward to adjust at the hover
position
Reverse SW
Mode SW
Charging Jack
WARNINGS
The product is not intended for those under 14 years
of age without proper adult supervision. The product is
not a toy. It is a precision machine requiring proper
assembly and setup to avoid accidents and it is the
responsibility of the owner to operate this product in a
safe manner as it can cause serious personal injury and
damage to property due to carelessness or misuse.
After each use, always allow the battery to cool down
before recharging. When charging the battery pack, do
not overcharge! If batteries get hot during charging,
discontinue charging immediately and disconnect the
battery from the charger. Never leave battery unattended
while charging. If you are unsure of how to charge this
battery, please seek the advice of experienced RC
users. Never let children charge the battery without adult
supervision.
The spinning rotors on this product can be
dangerous! When operating/flying, always be aware of
the spinning rotors. Be careful not to let them come
Always turn on the transmitter before connecting the
close to your body, other people or loose clothing. Keep battery on the model. When turning off the model, always
your hands, fingers and any articles of clothing away
disconnect the battery first, and then turn off the
from the rotors.
transmitter. If the order is reversed, the model may
become uncontrollable and cause serious damage.
Do not attempt to disassemble or modify any of the
product components without the assistance of an
If you are in doubt of your ability to operate the model,
experienced RC user. ? Only use the correct type of
we strongly recommend that you seek assistance from
battery to operate. Using any wrong type of battery will experienced RC users or join your local model flying
damage the product and possibly make it dangerous to club to gain the required knowledge and skill. As the
operate.
manufacturer and distributor, we assume no liability for
the use of this product.
The motor(s) may get hot during use. Always allow
10-15 minutes between each flight for the motor to cool
Before turning on your model and transmitter, please
down. This will prolong the life of your product.
check to make sure no one else is operating under the
same frequency. Frequency interference can cause your
Choose an appropriate operating site consisting of
model, or other models to crash. The guidance provided
flat,smooth ground, and clear open field. Do not
by experienced RC users will be valuable for the
operate near buildings, high voltage cable lines, or
assembly, tuning, trimming, and actual first flight.
trees to ensure safety operation. Operate in safe area
only, away from other people. RC models are prone to
Never allow batteries to run low or you might lose
accidents, failures, and crashes due to a variety of
control of the model.
reasons including, lack of maintenance, pilot error, and
radio interference. Pilots are responsible for their
You should complete a successful pre-flight check of
actions and damage or injury occurring during the
your radio equipment and model prior to each flight.
operation.
Plastic is very susceptible to damage or deformation
Do not operate in inclement weather, such as rain,
due to extreme heat and cold climate. Do not store the
wind,snow and darkness.
model near any source of heat such as oven or heater.
Store the model indoors, in a climate-controlled, room
The product is composed of precision electrical
temperature environment.
components. It is critical to keep the product away from
moisture and other contaminants. Do not allow them to
get wet. Electrical damage may occur that could affect
safe operation.
Receiver
Channel:7
Frequency:2 . 4G ISM Frequency range
Spread Spectrum Mode : FHSS
Power:4.5-5.5V/<30mA
Net weight : 11.5g
Measurement:40 . 4*26 . 4*13mm
GY.SEN
Gyro sensitivity adjustable , two groups value can set .
Gyro Shift Switch
When adjust the " GY . SEN " , by this switch to shift the values
A/E/R D/R
D / R switch for Aileron , Elevator and Rudder , each has 70 % and
100 % two optional value .
FCC Radiation Exposure Statement
The antennas used for this transmitter must be installed to provide
a separation distance of at least 20 cm from all persons and must
not be collocated or operating in conjunction with other antenna
or transmitter.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
XY4000
Ch6
CH5
CH4
CH3
CH2
CH1
PITCH
GYRO
GYRO
ESC
ELEV
AILERON

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
XMP Toolkit                     : 3.1-701
Producer                        : Acrobat Distiller 7.0.5 (Windows)
Creator Tool                    : PScript5.dll Version 5.2
Modify Date                     : 2012:01:10 16:02:21+08:00
Create Date                     : 2012:01:10 16:02:21+08:00
Format                          : application/pdf
Title                           : X6H(FHSS) 2.4G说明书(Airfield).cdr
Creator                         : Administrator
Document ID                     : uuid:cd1b5cd4-be8a-41f3-9b98-998d8c8eef5c
Instance ID                     : uuid:1b335bc5-87ca-4eaa-840d-7c0bc7b1eab4
Page Count                      : 1
Author                          : Administrator
EXIF Metadata provided by EXIF.tools
FCC ID Filing: V6KX-6H

Navigation menu