Guoguang Electric 00007 Bluetooth Mono Speaker User Manual B00GUTY3DK 14 0543 MAN V3 indd

Guoguang Electric Co.,Ltd Bluetooth Mono Speaker B00GUTY3DK 14 0543 MAN V3 indd

User Manual

Download: Guoguang Electric 00007 Bluetooth Mono Speaker User Manual B00GUTY3DK 14 0543 MAN V3 indd
Mirror Download [FCC.gov]Guoguang Electric 00007 Bluetooth Mono Speaker User Manual B00GUTY3DK 14 0543 MAN V3 indd
Document ID2357909
Application IDGRvTS70oZD4G0DUNuy2qnA==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize118.6kB (1482546 bits)
Date Submitted2014-08-14 00:00:00
Date Available2014-08-14 00:00:00
Creation Date2017-10-21 13:55:23
Producing SoftwareGPL Ghostscript 9.18
Document Lastmod2017-10-21 13:55:23
Document TitleB00GUTY3DK_14-0543_MAN_V3.indd
Document CreatorAdobe InDesign CS6 (Windows)
Document Author: blighjud

Instruction Manual ∙ English
AmazonBasics Micro Ultra-Portable Bluetooth® Speaker
Contents
•
•
•
•
Mono Portable Bluetooth Speaker
Carrying pouch
USB charging cable
This instruction manual
Bluetooth 4.0 supported
Product overview
Top/Front
Function
/ Power
Volume
down
Volume up
Side
Charging
port
AUX jack
LED
Setup
Your speaker is partially charged when it arrives so you can
use it right away. For the best reception, keep your speaker
within 30 feet of the device it’s paired to.
Pairing your speaker with a device
1. Turn ON your speaker. A tone sounds, the LED blinks
and your speaker enters last device searching mode.
2. Press and hold the function
button for 1 to 3 seconds
to put your speaker in paring mode. A tone sounds
and the LED blinks quickly.
3. Turn ON your Bluetooth device (like a phone or tablet).
4. On your device, locate your Bluetooth settings and turn on
Bluetooth.
5. In Bluetooth Settings, scan for devices if necessary, then
select Amazon_BT4 from your device’s list. The LED
stops blinking and lights blue. Your device and speaker
are paired and your speaker is ready to use.
Note: Your speaker stays in pairing mode for 3 minutes or
until you pair a device. If you do not pair a device within
3 minutes, your speaker exits pairing mode and the LED
ashes slowly. To start pairing mode again, press the
function
button once.
Pairing another device or reconnecting to a paired device
1. Disconnect from the previous device by pressing and
holding the function
button for 1 to 3 seconds. A tone
sounds, the LED blinks quickly, and your speaker enters
pairing mode.
2. Repeat the pairing steps for your next device.
Note: You can pair multiple devices but you can only have one
device actively paired at a time.
Play music
• Start playing music on your paired device. Music plays
through your speaker.
• On your speaker, press + or — to increase or decrease
the volume.
Note: A tone sounds when the maximum volume setting
is reached.
Connect with an audio cable
1. Connect a 3.5 mm audio cable (not included) from your
speaker’s AUX jack to your audio device (like an MP3
player).
2. You should disconnect from Bluetooth while using Aux jack
to play music.
Press and hold the function
button 1~3 seconds to
disconnect Bluetooth.
Note: When connected to AUX, use the controls on the
device instead of your speaker.
Charge your speaker
When your speaker is turned on and the battery is low, your
ashes red. If not charged, your speaker turns
off.
To charge your speaker, connect the USB charging cable to
the port on your speaker and an available USB port on your
computer.
• If your speaker is ON, the LED flashes red & blue when
charging. When fully charged and connected to a
Bluetooth device, the LED lights blue.
• If your speaker is OFF, the LED lights red while charging
and turns off when fully charged.
Troubleshooting
My speaker won’t pair.
• Move your speaker and Bluetooth device closer together.
• If you do not pair a device within 3 minutes, your speaker
ashes slowly. Press the
function
button once to put your speaker into pairing
mode. A tone sounds and the LED blinks quickly.
• Press and hold the function
button to make sure that
your speaker is not connected to any other Bluetooth
device.
The sound is too quiet or loud.
• Adjust the volume on your device. It should be at about
50%.
• Adjust your speaker volume.
I hear static through my speaker.
• Move your speaker closer to your paired device. The
maximum distance is 30 feet.
• Turn down the volume.
10
My speaker buttons aren’t controlling my device.
• Some functions may be restricted depending on the
device paired to your speaker.
• If the device is connected to the AUX jack, you must use
the controls on the device.
• Make sure the device is within 30 feet of your speaker.
• Make sure your device supports Bluetooth 4.0.
Safety and Compliance
re or electric shock: Do not expose this appliance to rain or moisture.
A warning that batteries (battery pack or batteries installed) shall not be exposed to excessive heat
re or the light.
11
FCC Information
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
cations not expressly approved by the party responsible for compliance may cause
interference and void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.”
PRODUCT DISPOSAL INFORMATION
Dispose of this product in accordance with Local and National Disposal Regulations.
WEEE
Regulatory Information: Disposal of Waste Electrical and Electronic Equipment (WEEE)
The Waste Electrical and Electronic Equipment (WEEE) Directive aims to minimize the impact of electrical
and electronic goods on the environment, by increasing re-use and recycling and by reducing the amount of
es that this product must be disposed separately from ordinary household wastes at its end of life. Be aware that this is your responsibility to
dispose of electronic equipment at recycling centers in order to help conserve natural resources.
Each country should have its collection centers for electrical and electronic equipment recycling. For information about your recycling drop off area, please contact your related electrical and electronic equipment
ce, or your household waste disposal service.
liates. All Rights reserved. Amazon and the AmazonBasics
liates.
12
Made in China
V0 00-0000

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Encryption                      : Standard V4.4 (128-bit)
User Access                     : Print, Extract, Print high-res
Author                          : blighjud
Create Date                     : 2014:06:03 16:39:28-05:00
Modify Date                     : 2014:08:14 20:57:55+08:00
Has XFA                         : No
XMP Toolkit                     : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00
Creator Tool                    : Adobe InDesign CS6 (Windows)
Metadata Date                   : 2014:08:14 20:57:55+08:00
Thumbnail Width                 : 256
Thumbnail Height                : 256
Thumbnail Format                : JPEG
Thumbnail Image                 : (Binary data 11576 bytes, use -b option to extract)
Producer                        : Acrobat Distiller 10.1.8 (Windows)
Format                          : application/pdf
Title                           : B00GUTY3DK_14-0543_MAN_V3.indd
Creator                         : blighjud
Document ID                     : uuid:8fd561f7-7564-4f3e-b82b-056de7d3375e
Instance ID                     : uuid:840a4f9d-fe84-4cc9-9b0b-557ab13c64f9
Rendition Class                 : proof:pdf
N Pages                         : 1
Has Visible Transparency        : False
Has Visible Overprint           : True
Max Page Size W                 : 285.118164
Max Page Size H                 : 285.118164
Max Page Size Unit              : Pixels
Font Name                       : HelveticaNeueLTPro-Roman, HelveticaNeueLTStd-MdCn, HelveticaNeueLTStd-BlkEx
Font Family                     : Helvetica Neue LT Pro, Helvetica Neue LT Std, Helvetica Neue LT Std
Font Face                       : 55 Roman, 67 Medium Condensed, 93 Black Extended
Font Type                       : Open Type, Open Type, Open Type
Font Version                    : Version 1.300;PS 001.003;hotconv 1.0.38, OTF 1.029;PS 001.000;Core 1.0.33;makeotf.lib1.4.1585, OTF 1.029;PS 001.000;Core 1.0.33;makeotf.lib1.4.1585
Font Composite                  : False, False, False
Font File Name                  : HelveticaNeueLTPro-Roman.otf, HelveticaNeueLTStd-MdCn.otf, HelveticaNeueLTStd-BlkEx.otf
Plate Names                     : Cyan, Magenta, Yellow, Black
Swatch Groups Group Name        : 預設色票群組
Swatch Groups Group Type        : 0
Page Count                      : 12
EXIF Metadata provided by EXIF.tools
FCC ID Filing: 2AAP800007

Navigation menu