HAN Networks AP24X HAN Access Point User Manual statement

HAN Networks Co., Ltd. HAN Access Point statement

User Manual (statement)

HAN Access Point AP241 AP241e
Regulatory Compliance and Safety
Information
xxxxxx-xx Rev. A
*xxxxxx-XX Rev. A*
HAN Access Point
This series contains 2 models: AP241 and AP241e
Introduction
This document contains domestic and international regulatory
compliance information for the access point. To ensure that this
device complies with the regulatory standards for your region,
please refer to the content below.
For United States and Canada
FCC Statement: Improper installation of access points in
the United States configured to non-US model controllers
will be in violation of the FCC rules. Any such willful or
intentional violation may result in a requirement by the
FCC for immediate termination of operation and may be
subject to forfeiture (refer to 47 CFR 1.80).
EU Statement: Low power radio LAN product operating in
2.4 GHz and 5 GHz bands. Please refer to the User Guide
for details on restrictions.
For product available in the USA market, only channel
1~11 can be operated. Selection of other channels is not
possible. This device is restricted for indoor use.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Operations in the 5.15-5.25GHz band are restricted to indoor
usage only.
FCC Class B Part 15:
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including
interference that may cause undesired operation.
Any changes or modifications to this unit not expressly
approved by the party responsible for compliance could
void the user’s authority to operate this equipment.
This equipment has been tested and compliant with the limits for
a Class B digital device under part 15 of the FCC Rules. This
equipment generates, uses and can radiate radio frequency
energy. If it is not installed and used in accordance with HAN’s
instructions, it may cause harmful interference. If this equipment
does cause interference, which can be determined by turning the
equipment off and on, the user is encouraged to correct the
interference by one or more of the following ways:
Reorient or relocate the antenna.
Increase the separation between the equipment and other
devices.
Connect the equipment to an outlet on a circuit different
from that to which the other device is connected.
Consult the dealer or an experienced radio technician for
help.
California Proposition 65 Warning
WARNING: This product contains chemicals known to the State of
California to cause cancer and birth defects or other reproductive
harm.
For EU
HAN, hereby declares that these models are compliant with the
essential requirements and other provisions of Directive
2014/53/EU. For the complete CE DoC, please access the website
below to get more information:
service.esd.alcatel-lucent.com
Waste Electrical and Electronic Equipment (WEEE) Statement
HAN products are subject to separate
collection and treatment in the EU Member
States, Norway, and Switzerland when they are
at end of life, and therefore are marked with
the symbol shown. The treatment applied to
these products in these countries shall be
compliant with the applicable national laws
which are under the implementing of Directive 2012/19/EU on
Waste of Electrical and Electronic Equipment (WEEE).
European Union RoHS
HAN products are compliant with the EU Restriction of Hazardous
Substances Directive 2011/65/EU (RoHS). EU RoHS restricts the
use of specific hazardous materials in the manufacture of
electrical and electronic equipment. The restricted materials
under the Directive are Lead (including Solder used in printed
circuit assemblies), Cadmium, Mercury, equivalent Chromium, and
Bromine.
Global RF healthy information:
RF Radiation Exposure Statement: This equipment complies
with FCC and CE RF radiation exposure limits. This equipment
should be installed and operated with a minimum distance of
37 cm between the equipment and a human’s body for 2.4 GHz
and 5 GHz operations. This transmitter must not be co-located
or operating in conjunction with any other antenna or
transmitter.
For Model ap241, the frequency, mode, and the maximum
transmitted power in EU are listed below:
2412-2472MHz (802.11b 1 Mbps): 17.99dBm
2412-2472MHz (802.11g 6 Mbps): 19.09dBm
2412-2472MHz (802.11n HT20 MCS0): 19.10dBm
2412-2472MHz (802.11n VHT40 MCS0): 19.13dBm
5180-5240MHz (802.11a 6 Mbps): 22.21dBm
5260-5320MHz (802.11a 6 Mbps): 22.19dBm
5500-5700MHz (802.11a 6 Mbps):28.94dBm
5180-5240MHz (802.11n HT20 MCS0): 22.20dBm
5260-5320MHz (802.11n HT20 MCS0): 22.19dBm
5500-5700MHz (802.11n HT20 MCS0):29.21dBm
5180-5240MHz (802.11n VHT40 MCS0): 22.10dBm
5260-5320MHz (802.11n VHT40 MCS0): 22.13dBm
5500-5700MHz (802.11n VHT40 MCS0):29.13dBm
5180-5240MHz (802.11ac VHT80 MCS0): 22.17dBm
5260-5320MHz (802.11ac VHT80 MCS0): 22.18dBm
5500-5700MHz (802.11ac VHT80 MCS0):29.18dBm
For Model AP241e, the frequency, mode, and the maximum
transmitted power in EU are listed below:
2412-2472MHz (802.11b 1 Mbps): 17.97dBm
2412-2472MHz (802.11g 6 Mbps): 19.10dBm
2412-2472MHz (802.11n HT20 MCS0): 19.12dBm
2412-2472MHz (802.11n VHT40 MCS0): 19.14dBm
5180-5240MHz (802.11a 6 Mbps): 22.23dBm
5260-5320MHz (802.11a 6 Mbps): 22.20dBm
5500-5700MHz (802.11a 6 Mbps):29.22dBm
5180-5240MHz (802.11n HT20 MCS0): 22.21dBm
5260-5320MHz (802.11n HT20 MCS0): 22.19dBm
5500-5700MHz (802.11n HT20 MCS0):29.22dBm
5180-5240MHz (802.11n VHT40 MCS0): 22.12dBm
5260-5320MHz (802.11n VHT40 MCS0): 22.13dBm
5500-5700MHz (802.11n VHT40 MCS0):29.15dBm
5180-5240MHz (802.11ac VHT80 MCS0): 22.19dBm
5260-5320MHz (802.11ac VHT80 MCS0): 22.18dBm
5500-5700MHz (802.11ac VHT80 MCS0):29.20dBm
The device is restricted to indoor use only when operating in the
5150 to 5350 MHz frequency range.

Navigation menu