HAN Networks AP27X HAN Access Point User Manual Statement

HAN Networks Co., Ltd. HAN Access Point Statement

User Manual (Statement)

HAN Access Point
AP271
Regulatory Compliance and Safety
Information
enterprise.alcatel-lucent.com
Alcatel-Lucent and the Alcatel-Lucent Enterprise logo are trademarks of
Alcatel-Lucent. To view other trademarks used by affiliated companies of ALE
holding, visit: enterprise.alcatel-lucent.com/trademarks. All other
trademarks are the property of their respective owners. The information
presented is subject to ALE without notice. Neither ALE Holding nor any of its
affiliates assumes any responsibility for inaccuracies contained herein.
(2017)
Introduction
This document contains domestic and international regulatory
compliance information for the access point, the model is
OAW-AP1251. To ensure that this device complies with the
regulatory standards for your region, please refer to the content
below.
For United States and Canada
FCC Statement: Improper installation of access points in
the United States configured to non-US model controllers
will be in violation of the FCC rules. Any such willful or
intentional violation may result in a requirement by the
FCC for immediate termination of operation and may be
subject to forfeiture (refer to 47 CFR 1.80).
EU Statement: Low power radio LAN product operating in
2.4 GHz and 5 GHz bands. Please refer to the User Guide
for details on restrictions.
For product available in the USA market, only channel
1~11 can be operated. Selection of other channels is not
possible. This device is restricted for indoor use.
Dynamic Frequency Selection (DFS) for devices operating
in the bands 5470-5600 MHz and 5650-5725 MHz.
Users should also be advised that high-power radars are
allocated as primary users (i.e. priority users) of the
bands 5650-5725MHz and that these radars could cause
interference and/or damage to LE-LAN devices.
This product has been tested and found to comply with the limits
for a Class A digital device pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a
commercial environment. This product generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the manufacturer’s instruction manual, may
cause harmful interference with radio communications. Operation
of this product in a residential area is likely to cause harmful
interference, in which case you will be required to correct the
interference at your own expense.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including
interference that may cause undesired operation.
Any changes or modifications to this unit not expressly
approved by the party responsible for compliance could
void the user’s authority to operate this equipment.
California Proposition 65 Warning
WARNING: This product contains chemicals known to the State of
California to cause cancer and birth defects or other reproductive
harm.
For EU
ALE USA Inc., hereby declares that these models are compliant
with the essential requirements and other provisions of Directive
2014/53/EU. For the complete CE DoC, please access the website
below to get more information:
service.esd.alcatel-lucent.com
Waste Electrical and Electronic Equipment (WEEE) Statement
ALE products are subject to separate collection
and treatment in the EU Member States,
Norway, and Switzerland when they are at end
of life, and therefore are marked with the
symbol shown. The treatment applied to these
products in these countries shall be compliant
with the applicable national laws which are
under the implementing of Directive 2012/19/EU on Waste of
Electrical and Electronic Equipment (WEEE).
European Union RoHS
ALE products are compliant with the EU Restriction of Hazardous
Substances Directive 2011/65/EU (RoHS). EU RoHS restricts the
use of specific hazardous materials in the manufacture of
electrical and electronic equipment. The restricted materials
under the Directive are Lead (including Solder used in printed
circuit assemblies), Cadmium, Mercury, equivalent Chromium, and
Bromine.
Global RF healthy information:
RF Radiation Exposure Statement: This equipment complies
with FCC and CE RF radiation exposure limits. This equipment
should be installed and operated with a minimum distance of
31 cm between the equipment and a human’s body for 2.4 GHz
and 5 GHz operations. This transmitter must not be co-located
or operating in conjunction with any other antenna or
transmitter.
For Model OAW-AP1251, the frequency, mode, and the maximum
transmitted power in EU are listed below:
2412-2472MHz (802.11b 1 Mbps): 17.77dBm
2412-2472MHz (802.11g 6 Mbps): 19.60dBm
2412-2472MHz (802.11n HT20 MCS0): 19.58dBm
2412-2472MHz (802.11n VHT40 MCS0): 19.59dBm
5180-5700MHz (802.11a 6 Mbps): 29.54dBm
5180-5700MHz (802.11n HT20 MCS0): 29.49dBm
5190-5510MHz (802.11n VHT40 MCS0): 29.54dBm
5530-5610MHz (802.11ac VHT80 MCS0): 29.58dBm
[THIS SECTION INTENTIONALLY LEFT BLANK]

Navigation menu