HARRIS TR-413-A2 cellular/pcs portable terminal User Manual accessories and SAR performance
HARRIS CORPORATION cellular/pcs portable terminal accessories and SAR performance
HARRIS >
Contents
- 1. exhibit 8a
- 2. exhibit 8b
- 3. accessories and SAR performance
accessories and SAR performance
LZT 123 4598/9 R1
Important Information
THIS PHONE MODEL HAS BEEN CERTIFIED IN
COMPLIANCE WITH THE GOVERNMENT’S
REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.
Your wireless phone is a radio transmitter and receiver. It is designed
to not exceed the limits for exposure to radio frequency (RF) energy
set by the Federal Communications Commission (FCC) of the U.S.
Government. These limits establish permitted levels of RF energy
for the general population. The guidelines are based on standards
that were developed by international scientific organizations
through periodic and thorough evaluation of scientific studies. The
standards include a safety margin designed to assure the safety of all
persons, regardless of age and health.
The exposure standard for wireless mobile phones employs a unit of
measurement known as the Specific Absorption Rate, or SAR. The
SAR limit set by the FCC is 1.6W/kg.* Tests for SAR are conducted
using standard operating positions accepted by the FCC with the
phone transmitting at its highest certified power level in all tested
frequency bands. Although the SAR is determined at the highest
certified power level, the actual SAR level of the phone while
operating can be well below the maximum value. This is because the
phone is designed to operate at multiple power levels so as to use
only the power required to reach the network. In general, the closer
you are to a wireless base station antenna, the lower the power
output.
Before a phone model is available for sale to the public, it must be
tested and certified to the FCC that it does not exceed the limit
established by the government-adopted requirement for safe
exposure. The tests are performed in positions and locations (i.e., at
the ear and worn on the body) as required by the FCC for each
model. The highest SAR value as reported to the FCC for this model
phone when tested for use at the ear is 1.41 W/kg and when worn
on the body is 1.36 W/kg. Body worn measurements are made while
the phone is in use and worn on the body with an Ericsson
accessory. Accessories can significantly affect SAR compliance. The
Federal Communication Commission requires that some
manufacturers' accessories be tested, and Ericsson has done so with
respect to its products. Ericsson has not tested non-Ericsson
accessories in conjunction with Ericsson phones. It is therefore
recommended that only Ericsson accessories be used in conjunction
with Ericsson phones.
The FCC has granted an Equipment Authorization for this model
phone with all reported SAR levels evaluated as in compliance with
the FCC RF exposure guidelines. While there may be differences
between the SAR levels of various phones, all mobile phones granted
an FCC equipment authorization meet the government requirement
for safe exposure.
SAR information on this model phone is on file with the FCC and
can be found under the Display Grant section of http://
www.fcc.gov/oet/fccid after searching on FCC ID AXATR-413-A2.
Additional information on Specific Absorption Rates (SAR) can be
found on the Cellular Telecommunications & Internet Association
(CTIA) web-site at http://phonefacts.net/.
* In the United States and Canada, the SAR limit for mobile phones used by
the public is 1.6 watts/kilogram (W/kg) averaged over one gram of tissue. The
standard incorporates a margin of safety to give additional protection for the
public and to account for any variations in measurements.