HBC radiomatic TC693 UHF transceiver for data transfer User Manual UM TC693 V2

HBC-radiomatic GmbH UHF transceiver for data transfer UM TC693 V2

Installation Manual

User Manual Transceiver Module TC693 UM-TC693-V2.DOC / SEBB/DOKUS Page 1 / 5 HBC-radiomatic GmbH • 74564 Crailsheim • Germany Information and specifications subject to change without notice. 2011-05-10 www.hbc-radiomatic.com HBC – Transceiver Module TTCC 669933
User Manual Transceiver Module TC693 UM-TC693-V2.DOC / SEBB/DOKUS Page 2 / 5 HBC-radiomatic GmbH • 74564 Crailsheim • Germany Information and specifications subject to change without notice. 2011-05-10 www.hbc-radiomatic.com Manufactured by: HBC-radiomatic GmbH Haller Strasse 47 – 53 74564 Crailsheim, Germany Tel: +49 79 51 3 93–0 Fax: +49 79 51 3 93–50 E-mail: info@radiomatic.com http://www.hbc-radiomatic.com HBC-radiomatic GmbH is not liable for any misprints or errors! – All rights reserved. ™ HBC-radiomatic is a registered German trademark. © 2011 – 11 , HBC-radiomatic GmbH , 74564 Crailsheim , Germany No part of any software or of the present document may be reproduced in any manner whatsoever without the expressed written permission of HBC-radiomatic GmbH.
User Manual Transceiver Module TC693 UM-TC693-V2.DOC / SEBB/DOKUS Page 3 / 5 HBC-radiomatic GmbH • 74564 Crailsheim • Germany Information and specifications subject to change without notice. 2011-05-10 www.hbc-radiomatic.com Table of Contents Warnings ................................................................................................. 4 Installation………………………………………………………………………..5 Technical Data ........................................................................................ 5
User Manual Transceiver Module TC693 UM-TC693-V2.DOC / SEBB/DOKUS Page 4 / 5 HBC-radiomatic GmbH • 74564 Crailsheim • Germany Information and specifications subject to change without notice. 2011-05-10 www.hbc-radiomatic.com Warnings FCC Part 15.21 Statement NOTICE: Changes or modifications made to this equipment not expressly approved by (manufacturer name) may void the FCC authorization to operate this equipment. Part 15.105 Statement NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. IC RSS-GEN – User Manual Statements (English/French) Licence exempt This device complies with complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le onctionnement.
User Manual Transceiver Module TC693 UM-TC693-V2.DOC / SEBB/DOKUS Page 5 / 5 HBC-radiomatic GmbH • 74564 Crailsheim • Germany Information and specifications subject to change without notice. 2011-05-10 www.hbc-radiomatic.com Installation The module is installed by plugging it into the suitable interface (38 pins) on the receiver or transmitter board. An additional screw, which must be added, holds the module in his interface. Technical Data Common data (RX+TX): Frequency range: 902.000 ... 917.975 MHz Operating voltage: + 3.3 ... 4.6 V Channel pattern: 25 kHz LF transmission bandwidth: 150 Hz .... 4.8 kHz Modulation type: F2D Operating temperature range: -30 ... +70 °C Transmitter: Maximum field strength: 50 mV/m @ 3 m Frequency deviation: +/- 5 kHz Current consumption when transmitting: 100 mA Switch-over time (RX-TX): < 1 ms Receiver: Sensitivity: -108 dBm (20dB S/N) First IF: 45 MHz Second IF: 455 kHz Current consumption when receiving: 70 mA Switch-over time (TX-RX): < 1 ms LF output voltage: 120 mV RMS at +/-5 kHz deviation (internal test point only!) IP3: 0 dBm

Navigation menu