HCS RC377A Remote control User Manual

HCS (Suzhou) Limited Remote control

User Manual

Remote Control user manual Remote Control Remote control can be programmed to operate some features on TVs or audio/video equipment. The key features of the remote are: • The Remote works in IR, RF and Bluetooth interface. • The remote uses Bluetooth for two-way communication to the STB • Like RF mode, Bluetooth eliminates the need for the remote and the paired devices to be in line of sight to each other. • The Remote has a touchpad. Basic operations and functions can be made by sliding and pressing the touchpad. • If the remote is not paired to a STB, the touchpad can be used for functions like Up, Down, Left, Right and Select. • Once the remote is paired to a STB, it can send absolute touch data to the STB Voice recognition is available with the VRC81 Remote. Voice search will only work when the remote is paired to the STB. Activating RF To pair the remote control to the STB, perform the following steps: 1. Press and HOLD MUTE and VOL+ at the same time until the blue light blinks after this. 2. STB enters searching mode and choose the remote control. 3. Pair with STB. Deactivating RF To deactivate the RF Transmitter on the remote control, perform the following steps: The RCU pairing can be cleared pressing and holding <<FFWD+REW>> keys simultaneously for 3 seconds. The RCU should also send the un-pairing message to STB so that the STB can remove the pairing entry
RESTORING FACTORY DEFAULT SETTINGS To reset all the functions of the remote control to the factory default settings following these steps: 1. Press and hold MUTE and SELECT at the same time until the green light flashes twice. 2. Using the number keys enter 981 Federal Communications Commission Interference Statement: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. Responsible Party: ATT/DIRECTV 2230 E. Imperial Hwy El Segundo, CA 90245 1-800-DIRECTV

Navigation menu