HID Global 4043 Handheld Tag Reader User Manual Manual

HID Global Corporation Handheld Tag Reader Manual

Contents

Manual

Download: HID Global 4043 Handheld Tag Reader User Manual Manual
Mirror Download [FCC.gov]HID Global 4043 Handheld Tag Reader User Manual Manual
Document ID91785
Application IDiprfsFlrqDd1hoD1ULLcFg==
Document DescriptionManual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatMicrosoft Word - pdf
Filesize8.85kB (110593 bits)
Date Submitted2000-03-16 00:00:00
Date Available2000-04-28 00:00:00
Creation Date2000-03-16 17:48:23
Producing SoftwareAcrobat Distiller 4.0 for Windows
Document Lastmod2000-03-16 17:48:25
Document TitleManual

4043A AMH100 HandHeld Reader User Manual
PROXTRAK™
4043A AMH100 HandHeld Reader
User Manual
4043A AMH100 HandHeld Reader User Manual
October 16, 1998
HID Corporation 9292 Jeronimo Road Irvine, CA 92618 USA TEL (949)598-1600 (800)237-7769 FAX (949)598-1690
Web page, E- mail – www.prox.com 4043A AMH100 HandHeld Reader User Manual
1 of 4
4043A AMH100 HandHeld Reader User Manual
Overview
This document describes how to install and operate the HID ProxTrak (Also known as 4043A
AMH100 HandHeld Reader) HandHeld Reader. The HID HandHeld Reader is a unit designed to
work in conjunction with the Symbol PDT 6100 HandHeld Computer. Together, the system is
capable of reading from and writing to an IBM PC with the AssetID™ Radio Frequency (RF)
interface. The HandHeld Reader unit is connected to the Symbol 6100 unit via a coiled cable
with an RJ-45 style connector. When connected, the HID HandHeld Reader and HandHeld
Computer (PDT 6100) communicate through an RS-232 protocol. The HID HandHeld Reader
receives power as well as commands from the HandHeld Computer. When the HandHeld
Reader receives a command from the HandHeld Computer, it executes the command and sends
back the appropriate response to the HandHeld Computer.
Hardware Setup
1. Connect the RJ45 connector at the end of the HandHeld Reader into the Symbol PDT6100
HandHeld computer.
2. Turn on the HandHeld Computer by pressing the round button near the lower right hand
corner of the display.
Operating the HandHeld Reader
1. Select the desired command/process from the menu of the Symbol HandHeld Computer.
2. When a command is entered, the LED on the HandHeld Reader flashes red and continues to
flash red approximately every 3 seconds while no tag is in the field.
3. When the HandHeld Reader is placed within range of a tag, the HandHeld Reader LED
continues flashing red at an increased rate indicating that the HandHeld Reader unit is
working.
4. The HandHeld Reader flashes green for approximately 250ms after a successful execution of
a command or until a subsequent command is received.
5. If there is no tag detected, the HandHeld Reader sends back a “no tag” message to the
HandHeld Computer.
6. If the command sent to the tag fails, a failure message will be sent to the HandHeld
Computer.
Tag Orientation
It is important to orient the HandHeld Reader correctly for a successful read/write of the tag.
HandHeld Reader Orientation – PC in a box
1. Locate the target symbol on the outside of each box. See figure 1.
2. Hold the HandHeld Reader parallel to the tag located behind the Asset ID target symbol on
the box. Refer to the orientation diagram seen in figure 2 for correct positioning.
3. The HandHeld Reader should be held vertically for a desktop computer box and horizontally
for a tower computer box. Note that for the desktop, the HandHeld Reader is actually
oriented 90°° from the words Asset ID™ on the target label.
Figure 1
TM
Asset ID
HID Corporation 9292 Jeronimo Road Irvine, CA 92618 USA TEL (949)598-1600 (800)237-7769 FAX (949)598-1690
Web page, E- mail – www.prox.com 4043A AMH100 HandHeld Reader User Manual
2 of 4
4043A AMH100 HandHeld Reader User Manual
4. Move the HandHeld Reader toward the box until it is within a range of 0” to 2” .
Figure 2
0" - 2.0"
Approximate
Read Range
0" - 2.0"
Approximate
Read Range
TM
Asset ID
Asset ID
PC Orientation
in box
Tower Orientation
in box
Figure 2: Target is shown only as a guide and is not on PC. Target position reflects approximate
position of tag in PC.
Orientation – PC out of a box
1. Hold the HandHeld Reader according to the orientation illustrated in the figure 3, below.
Figure 3
Approximate Tag location
0.5 - 6.0" Approximate
Read Range
PC Orientation
0.5 - 6.0" Approximate
Read Range
Approximate Tag location
Tower Orientation
HID Corporation 9292 Jeronimo Road Irvine, CA 92618 USA TEL (949)598-1600 (800)237-7769 FAX (949)598-1690
Web page, E- mail – www.prox.com 4043A AMH100 HandHeld Reader User Manual
3 of 4
4043A AMH100 HandHeld Reader User Manual
Troubleshooting the HandHeld Reader
The LED on the HandHeld Reader is not lit.
1. Check to make sure the RJ45 connector is securely seated into the connection location on
the Symbol HandHeld Computer.
2. Make sure the HandHeld Computer is turned on. Make sure the red LED is blinking. If the
HandHeld Reader connection is secure and the LED is not blinking, contact Technical
Support.
When I present a tag, the LED flashes red at about once per 3 seconds
1. Be sure the HandHeld Reader is oriented in the correct position to read the tag, refer to figure
2.
2. Confirm that the HandHeld Reader is with ½” to 6” (0”-2” if PC in box) from the tag for best
read/write performance.
3. Be sure that a command/process was selected from the menu on the HandHeld Computer.
4. Be sure the system being read has the AssetID™ subsystem installed.
When I present a tag, the LED flashes at rate greater than once per 3 seconds but does not
flash green
1. Be sure the HandHeld Reader is oriented in the correct position.
2. Be sure the AssetID subsystem of the system being read/written is operating normally.
Notes:
AssetID™ is a trademark of IBM Corporation
ProxTrak™ is a trademark of HID Corporation
HID Corporation 9292 Jeronimo Road Irvine, CA 92618 USA TEL (949)598-1600 (800)237-7769 FAX (949)598-1690
Web page, E- mail – www.prox.com 4043A AMH100 HandHeld Reader User Manual
4 of 4

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : Yes
Create Date                     : 2000:03:16 17:48:23
Producer                        : Acrobat Distiller 4.0 for Windows
Modify Date                     : 2000:03:16 17:48:25-05:00
Page Count                      : 4
EXIF Metadata provided by EXIF.tools
FCC ID Filing: JQ64043

Navigation menu