HID Global 615Y iClass Long Range Reader User Manual R90 Install Manual indd

HID Global Corporation iClass Long Range Reader R90 Install Manual indd

Contents

Users Manual 1

installation  ®iCLASS® by2assembly and disassembly1preparing3testingOpen CollectorHoldBeeperRed LEDGreen LEDGround Shield+DC  (12 – 24 VDC)Data 1Data 0GroundNot UsedNot UsedNot UsedNot Used Not UsedNot Used  Wiring diagram Mounting HolesR90 Install Manual.indd   1 9/19/05   2:31:48 PM
parts• 1 - reader• 1 - Installation Manual• 4 - #8 Philips self taping screws• 4 - #8 Spanner security screwsOPTIONAL FEATURES5• Open Collector Output - controls an external device operating in  Host Mode only. See iCLASS Application Note for details.• Configuration Options - Configure LED, Speaker, and other  features. See How To Order Guide or iCLASS Application Note   for details.• Hold Input - when asserted, this line either buffers a card or disables   a card read until released, as configured.PARTS6installation HID Corporation  9292 Jeronimo RoadIrvine, California 92618-1905 USAtel: +1 (949) 598-1600U.S. (800) 237-7769fax: +1 (949) 598-1690email:tech@hidcorp.comwww.hidcorp.com6090-900 Rev. A.3R90 • Long Range Reader4 An on board tamper switch is wired through the “I’m Alive” feature and if active, the standard supervisory signal will stop if the cover is removed.  This device complies with part 15 of the FCC rules.  Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.This Proximity Reader is intended to be powered from a limited power source output of a previously certied power supply.  For regulatory compliance, the drain wire is to be disconnected at the power supply end of the I/O cable.TAMPER SWITCHR90 Install Manual.indd   2 9/19/05   2:31:51 PM

Navigation menu