HUSQVARNA FMS2 Fleet Machine Sensor User Manual 2

Download:
Mirror Download [FCC.gov]
Document ID	3755136
Application ID	XBxSek4NNDj6nXX4AcgqzA==
Document Description	Users Manual 2
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	57.78kB (722281 bits)
Date Submitted	2018-02-16 00:00:00
Date Available	2018-02-16 00:00:00
Creation Date	2018-01-10 08:21:06
Producing Software	Adobe PDF Library 10.0.1
Document Lastmod	2018-01-10 08:21:10
Document Title	Users Manual 2
Document Creator	Adobe InDesign CS6 (Macintosh)

Husqvarna Fleet Services
Machine Sensor
Machine Sensor
Please read these instructions carefully before using the device.
Original instructions
Safety and Regulatory Information
IMPORTANT: A complete User Manual is is built
into the Fleet services different applications as digital
content or pdf document.
To ensure that the device is used safely, follow all safety and
operating instructions in this manual. If the device is not used as
described in this manual, the safety features might be impaired.
!!Warning: Non compliance with the warnings and/or the
instructions for use may damage the device and/or its
components or injure the operator.
Take extreme care under the following conditions when using the
device:
• For your own safety and that of the device, you must follow the
procedure described in this instruction manual.
• Do not use this device in a location where there is explosive gas
in the vicinity. The use of this device in a location where there is
explosive gas could result in explosion.
• Take care not to allow water to get into the device. The use of
the device in a wet state could result in electrical shock or fire.
• Do not remove either the cover or panel.
• Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
Symbols
Please read the user manual carefully and make sure you
understand the instructions before using the device.
This device is in accordance with applicable EC
directives.
Environmental marking. Symbols on the device or its
packaging indicate that this device cannot be handled
as domestic waste. It must instead be submitted to
an appropriate recycling station for the recovery of
electrical and electronic equipment.
English - 2
NOTICE:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Notes, Cautions and Warnings
A NOTE provides important information about your
Husqvarna Fleet Service (HFS) system.!
A CAUTION indicates either potential damage to hardware
or loss of data and tells you how to avoid the problem.
!!WARNING indicates a potential risk for property damage,
personal injury or death.
Note: This document provides important information about your
Husqvarna Fleet Service (HFS) system!
!!WARNING: Use of tools, adjustments, procedures,
connections or battery type other than those specified
in this documentation may result in exposure to shock,
electrical hazard, and/or mechanical hazard.
• Husqvarna Fleet Services devices are not designed for use in
hazardous environments.
!!CAUTION: Only operate your machine sensor with cover
removed when replacing battery and/or verifying LED
indications.
• Do not use damaged equipment.
English - 3
When working inside your device
!!WARNING:
!!Do not attempt to service the equipment yourself, exept as
explained in the documentation or in instructions otherwise
provided to you by Husqvarna dealer. Always follow
installation and service instructions closely.
!!Internal components may become very warm during normal
operation. Before touching any internal components, allow
time for them to cool.
Battery Safety
!!WARNING:
!!Using an incompatible battery may increase the risk of fire
or explosion. Replace the battery only with compatible
battery type VARTA CR2450.
!!A damaged battery may pose a risk of personal injury.
Damage may include impact or shock that dents or
punctures the battery, exposure to a flame, or other
deformation. Do not disassemble the battery.
!!Do not expose (store or place) any Husqvarna Fleet
Services device to a heat source such as a radiator, fireplace,
stove, electric heater, or other heat-generating appliance
or otherwise expose it to temperatures in excess of 65ºC
(149ºF). When heated to excessive temperatures, battery
cells could vent or explode, posing risk of fire.
!!Do not ingest battery, chemical burn hazard. This device
contains a coin cell battery. If the battery is swallowed, it
can cause severe internal burns or death. Keep new and used
batteries away from children. If the battery compartment
does not close securely, stop using the device and keep
it away from children. If you think batteries might have
been swallowed or placed inside any part of the body, seek
immediate medical attention.
English - 4
Waste Electrical and Electronic Equipment (WEEE)
Directive
In the European Union, this label indicates that this
device should not be disposed of with household waste.
It should instead be left at a suitable recycling center
to recycle its electronic components and batteries.
By ensuring this device is disposed of correctly,
you will help prevent potential negative consequences for the
environment and human health, which could otherwise be caused
by inappropriate waste handling of this device. For more detailed
informaton about recycling of this device, please contact your local
council office, your household waste disposal service or the shop
where you purchased the device.
English - 5
Technical Specifications
Modulation
MSK
Nominal Input [V]
3.0
Max Input [V]
3.4
Min Input [V]
2.6
Internal Operational Max Temperature [°C]
55
Internal Operational Min Temperature [°C]
-10
Absolute Max Temperature [°C]
60
Absolute Min Temperature [°C]
-20
Nominal RF Range [m]
20 (To BS)
Receiver type
Category 2
Transmitter type
Category 2
Nominal RF Output Power [dBm]
Frequence Range [GHz]
2.4000 – 2.4835
Max Current Consumption [mA]
24
Battery
VARTA CR2450 x 1
Functionality
Petrol: Pulse Engine Tachometer
(500-15K rpm) nominal sensitivity
of 10 cm in line of sight from
source
Electric: Engine-On Chronometer
nominal sensitivity of 10 cm in
line of sight from source*
*See recommended position from on-line
manual.
Off-line data storage of 100
working hours
Nearby Operator Tag detection
Nominal 120 kB of data per
working hour
Sensors
rpm Tachometer
Internal Temperature (±4°C)
Battery Status
English - 6

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : Yes
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.3-c011 66.145661, 2012/02/06-14:56:27
Create Date                     : 2018:01:10 08:21:06+01:00
Metadata Date                   : 2018:01:10 08:21:10+01:00
Modify Date                     : 2018:01:10 08:21:10+01:00
Creator Tool                    : Adobe InDesign CS6 (Macintosh)
Instance ID                     : uuid:7e7c180d-2db0-f941-9add-9ef02cfe39bb
Original Document ID            : xmp.did:F77F11740720681197A59CFDE72C1854
Document ID                     : xmp.id:9BE45A53082068118083BE2022603437
Rendition Class                 : proof:pdf
Derived From Instance ID        : xmp.iid:9AE45A53082068118083BE2022603437
Derived From Document ID        : xmp.did:B3F64A7407206811822AC788369E9D37
Derived From Original Document ID: xmp.did:F77F11740720681197A59CFDE72C1854
Derived From Rendition Class    : default
History Action                  : converted
History Parameters              : from application/x-indesign to application/pdf
History Software Agent          : Adobe InDesign CS6 (Macintosh)
History Changed                 : /
History When                    : 2018:01:10 08:21:07+01:00
Format                          : application/pdf
Producer                        : Adobe PDF Library 10.0.1
Trapped                         : False
Page Count                      : 6
Creator                         : Adobe InDesign CS6 (Macintosh)

EXIF Metadata provided by EXIF.tools