HYUNDAI MOBIS SMK-4N03 SMART KEY ECU User Manual

HYUNDAI MOBIS CO., LTD. SMART KEY ECU

User Manual

The SMART KEY ECU is a part of START-STOP BUTTON SYSTEM.It is possible to output the LF(125kHz) signal by pushing the button of door handle and SSB.1. GENERAL DISCRIPTIONIf the button of door handle or SSB button is pressed, SMART KEY ECU outputOutline of SMART KEY ECUIf the button of door handle or SSB button is pressed, SMART KEY ECU outputthe LF(125kHz) signal.1) LF signal output for engine startSSB button is pressed, SMART KEY ECU output LF signal through the interior LF antenna2) LF signal output for door lock/unlock and trunk releaseThe button of door handle or trunk is pressed, SMART KEY ECU output LF signal thtough theLF antenna for Fob searchingfor Fob searching.
FCC WarningThis equipment has been tested and found to comply with the limits for a Class A digital device, pursuant topart 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates, uses and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, may cause harmful interference toradio communications. However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio or television reception, which can bedetermined by turning the equipment off and on, the user is encouraged to try to correct the interference byone or more of the following measures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected.Consult the dealer or an experienced radio/TV technician for help.Caution: Any changes or modifications to this device not explicitly approved by manufacturer could voidyour authority to operate this equipment.This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received,including interference that may cause undesired operation. This equipment complies with FCC radiationexposure limits set forth for an uncontrolled environment. This equipment should be installed and operatedwith minimum 20 cm between the radiator and your body. This transmitter must not be collocated oroperating in conjunction with any other antenna or transmitter unless authorized to do so by the FCC.IC WarningOperation is subject to the following conditions: (1) this device may not cause interference, and (2) thisdevice must accept any interference, including interference that may cause undesired operation of the device.Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts delicence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas provoquer debrouillage, et (2) l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage estsusceptible d'en compromettre le fonctionnement.

Navigation menu